HME 110
Headset
Instruction manual
Download from Www.Somanuals.com. All Manuals Search And Download.
Important safety information
attention. During flight operation, do not use the headset
for making phone calls or listening to music.
̈ The product is capable of producing sound pressure
exceeding 85 dB(A). In many countries 85 dB(A) is the
maximum legally permissible level for continuous noise
exposure during the working day. Do not listen at high
volume levels for long periods of time to prevent hearing
damage.
Preventing damage to the product and dysfunctions
̈ Always keep the product dry and do not expose it to
extreme temperatures (hairdryer, heater, extended
exposure to sunlight, etc.) to avoid corrosion or
deformation.
̈ Only clean the product with a soft, dry cloth.
̈ Never repair or attempt to repair a defective product
yourself. Contact your Sennheiser partner or the
Sennheiser Service Department.
̈ Only replace parts of the product whose replacement is
described in this instruction manual. All other parts of the
product must be replaced by your Sennheiser partner.
2 | HME 110
Download from Www.Somanuals.com. All Manuals Search And Download.
Important safety information
Intended use of the headset
Intended use of the product includes
especially the chapter “Important safety information” on
page 1,
• using the headset in helicopters, propeller and turboprop
aircraft and within the operating conditions as described
in this instruction manual.
“Improper use” means using the product other than as
described in this instruction manual, or under operating
conditions which differ from those described herein.
HME 110 | 3
Download from Www.Somanuals.com. All Manuals Search And Download.
HME 110 headset
HME 110 headset
The HME 110 pilot headset is characterized by the following
features:
• Passive headset with excellent noise attenuation
• Excellent comfort due to very low weight, soft ear pads
and padded headband
• Foldable headband for easy and space-saving transport
• Clear communications due to BKE 45-1 condenser
microphone with adjustable sensitivity
• Microphone can be easily positioned and worn on either
left or right side due to flexible microphone boom with
quick-fixing device
• Best possible freedom of movement due to unilateral
connection cable
• Optimum radio reception due to headphone system with a
wide frequency response
• Integrated volume control
• Adaption to the aircraft audio system via mono/stereo
switch
• Made in Germany, 10-year warranty
4 | HME 110
Download from Www.Somanuals.com. All Manuals Search And Download.
Delivery includes
Delivery includes
1 HME 110 headset
1 wind screen for microphone
1 cable clip
1 instruction manual
HME 110 | 5
Download from Www.Somanuals.com. All Manuals Search And Download.
Putting the HME 110 in operation
Putting the HME 110 in
operation
Connecting the headset
̈ Connect the two jack plugs of the
headset to the corresponding jack
1
sockets of your audio system.
2
Jack plug
Jack socket of the audio system
5.25 mm jack plug 1
Microphone input
(PJ-068 equivalent)
¼” (6.35 mm) jack plug 2 Headphone output
Adjusting the headband
For good noise attenuation and best possible comfort, the
headset has to be adjusted to properly fit your head. To do
so, you can adjust the headband.
CAUTION!
Damage to the product due to squeezing of cables!
When adjusting the headband, the connection cable for the
headphones can be squeezed and damaged.
̈ Make sure not to squeeze the headphones connection
cable when adjusting the headband.
D6o|wHnMloaEd1f1ro0m Www.Somanuals.com. All Manuals Search And Download.
Putting the HME 110 in operation
̈ Wear the headset so that the headband runs over the top
of your head.
̈ Adjust the length of the headband so that
– your ears are completely inside the ear pads,
– you feel even, gentle pressure around your ears,
– a snug fit of the headband on the head is ensured.
̈ Final adjustment is best made in a noisy environment.
HME 110 | 7
Download from Www.Somanuals.com. All Manuals Search And Download.
Putting the HME 110 in operation
Positioning the microphone
To position the microphone boom on either the right or left-
hand side of the mouth:
̈ Loosen the quick-fixing device.
̈ Rotate the microphone boom by 180°.
̈ Tighten the quick-fixing device.
Positioning the microphone towards the corner of the
mouth
̈ Bend the flexible microphone boom so that the micro-
phone is placed at the corner of the mouth. Maintain a
distance of approx. 2 cm between microphone and mouth.
8 | HME 110
Download from Www.Somanuals.com. All Manuals Search And Download.
Using the HME 110
Using the HME 110
Switching between mono and stereo
operation
In general, you’ll receive a mono sound source so that the
mono/stereo switch can remain set to “MONO” (factory
setting).
̈ Remove the ear pad (see “Replacing the ear pads” on
page 14) from the ear cup with the microphone boom
attached.
̈ Set the mono/stereo switch to “STEREO”.
HME 110 | 9
Download from Www.Somanuals.com. All Manuals Search And Download.
Using the HME 110
Adjusting the volume
WARNING!
Hearing damage due to high volume levels!
Listening at high volume levels for long periods
can lead to permanent hearing defects.
̈ Before putting the headset on, set the
volume to a low level.
̈ Do not continuously expose yourself to high
volumes.
̈ Adjust the volume to a medium level. Make sure that you
can hear critical sounds such as warning alarms.
–
+
10 | HME 110
Download from Www.Somanuals.com. All Manuals Search And Download.
Using the HME 110
Adjusting the microphone gain “Mic Gain”
According to JTSO approval C58a, the microphone output
voltage is factory preset to 400 mV. If the microphone output
voltage is too high or too low for your audio system, it can be
readjusted on the microphone.
̈ Use a small slotted screwdriver and turn the “Mic Gain
Adjustment” screw (see diagram) until you have reached
the desired setting.
