Bagger Adapter Kit
Part No. 5600055
Installation
Instructions
Kit Contents:
Fits 2006 Simplicity Champion Series
Fits 2006 Snapper and Massey Ferguson Consumer Z Series
Part No.
5048264
5401581A
Qty. Description
E
D
A
2
2
Spacer, .39 X .63 X 1.50
Mount, Bagger, Tube Bracket
3/8-16 x 2-1/2” Bolt
C
5025013X20 2
B
5025013X8
5025394
2
4
3/8-16 x 1” Bolt
3/8-16 Nylock Flange Nut
WARNING
Before beginning any service work turn off the
PTO, set the parking brake, turn off the ignition,
and disconnect the spark plug wire(s).
C
F
2 Bag Mount
1. Park machine on a flat, level surface and engage the
parking brake. Disengage the PTO switch, turn off
the engine and remove the key from the ignition.
D
E
C
A
2. If the engine is hot, allow sufficient time for the
muffler to cool to prevent a burn injury during
installation.
B
3. Install the 3/8-16 x 2-1/2” bolts (B) through the mount
plate (A) and install spacers (C).
4. Install the mount plate onto the bumper with the bolts
above the top bumper tube.
C
5. Install the mount brackets (E) loosely secure with the
3/8-16 nylock flange nuts (D).
F
3 Bag Mount
6. Install the 3/8-16 x 1” bolts (F) through mount plate
and mount brackets loosely secure with the 3/8-16
nylock flange nuts (D).
Figure 1. Install Adapter Kit
A. Mount Plate
B. 3/8-16 x 2-1/2” Bolts (2X)
C. Spacers (2X)
D. 3/8-16 Nylock Flange Nut (4X)
E. Tube Brackets (2X)
F. 3/8-16 x 1” Bolts (2X)
7. For 2-Bag: Position the right hand side mount plate
approximately 2” (5,1cm) from the right hand end of
the bumper tubes and tighten the hardware securely.
For 3-Bag: Center the mount plate side-to-side on
the bumper and tighten the hardware securely.
5100530
Rev. 1/2006
TP 200-7281-00-SK-SMN
© Copyright 2006 Ferris Industries. All Rights Reserved.
1
Download from Www.Somanuals.com. All Manuals Search And Download.
|