IMPORTANT NOTES
291b
In addition to the items listed under “IMPORTANT SAFETY INSTRUCTIONS” and “USING THE UNIT SAFELY” on pages 2,
3 and 4, please read and observe the following:
Add
Power Supply
• Do not connect this unit to same electrical outlet that is being
used by an electrical appliance that is controlled by an inverter
• Do not allow objects to remain on top of the unit while it is in
301
operation.
Maintenance
(such as a refrigerator, washing machine, microwave oven, or air
conditioner), or that contains a motor. Depending on the way in
401a
• For everyday cleaning wipe the unit with a soft, dry cloth or one
which the electrical appliance is used, power supply noise may
that has been slightly dampened with water. To remove stubborn
cause this unit to malfunction or may produce audible noise. If it
dirt, use a cloth impregnated with a mild, non-abrasive detergent.
is not practical to use a separate electrical outlet, connect a power
Afterwards, be sure to wipe the unit thoroughly with a soft, dry
supply noise filter between this unit and the electrical outlet.
cloth.
307
402
• Before connecting this unit to other devices, turn off the power to
• Never use benzine, thinners, alcohol or solvents of any kind, to
all units. This will help prevent malfunctions and/or damage to
avoid the possibility of discoloration and/or deformation.
speakers or other devices.
Add
• For routine care of the carpeted surfaces, use a brush with stiff
308
• Although the LEDs are switched off when the POWER switch is
bristles.
switched off, this does not mean that the unit has been
completely disconnected from the source of power. If you need to
turn off the power completely, first turn off the POWER switch,
Additional Precautions
553
• Use a reasonable amount of care when using the unit’s buttons,
sliders, or other controls; and when using its jacks and
connectors. Rough handling can lead to malfunctions.
then unplug the power cord from the power outlet. For this
reason, the outlet into which you choose to connect the power
cord’s plug should be one that is within easy reach and readily
accessible.
556
• When connecting / disconnecting all cables, grasp the connector
itself—never pull on the cable. This way you will avoid causing
shorts, or damage to the cable’s internal elements.
Placement
351
557
• Using the unit near power amplifiers (or other equipment
• A small amount of heat will radiate from the unit during normal
containing large power transformers) may induce hum. To
alleviate the problem, change the orientation of this unit; or move
it farther away from the source of interference.
operation.
558a
• To avoid disturbing your neighbors, try to keep the unit’s volume
352a
at reasonable levels. You may prefer to use headphones, so you
do not need to be concerned about those around you (especially
when it is late at night).
• This device may interfere with radio and television reception. Do
not use this device in the vicinity of such receivers.
352b
559a
• Noise may be produced if wireless communications devices, such
• When you need to transport the unit, package it in the box
as cell phones, are operated in the vicinity of this unit. Such noise
could occur when receiving or initiating a call, or while
conversing. Should you experience such problems, you should
relocate such wireless devices so they are at a greater distance
from this unit, or switch them off.
(including padding) that it came in, if possible. Otherwise, you
will need to use equivalent packaging materials.
562
• Some connection cables contain resistors. Do not use cables that
incorporate resistors for connecting to this unit. The use of such
cables can cause the sound level to be extremely low, or impos-
sible to hear. For information on cable specifications, contact the
manufacturer of the cable.
354b
• Do not expose the unit to direct sunlight, place it near devices
that radiate heat, leave it inside an enclosed vehicle, or otherwise
subject it to temperature extremes. Also, do not allow lighting
devices that normally are used while their light source is very
close to the unit (such as a piano light), or powerful spotlights to
shine upon the same area of the unit for extended periods of time.
Excessive heat can deform or discolor the unit.
add
• Do not place your hands inside the ports on the front of the
KCW-1. Your hands may become lodged in the ports, possibly
resulting in injury to your hand and damaging the unit.
Particularly when using the unit in the presence of small children,
always make sure that an adult is present to provide supervision
and prevent children from inserting their hands or feet in the
ports.
3•55bWhen moved from one location to another where the temper-
ature and/or humidity is very different, water droplets (conden-
sation) may form inside the unit. Damage or malfunction may
result if you attempt to use the unit in this condition. Therefore,
before using the unit, you must allow it to stand for several
hours, until the condensation has completely evaporated.
356
• Do not allow rubber, vinyl, or similar materials to remain on the
unit for long periods of time. Such objects can discolor or
otherwise harmfully affect the finish.
359
• Do not paste stickers, decals, or the like to this instrument.
Peeling such matter off the instrument may damage the exterior
finish.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
