Sangean Electronics Portable Radio DT 200V User Guide

Download from Www.Somanuals.com. All Manuals Search And Download.  
LOCATION OF CONTROLS  
Congratulations and welcome to  
The SANGEAN WORLD OF LISTENING!  
To insure proper operation please famililarize  
Yourself with these instructions before using your  
New receiver  
1 . O n / O ff B u t t o n  
2 . Vo l u m e C o n t r o l  
3 . E a r p h o n e J a c k  
4 . L c d D d i s p l a y  
5 . Tu n i n g C o n t r o l  
6 . Tu n i n g C o n t r o l  
7 . B a n d S e l e c t i o n B u t t o n  
8 . M o n o / S t e r e o B u t t o n  
9 . M e m o r y B u t t o n  
1 0 . S e l e c t B u t t o n  
11 . S p e a k e r O n / O ff S w i t c h  
1 2 . B a t t e r y C o m p a r t m e n t  
1 3 . L o c k S w i t c h  
1 4 . B e l t C l i p  
2
Download from Www.Somanuals.com. All Manuals Search And Download.  
2
3
1
5
6
4
11  
9
7
10  
8
13  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
14  
12  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
BATTERY INSTALLATION  
The battery cover is located on the back of the unit.  
Slide the cover in the direction of the arrow to gain  
access to the battery compartment(12). Insert 2  
AA batteries into the compartment(12). Make sure  
that the batteries are positioned in accordance with  
the diagram located below batteries in battery com-  
partment. Replace cover.  
NOTE:  
(1) A flashing "E" appearing on the LCD  
Display indicates a weak battery and  
replacement is necessary  
(2) To ensure that the preset memories are  
not lost during the battery replacement,  
two steps must be followed . Make sure  
that the power ON/OFF switch is in the  
"OFF" position and the battery  
replacement is completed within one  
minute . If these two steps are not  
accomplished , the memory will have to  
be reset  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
ANTENNA/EARPHONE USE  
The cord connecting the headphones to the re-  
ceiver acts as an antenna during FM/TV reception  
and should be extended as much as possible to  
increase FM/TV sensitivity . Insert the Earphones  
into the Earphone Jack(3).Abuilt-in Ferrite Ante-  
nna is provided for AM reception and it is only  
necessary to rotate the radio for maximum signal  
strength during AM listening  
SPEAKER ON/OFF SELECTOR  
speaker Output may be turned on or off using  
the Speaker ON/OFF Selector (11).A( ) will  
appear in the LCD Display (4) if the Speaker  
On/Off switch(11) is in the off position and the  
headphones are inserted into the Earphone  
Jack(3).The Speaker On/Off Selector must  
be in the Off position with the earphones  
plugged into the earphone jack to receive FM  
stereo programs  
VOLUME CONTROL  
Adjust the Volume Control(2) by rotating clockwise  
to increase Volume.  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
TUNING THE RADIO  
BAND FREQUENCY  
ANTENNA  
AM 520-1710KHZ Internal/Rotate radio for  
best reception  
FM 87.5-108MHZ External/Make sure Head-  
phones are inserted into  
Headphone Jack  
TV ch.2-13(VHF) External/Make sure Head-  
phones are inserted into  
Headphone Jack  
A
SCAN TUNNING  
Turn on the Radion by pressing On/Off Button  
(1).Select AM,FM or TV Band by pressing  
Band Selection Button(7) and then press and  
Hold the Tuning Control(5) or(6) for more than  
1/2 second. The Radio will Scan all the  
frequencies in that Band and will stop  
automatically for 3-4 seconds each time it  
lands on an active station.Push the Tuning  
Control again and the Radio will stay at the  
Station you have selected. The Radio will turn  
tself off automatically after 60 minutes of  
Operation or you may turn it of at anytime by  
Pressing the On/Off Button.  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
B
C
MANUAL TUNING  
Turn on the Radio by pressing On/Off Button  
(1). Select AM,FM or TV Band by pressing  
Band Selection Button (7).Desired station  
May be selected by either pressing the Tuning  
Control(5)or(6) intermittently until the desired  
Station is reached or pressing and holding the  
Tuning Control until the desired station is  
Reached. Release and push the Tuning  
Control once again to retain the desired  
Station.  
MEMORY TUNING(STAION PRESET)  
Turn on the Ridio by pressing On/Off Button  
(1).Select AM or FM Band by pressing Band  
Selection Button (7).Tune to the desired sta-  
Tion using the Manual or Scan Tuning Methods  
As reached and indicated in the desired station  
Is reached and indicated in the LCD Display  
(4) Press the Memory Button (9).A M will  
flash in the LCD Display. During its flashing  
push the Select Button (10).The Number of  
the Memory position will appear successively  
each time the Select Button is pressed. Select  
the Number Position for the station appearing  
in the LCD Display by pressing the Menory  
Button (9) when the correct position appears  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  
In the LCD Display. You may store a total of  
19 stations in any mix from any band.Original  
stations are eliminated when new stations are  
selected to take their places.  
