OWNER’S MANUAL
®
Power Inverter 750
Converts 12V DC Power to 110V AC
Household Electrical Power
Model No.
200.71495
CAUTION:
Read all Safety Rules and Operating Instructions,
and follow them with each use of this product.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
00-99-000862/0508
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT: CHARGE IMMEDIATELY AFTER PURCHASE
IMPORTANT: READ AND SAVE THIS SAFETY AND INSTRUCTION MANUAL.
1.
IMPORTANT SAFETY INSTRUCTIONS
Before using your Power Inverter 750, read and understand this Owner’s
Manual.
1.1
1.2
Keep the inverter well ventilated in order to properly disperse heat gener-
ated while it is in use. Make sure there are several inches of clearance
around the top and sides and do not block the slots of the inverter.
Make sure the inverter is not close to any potential source of flammable
fumes, gases or clothing.
1.3
1.4
1.5
Keep the inverter dry.
DO NOT allow the inverter to come into contact with rain or moisture.
DO NOT operate the inverter if you, the inverter, the device being operat-
ed or any other surfaces that may come in contact with any power source
are wet. Water and many other liquids can conduct electricity, which may
lead to serious injury.
1.6
1.7
Do not place the inverter on or near heating vents, radiators or other
sources of heat.
Do not place the inverter in direct sunlight. The ideal air temperature for
operation is between 50° and 80°F.
1.8
1.9
Do not use the inverter near an open engine compartment.
Only connect the power inverter to a 12-volt battery accessory outlet or
12-volt battery. Make sure the AC plug and/or USB connection is tight.
1.10 Do not modify the AC or USB receptacle in any way.
1.11 Use only 40-amp or 50-amp fuses. (Replaced by certified technician only:
1-800-SEARS-64.)
WARNING: Handling the cord on this product or cords associated with
accessories sold with this product, may expose you to lead, a chemical
known to the State of California to cause cancer and birth defects or other
reproductive harm. Wash hands after handling.
• 1 •
Download from Www.Somanuals.com. All Manuals Search And Download.
2.
POWER INVERTER 750 PRODUCT FEATURES
1. ON/OFF Button
2. Digital Display
3. LED Indicators
Voltage In
Voltage Out
Power Out
4. Two, 3-prong 110V
AC Outlets
5. Positive and Negative
Connector Knobs (not
shown)
6. USP Port (not shown)
12V Accessory Plug
Battery Clamps
3.
bEFORE USING POWER INVERTER 750
It is important to know the continuous wattage of the device you plan to
use with the inverter. The Power Inverter 750 must be used with devices
drawing 750 watts or less. If the wattage is not marked on the device, an
estimate can be made by multiplying the AC input current (Amps) by the
AC voltage (110V).
Devices like TVs, fans and electric motors require additional power to start
(commonly known as the “starting or peak power”). The Power Inverter
750 can supply a momentary surge in wattage; however even devices
rated less than the maximum 750 watts can exceed the inverters surge
capability and cause an automatic overload shutdown.
Make sure the device you are using is compatible with a modified sine
wave inverter.
• 2 •
Download from Www.Somanuals.com. All Manuals Search And Download.
4.
CONNECTING CAbLE ASSEMbLY
Determine whether you’ll be using the battery clamps (750 watt out-
put maximum) or accessory plug (120 watt output maximum).
4.1
4.2
4.3
Make sure that there is no device plugged into inverter before making con-
nection.
Unscrew the positive (red) and negative (black) plastic connector knobs
from the studs on the back of the inverter.
Slip the red (positive) ring terminal of the 12V accessory plug over the red
(positive) stud. Screw on the connector knob and tighten securely. Repeat
the same process for the black ring terminal.
4.4
Accessory Plug: Push the 12V accessory plug firmly into a 12V acces-
sory outlet.
battery Clamps: Connect the red (positive) battery clamp to the posi-
tive (+) battery terminal. Connect the black (negative) battery clamp to
the negative (-) battery terminal, taking care to shield eyes, clothing and
hands from battery acid.
5.
USING INVERTER
Determine the wattage of device being used. The Power inverter 750
must be used with devices drawing 750 watts or less when being
used with the battery Clamps and 120 watts or less when using the
Accessory Plug.
5.1
5.2
5.3
Plug the device to be operated into either the AC outlet of the inverter or
USB connector. NOTE: If using more than one device, the total combined
wattage of both devices must not exceed 750 watts.
Press and hold the ON/OFF button to turn the inverter ON. The VOLT-
AGE IN indicator will glow and the digital display will show the DC input
voltage.
Turn the device ON. To show AC VOLTAGE OUT, press the ON/OFF
button once. Press the ON/OFF button once again to show total wattage
used by the device (POWER OUT). NOTE: If there is a short circuit or
power surge in the device, SC will display and an alarm will sound. Press
the ON/OFF button to turn off the alarm. If the SC displays after several
attempts, there is a short circuit or the device requires more surge power
than the inverter is capable of providing.
5.4
TO DISCONNECT THE INVERTER:
• Turn device OFF
• Press and hold the ON/OFF button to turn the inverter OFF
• Unplug the device from inverter
• If using the Accessory Plug, unplug inverter from 12V DC accessory
outlet. If using the battery Clamps, unclamp inverter from 12V battery.
• 3 •
Download from Www.Somanuals.com. All Manuals Search And Download.
6.
DISPLAYS
6.1
LED Indicators
The LED indicators identify the operating status of the inverter.
• VOLTAGE IN: DC voltage of the battery, vehicle electrical system or
power supply.
