OPERATOR’S MANUAL
®
Universal Power and Adapter Kit
2 Amp DC to DC Converter
Model No.
200.71521
CAUTION:
Read all Safety Rules and Operating Instructions,
and follow them with each use of this product.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
00-99-000868/0808
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT: READ AND SAvE THIS SAfETY AND INSTRUCTION MANUAL.
1.
IMPORTANT SAfETY INSTRUCTIONS
Before using your Universal Power and Adapter Kit converter, read and
understand this Owner’s Manual.
1.1
Keep the Universal Power and Adapter Kit well ventilated in order to prop-
erly disperse heat generated while it is in use. Make sure that there are
several inches of clearance around the top and sides and do not block the
slots of the converter.
1.2
Make sure the Universal Power and Adapter Kit is not close to any poten-
tial source of flammable fumes, gases or clothing.
1.3
1.4
Keep the Universal Power and Adapter Kit dry.
DO NOT allow the Universal Power and Adapter Kit to come into contact with
rain or moisture.
1.5
DO NOT operate the Universal Power and Adapter Kit if you, the con-
verter, the device being operated or any other surfaces that may come in
contact with any power source are wet. Water and many other liquids can
conduct electricity, which may lead to serious injury.
1.6
1.7
1.8
1.9
Do not place the Universal Power and Adapter Kit on or near heating
vents, radiators or other sources of heat.
Do not place the Universal Power and Adapter Kit in direct sunlight. The
ideal air temperature for operation is between 50° and 80°F.
Do not use the Universal Power and Adapter Kit near an open engine
compartment.
Only connect the Universal Power and Adapter Kit to a 12 - 16.5 volt ac-
cessory outlet.
1.10 Do not modify the adapter plugs or connectors in any way.
1.11 Use only five amp fuses.
wARNINg: Pursuant to California Proposition 65, this product contains
chemicals known to the State of California to cause cancer and birth de-
fects or other reproductive harm.
NOTE: Nintendo®, PSP®, Game Boy®, IPod®, and Nintendo DS® are
registered trademarks of independently owned and operated companies.
This product has not been licensed or endorsed by these companies or
their manufacturer.
• 1 •
Download from Www.Somanuals.com. All Manuals Search And Download.
2.
PRODUCT fEATURES
7
8
1
5
9
3
6
1. Nintendo game boy® Adapter
Plug*
2. Mini-USb Adapter Plug
3. Nintendo DS® Adapter Plug*
4. USb Adapter Plug
(Adapter Plugs 1-4 come
assembled in bag)
2
1
4
3
5. Six Piece Adapter Plug Set
6. Carrying Case
7. Connector Plug
8. Selector Knob
9. Converter
*Adapter plugs 1&3 are compat-
ible with but not manufactured by
Nintendo®
3.
bEfORE USINg THE UNIvERSAL POwER AND ADAPTER KIT
3.1
It is important to know that this converter only supplies DC power at the
voltage you set it to. Read the specifications in the “input” section of the
device’s manual you are about to power before plugging it in.
3.2
This converter only charges
devices (positive center pin, and
negative outside). If the polarity of the device you are trying to power has
a negative center pin and positive outside
not work.
the converter will
O.K.
3.3
Make sure that the device is turned OFF before inserting plugs. Failure to
do so may cause damage that isn’t covered by the manufacturer’s normal
warranty.
• 2 •
Download from Www.Somanuals.com. All Manuals Search And Download.
4.
OPERATINg INSTRUCTIONS
The Universal Power and Adapter Kit comes in a carrying case with 10
adapter plugs. Select the appropriate connector for the device you would
like to operate.
4.1
4.2
Setting the Converter voltage
• Determine the proper voltage setting by checking the electronic device
rating plate, owner’s manual, or number of batteries.
Plugging Adapter Plugs into the Universal Power and Adapter Kit
and Electronic Device:
• After selecting the appropriate adapter plug, push into the Universal Pow-
er and Adapter Kit’s cord plug. NOTE: Each connector has a tab guide so
that they will only fit into the plug one way. Forcing the connector into the
plug the wrong way (reversed polarity) will cause damage to your device
and/or Universal Power and Adapter Kit.
• Make sure the electronic device is turned off. Firmly push the selected
adapter into the device input socket.
4.3
Plugging Universal Power and Adapter Kit in vehicle:
• Make sure that the 12V accessory (cigarette) outlet in your vehicle is free
of any materials and debris. Particles in the accessory outlet could cause
a short; blowing the fuse in your vehicle and/or Universal Power and
Adapter Kit.
• Make sure that the vehicle’s engine is off and there is not anything
plugged into the Universal Power and Adapter Kit other than the selected
connector.
• Firmly plug the 12V end of the Universal Power and Adapter Kit into the
12V accessory outlet.