D
MEMORY TUNING (STATION RECALL)  
Turn on the Radio by pressing On/Off Button  
(1). Select AM, FM or TV Band by pressing  
Band Selection Button (7). Pressing and  
Holding the Select Button (10) for more than  
1/2 second will begin displaying the stored sta-  
tion and their associated numbers one by one  
in the LCD Display .Numbers order of display  
may be changed form ascending to descen-  
ding and vice versa at any time by pressing  
the Tuning Controls (5) or (6) .It is only  
necessary to press the Select Button a second  
time when the desired station appears in the  
LCD Display to retain the desired station  
MONO/STEREO BUTTON  
Monaural or Stereo reception may be selected  
Through the Headphones during FM reception by  
Alternately pressing the Mono/Stereo Button (8).  
The Speaker On/Off Switch (11) must be in the Off  
Position.  
9
Download from Www.Somanuals.com. All Manuals Search And Download.  
LOCK SWITCH  
To prevent accidental changing of any o the radio  
settings move the Lock Switch (13)to its up , locked  
position(  
). To release simply move the switch  
to its down position. IT IS IMPORTANT TO MAKE  
SURE LOCK SWITCH IS IN ITS DOWN POSITION  
WHEN RADIO IS TO BE USED AS RADIO IS  
COMPLETELY INOPERATIVE UNTIL LOCK  
SWITCH IS RELEASED . If the Radio is not to be  
Used for any extended period of time battery power  
Savings may be realized by setting-Lock Switch  
In its locked (  
) position during storage.  
BELT CLIP  
A removable Belt Clip(14) is provided on the back  
Of the unit.It can be removed by gently pushing  
Where indicated on the back of the clip and moving  
The clip in the direction of the battery case ad in-  
Dicated in the illustration.Reverse procedure to  
Reinstall clip.  
14  
14  
REMOVAL  
Download from Www.Somanuals.com. All Manuals Search And Download.  
REINSTALL  
10  
SPECIFICATIONS  
Type: FM-Stereo(Via headphones)  
AM Standard(mono)  
TV Band (mono, CH. 2-13VHF)  
Earphone Jack:3.5mm mini-plug  
32 ohm impedance (stereo)  
Output Power:60mW(10%THD) Via built-in  
speaker  
32 ohm impedance(stereo)  
Speaker:1 inch diameter, 4 ohms impedance  
External Power:  
AM  
FM/TV  
Speaker Earphones  
60  
78  
50MA  
68MA  
Batteries:3 Volts(AA size)x 2  
Dimensions (Wx Hx D):  
4 3-8"Hx2 5/8"W x3/4"D  
Weight:5.0 ounces approximately without batteries.  
11  
Download from Www.Somanuals.com. All Manuals Search And Download.  
MAINTENANCE  
1.Keep the radio dry. If it does get wet, wipe it  
immediately. Liquids may contain chemicals that  
can corrode electronic circuitry.  
2.Use and store your radio only in normal  
temperature environments. High temperature  
can shorten the life of electronic devices,  
damage batteries and melt plastic parts.  
3.Handle the radio gently and carefully. Dropping  
it can damage circuit boards and cases and  
render it defective.  
4.Keep the radio away from dust and dirt.  
5.Wipe the radio with a damp cloth to keep it look-  
ing new. Do not use harsh chemicals, solvents  
or strong detergents.  
6.Use only fresh batteries of the recommended  
size and type. Always remove old or weak bat-  
teries as they can leak and destroy electronic  
components and circuitry.  
7.Modifying or tampering with the radio 's internal  
components can cause a malfunction, and will  
void the product's warranty.  
WARRANTY  
Please see the Statement of Limited Warranty  
enclosed with your Sangean Product for complete  
details.  
12  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Q See Security Camera QT426 818 User Guide
Quadra Fire Stove 7023 111E User Guide
Radio Shack Cordless Telephone ET 521 User Guide
Ricoh Universal Remote FOCUS 3 MODE User Guide
Rival Gas Grill GRF405 User Guide
Rosen Entertainment Systems Home Theater Server AC 3105 User Guide
Ryobi Outdoor Trimmer CS30, SS30, BC30 User Guide
Sanyo DVD Player DS32830H User Guide
Sanyo Flat Panel Television DP42410 User Guide
Sears Power Supply 20071521 User Guide