• VOLTAGE OUT: AC voltage supplied to device through the outlets.
• POWER OUT: AC power (wattage) supplied to device through the outlets.
Digital Display
6.2
The values of the corresponding LED indicators will be shown in the digital
display.
VOLTAGE IN
●
VOLTAGE OUT
○
POWER OUT
120
○
If a problem develops during use, an audio alarm will sound, and one of
the codes shown below will display. To stop the alarm, press the ON/OFF
button.
• BaD – Inverter is not functional. Call Customer Service to trouble shoot
problem, anywhere in the U.S.A.
7 am to 4:30 pm Central Time, Monday through Friday, 1-800-SEARS-64
(1-800-732-7764).
• HIb – Vehicle’s battery voltage is more than 15.5 volts. Inverter will auto-
matically restart after the voltage drops below 15.0 volts.
• H IP – The continuous load demand from the device exceeds 750 watts.
• HoT – Inverter is overheated and automatically turns off for a period of
1–3 minutes to cool. Make sure inverter is well ventilated. It will automati-
cally restart after it cools.
• Lob – Vehicle’s battery voltage is less than 10.5 volts.
• SC– Short circuit, power surge or overload in the device.
• 4 •
Download from Www.Somanuals.com. All Manuals Search And Download.
7.
OPERATING TIPS
A typical automobile or marine battery at full charge will provide an ample
power supply for the inverter. The actual length of time the inverter can be
operated depends on the age and condition of the battery and the amount
of power being drawn by the devices.
To extend operating time when using power from a car that’s not running,
turn OFF the device before starting the engine. Then run the engine peri-
odically for approximately 10 minutes to recharge the battery.
Unplug the inverter when not in use to avoid battery drain.
A “buzzing” sound emitted from inexpensive sound systems is the result of
ineffective filters in the sound system.
Device Type
Cell Phones, MP3 Players
Portable CD Players
Laptop Computers
Video Games
Estimated Wattage
10 watts
50 watts
90 watts
100 watts
300 watts
375 watts
525 watts
TVs
Power Tools
Small Appliances
8.
SPECIFICATIONS
Maximum Continuous Power
Surge Capacity (Output Wattage)
No Load Current Draw
Wave Form
750 Watts
1500 Watts
<0.6 Amps
Modified Sine Wave
10.5 - 15.5V DC
10.7V - 11.3V DC
110V - 125V AC
Input Voltage Range
Low Battery Alarm
Output Voltage
Low Battery Shutdown
High Battery Shutdown
Optimum Efficiency
Dimensions
10.2V - 10.8V DC
15V - 16V DC
>85%
8.5”L x 4”W x 2.2”H
Approximately 3.5 lbs.
Two, 110V AC 3-Prong
Two, 50 Amp or 40 Amp (spade type)
Weight
AC Outlets
Fuse
• 5 •
Download from Www.Somanuals.com. All Manuals Search And Download.
9.
TROUbLESHOOTING
PRObLEM: ALARM IS ON
REASON
SOLUTION
Display shows SC. Device has a short Cycle inverter power OFF and ON.
circuit or demands too much surge
power.
If problem persists, use a larger inverter
or a smaller device
Remove defective device.
Call 1-800-SEARS-64 (1-800-732-7764)
for troubleshooting assistance.
Display shows Lob. 12 Volt battery is Recharge/replace low battery.
too low.
Display shows Voltage in between
10.5 and 11.0 Volts.
12 Volt battery is low.
Recharge/replace low battery.
Inverter will automatically shut off after
battery voltage reaches 10.5 volts.
Display shows Hi b. DC Voltage in is
too high.
If in a vehicle, repair/replace the alterna-
tor or charging system.
Use a properly sized and rated 12 Volt
battery.
If input voltage returns to 15 volts or less,
the inverter will automatically restart.
Display shows Hi P. Device demands
more than 750 Watts continuous
power.
Cycle inverter power OFF and ON.
If problem persists, use a larger inverter
or a smaller device.
Display shows HoT. Inverter is too hot. Increase ventilation to inverter.
Move inverter to a cooler area.
Reduce the power consumption of the
device.
Inverter will automatically reset after
cooling.
PRObLEM: INVERTER DOES NOT TURN ON
REASON
SOLUTION
Poor contact at terminals.
Unplug and reinsert Power Inverter 750.
Fuse is blown.
A blown fuse is usually caused by re-
verse polarity or a short circuit within the
inverter. The fuse is not user replaceable.
Inverter may be defective.
Call 1-800-SEARS-64 (1-800-732-7764)
for troubleshooting assistance.
• 6 •
Download from Www.Somanuals.com. All Manuals Search And Download.
10. WARRANTY
One-Year Full Warranty on DieHard Power Inverter 750
If this Power Inverter 750 fails due to a defect in material or workmanship
within one year from the date of purchase, RETURN IT TO ANY SEARS
STORE or OTHER DIEHARD OUTLET IN THE UNITED STATES FOR
FREE REPLACEMENT.
This warranty gives you specific legal rights, and you may also have other
rights which vary from state to state
Sears, Roebuck and Co., Hoffman Estates, IL 60179
For information about troubleshooting, call toll-free from anywhere in the
U.S.A. 7 am to 4:30 pm CT Monday through Friday.
1-800-SEARS-64 (1-800-732-7764).
• 7 •
Download from Www.Somanuals.com. All Manuals Search And Download.
• 8 •
Download from Www.Somanuals.com. All Manuals Search And Download.
|