NOTE: Some vehicles’ 12V outlets are not live unless the key is turned
to the ACC position. If the red LED does not illuminate on the Universal
Power and Adapter Kit, turn the vehicle’s key to the ACC position without
starting the engine.
• The Red LED illuminates when the Universal Power and Adapter Kit
converter receives power from the 12V accessory outlet. The Universal
Power and Adapter Kit is equipped with a five amp fuse, located in the
neck of the converter, for overload protection. See the Troubleshooting
section for instructions on how to replace the fuse.
• Turn on the electronic device.
• It is not recommended to leave the Universal Power and Adapter Kit
plugged into the vehicle’s 12V accessory outlet while the car is not run-
ning. Doing so may drain the vehicle’s battery.
WARNING: To ensure that damage will not occur, check voltage and
polarity of electronic device before using this product. ALWAYS SWITCH
OFF APPLIANCES PRIOR TO INSERTION OF PLUGS. Failure to do so
may cause damage that is not covered by the normal warranty. It is best to
• 3 •
Download from Www.Somanuals.com. All Manuals Search And Download.
check your owner’s manual.
4.4
Storage of Adapter Plugs and Converter:
• The carrying case is equipped with 10 pocket holders for the adapter
plugs and a strap for the converter.
• The first four pockets across the top are specifically labeled for each con-
nector.
• The rest of the pockets have suggested labels, but the adapter plugs can
be stored in any of the six pockets that you feel fit for your devices.
5.
POwER SOURCE AND OUTPUTS
The Universal Power and Adapter Kit operates with any 12 - 16.5V DC
power source. The converter’s power is dependant on and is determined
by the charge and life of the vehicle’s battery.
The Universal Power and Adapter Kit supplies DC voltage in the range of
3V, 4.5V, 5V (USB), 6V, 9V and 12V DC at a maximum of 2 amps. Setting
the wrong voltage may damage the device you are trying to power.
Read the device’s owner’s manual specifications under the “input”
section to determine proper voltage. Using devices rated over 2
Amps will blow the fuse and could cause damage to the Universal
Power and Adapter Kit.
6.
USAgE ExAMPLES
Device Type
Portable CD Player
Estimated voltage
3 Volts
Camcorder
4.5 Volts
IPod®
5 Volts (USB)
5.4 Volts
PSP®, Game Boy®, Nintendo DS®
Camera
GPS
6 Volts
9 Volts
Radio
12 Volts
Some devices may have different specifications than the ones listed in the
table. Please refer to device’s owner’s manual before using the converter.
7.
SPECIfICATIONS
Input Voltage
Output Voltage
Fuse
12 - 16.5V DC
3V, 4.5V, 5V, 5.4V, 6V, 9V, 12V DC
5A /250V
Adapter Plugs
Mini USB, USB, Game Boy®, Nintendo DS®, 2.3mm yellow,
3.3mm orange, 4.0mm yellow, 5mm red, 5.5mm blue, 5.5mm
white.
Dimensions
7 x 1.42 x 2.75”
• 4 •
Download from Www.Somanuals.com. All Manuals Search And Download.
8.
REPLACEMENT PARTS
5A fuse: 0099000549
USb Adapter Plug: 0699000281
Mini-USb Adapter Plug: 0699000284
Nintendo game boy® Adapter Plug: 0699000282*
Nintendo DS® Adapter Plug: 0699000283*
Six Piece Adapter Plug Set: 2299001762
*Nintendo Game Boy® and Nintendo DS® adapter plugs are compatible
with but not manufactured by Nintendo®.
9.
TROUbLESHOOTINg
Problem
Cause
Solution
Device you’re trying to
power doesn’t work.
Converter is set to
wrong voltage.
Check device specifications.
Device polarity doesn’t
match.
This unit only works with
The LED is not illuminating
and device doesn’t work in
either converter or vehicle.
Bad Fuse.
Change Fuse (Directions
below)
Not inserted all the way. Make sure the converter is
firmly pushed into the acces-
sory outlet.
12V accessory plug
may be malfunctioning.
Plug in a different device. If no
results, then check outlet for
debris and then check fuse.
Damaged Cords
Please take to a qualified
service technician. Never use if
cord is damaged.
Call 1-800-SEARS-64 for
troubleshooting assistance.
Inverter may be defective.
9.1
Changing the fuse in the Universal Power and Adapter Kit:
• Make sure there are not any loads connected to the Universal Power and
Adapter Kit.
• Unscrew the head. Be careful not to lose the tab and spring.
• Turn the Universal Power and Adapter Kit upside down and let the fuse
fall in your hand.
• Replace new fuse and reverse directions. Twist the head on finger tight.
Be sure not to overtighten because it may cause damage to the con-
verter.
• 5 •
Download from Www.Somanuals.com. All Manuals Search And Download.
• 6 •
Download from Www.Somanuals.com. All Manuals Search And Download.
|