+
Mic Gain Adjustment
–
BKE 45–1
P/N 045–305–097
TSO - C58a
MADE IN GERMANY
HME 110 | 11
Download from Www.Somanuals.com. All Manuals Search And Download.
Using the HME 110
Transporting the headset
For space-saving transportation, you can fold the headset:
̈ Tuck the ear cups between the headband.
To unfold the headset:
̈ Grasp both ear cups and pull them up and away from the
headband.
12 | HME 110
Download from Www.Somanuals.com. All Manuals Search And Download.
Cleaning and maintaining the HME 110
Cleaning and maintaining the
HME 110
Cleaning the headset
CAUTION!
Liquids can damage the electronics of the product!
Liquids entering the housing of the product can cause a
short-circuit and damage the electronics.
̈ Keep all liquids far away from the product.
̈ Do not use any solvents or cleansing agents.
̈ Use a soft, dry cloth to clean the product from time to
time.
Replacing the wind screen
If the wind screen for the microphone shows signs of wear
such as tears or holes, replace the wind screen. The new wind
screen must totally enclose the microphone.
HME 110 | 13
Download from Www.Somanuals.com. All Manuals Search And Download.
Cleaning and maintaining the HME 110
Replacing the ear pads
If the ear pads are damaged or worn out, replace them as
follows:
̈ Grasp the edge of the old ear pads and peel them up and
away from the ear cups.
̈ Press the new ear pads onto the ear cups.
14 | HME 110
Download from Www.Somanuals.com. All Manuals Search And Download.
Accessories and spare parts
Accessories and spare parts
The following accessories and spare parts are available from
your Sennheiser partner. To find a Sennheiser partner in your
• Wind screen for BKE 45-1 condenser microphone
• HZC 08 cable clip
• Carry and storage bag
• GOP gel ear pads
• LUXURY ear pads
HME 110 | 15
Download from Www.Somanuals.com. All Manuals Search And Download.
If a problem occurs ...
If a problem occurs ...
Problem
Possible cause
Solution
Communication
audio system but the
switch to “STEREO”
s in one ear only
headset is set to mono (see page 9).
operation.
You are receiving a
mono source but the
Set the mono/stereo
switch to “MONO”
headset is set to stereo (see page 9).
operation.
Very low
volume
The volume is set too
low.
Adjust the volume
setting of your
communication
headset
(see page 10).
The headphone
connection has been
pulled out.
Check to see if the
headphone jack plug
is correctly connected.
Reduced
intelligibility
The microphone
connection has been
pulled out.
Check to see if the
microphone jack plug
is correctly connected.
Microphone
The microphone gain
Adjust the
output voltage “Mic Gain” needs to be microphone gain
too high or too readjusted.
low
“Mic Gain” until you
have reached the
desired setting
(see page 11).
16 | HME 110
Download from Www.Somanuals.com. All Manuals Search And Download.
If a problem occurs ...
If a problem occurs that is not listed in the above table or if
the problem cannot be solved with the proposed solutions,
please contact your local Sennheiser partner for assistance.
To find a Sennheiser partner in your country, search at
HME 110 | 17
Download from Www.Somanuals.com. All Manuals Search And Download.
Specifications
Specifications
Headset
Transducer principle
Ear coupling
dynamic, closed
circum-aural
Frequency response
Nominal impedance
45 – 15,000 Hz
mono: 150
stereo: 300
Noise attenuation
Contact pressure
> 10 to 40 dB
approx. 10 N
Microphone incl. preamplifier
Transducer principle
BKE 45-1 condenser mic capsule,
noise-compensating
300 – 5,000 Hz
120 dB
Frequency response
Max. SPL
Terminating
impedance
150
Output voltage
400 mV ± 3dB at 114 dB
(as per RTCA/DO 214)
Supply voltage
typ. 16 V (8 to 16 V
DC
DC
approx. 8 to 25 mA as per RTCA/DO 214)
18 | HME 110
Download from Www.Somanuals.com. All Manuals Search And Download.
Specifications
General data
Connection cable
approx. 1,5 m,
unilateral
Weight without cable approx. 350 g
Connectors
¼” (6.35 mm) jack plug for headphones,
5.25 mm jack plug (PJ-068 equivalent)
for microphone
Controls
mono/stereo switch
headphone volume control
Temperature range
operation: 15°C to 55°C
storage: 55°C to 55°C
Connector assignment
5.25 mm jack plug (PJ-068 equivalent)
1 Not assigned
2 Microphone High
3 Microphone Low
1 2
3
¼” (6.35 mm) jack plug
1 Audio High left
2 Audio High right
3 Audio Low
1 2
3
HME 110 | 19
Download from Www.Somanuals.com. All Manuals Search And Download.
Manufacturer Declarations
Manufacturer Declarations
Warranty
Sennheiser electronic GmbH & Co. KG gives a warranty of 10
years on this product.
For the current warranty conditions, please visit our web site
contact your Sennheiser partner.
In compliance with the following requirements
• RoHS Directive (2002/95/EC)
• WEEE Directive (2002/96/EC)
CE Declaration of Conformity
•
• EMC Directive (2004/108/EC)
WEEE Declaration
Please dispose of this product by taking it to your local
collection point or recycling centre for such equipment.
This will help to protect the environment in which we
all live.
20 | HME 110
Download from Www.Somanuals.com. All Manuals Search And Download.
Name plates
Download from Www.Somanuals.com. All Manuals Search And Download.
Sennheiser electronic GmbH & Co. KG
Am Labor 1, 30900 Wedemark, Germany
Publ. 01/12, 547018/A01
Download from Www.Somanuals.com. All Manuals Search And Download.
|