Samson Speaker 215XL User Guide

2 x15Stackable  
Aluminum Drive Bass Enclosure  
Hartke  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Connecting the 215XL  
About Impedance  
Before you hook up your speaker cabinet, be sure that you understand a little about  
impedance. Impedance is the electronic load that the speaker puts on the power amplifier  
and is measured in Ohms.  
Here is the tricky, yet simple rule of impedance: When two speakers are wired in "Parallel"  
the total impedance is cut in half and  
when two speakers are wire in “Series”  
the total impedance is the sum of the  
speakers individual impedance.  
The 215XL impedance (many audio  
guys used the made up word “ohmage”,  
however the correct term is impedance)  
is 4 Ohms. So, when two 215XL’s are  
connected together in parallel, the total  
impedance is 2 Ohms. The impedance  
of your speaker also has an effect on  
your amplifier. In general, the lower the  
impedance, the more power your ampli-  
fier will put out.  
EFFECT  
Hartke Systems  
Distributed Exclusively by  
Samson Technologies Corp.  
Hicksville, New York 11802  
RETUIRN  
SEND  
MODEL 2000  
200 WATTS  
~
AC INPUT  
115V/230V 50/60Hz  
FUSE  
5A/250V, 180W (115V)  
2.5A/250V, 450W (230V)  
8
4
=
=
120 WATTS  
200 WATTS  
SPEAKER OUTPUTS  
CAUTION  
TO PREVENT SHOCK, DO NOT OPEN. NO USER SERVICE-  
ABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED  
SERVICE PERSONNEL. TO PREVENT FIRE OR SHOCK  
HAZARD, DO NOT EXPOSE TO RAIN OR MOISTURE.  
HPF  
OFF  
ON  
8
8
SERIAL NUMBER  
ASSEMBLED IN R.O.K.  
4
IMPORTANT: There is a minimum safe  
impedance so be sure to check the  
manufacturer’s recommended imped-  
ance for your amplifier to avoid any  
damage to your amplifier or voiding  
your warranty.  
Connecting the 215XL to Your Amplifier  
The 215XL connections are made via  
1/4” phone jacks located on the rear  
panel jack-plate. Be sure to make your  
connection with un-shielded speaker  
cable. Connect the Amplifier Output to  
the speaker Input on the 215XL’s rear  
jackplate.  
Using the EXTENSION Output  
The 215XL provides a convenient  
Extension Output for connecting addi-  
tional speaker cabinets in parallel. Be  
sure to read the section above on  
impedance to insure a proper hook-up  
with your amplifier.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Specifications  
Hartke 215XL Specifications  
Type  
Tuned, Vented Enclosure  
4 Ohms Impedance  
400 Watts RMS Power Handling  
2-Hartke 15XL8 Special Design  
Aluminum 15", 8 ohm, 200 watt  
drive unit  
Impedance (Ohms)  
Power Handling  
Drivers  
SPL  
101dB  
Frequency Response  
Inputs  
30Hz - 2.5kHz  
1/4-inch Phone  
Weight  
105 lbs. (47.63)  
Dimensions  
Height:34" (86.36 cm)  
Width: 24" (60.96 cm)  
Depth: 18.5" (46.99 cm)  
Hartke  
Hartke  
575 Underhill Blvd.  
P.O. Box 9031  
Syosset, NY 11791-9031  
Phone: 1-800-3-SAMSON (1-800-372-6766)  
Fax: 516-364-3888  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Raypak Heat Pump RHP 33 User Guide
RCA Flat Panel Television J12H770 User Guide
RCA Microwave Oven RMW1108 User Guide
Remington Electric Shaver MB 900 User Guide
Rockford Fosgate Stereo Amplifier PUNCH100 User Guide
Rotel Stereo Amplifier RA935BX User Guide
Samson Musical Toy Instrument Graphite 25 User Guide
Sanyo Air Conditioner 36K72R User Guide
Sanyo Battery Charger N 6PT User Guide
Sceptre Technologies Flat Panel Television SCEPTRE X425 HDTV User Guide