®ÂØÒňή
JV-1010
TurboStart
64-Voice Synthesizer
Module
Playing the Demo Songs
It’s a Fact…
The JV-1010 64-Voice Synthesizer Module is a half
rackspace sound module that features the full sound
set of the JV-1080/2080 synth modules. It also
includes the sounds from the Session wave
expansion board, and a slot for installing an
additional SR-JV80 Series expansion board of your
choice. Features include:
The JV-1010 contains four demo songs that
demonstrate its internal sounds and effects. Use the
following procedure to listen to the demo songs:
1. Turn the CATEGORY/BANK knob to select
DEMO.
2. Turn the VALUE knob to select the desired song.
3. Press the VALUE knob or the VOLUME knob
start demo song playback. Press either knob
again to stop playback.
•
Compact half-rackspace, expandable synth
module with 64-voice polyphony
Includes the complete sound set of the
JV-1080/2080 sound modules, plus the sounds
from the Session expansion board (1023
patches before expansion)
•
Selecting Patches
The JV-1010 contains over 1,000 built-in sounds.
Use the following procedure to select a patch:
1. Press the VALUE knob to select Patch mode
•
Expansion slot for installing one of sixteen
additional SR-JV80 Series Wave Expansion
boards
(PATCH).
•
•
Intuitive knob-style control and straightforward
interface
Dedicated reverb and chorus effects, plus 40
built-in effect algorithms such as distortion and
rotary simulation
2. Turn the CATEGORY/BANK knob to select the
desired bank.
3. Turn the VALUE knob to select the desired
patch.
Try these patches:
•
Phrase Preview button and Category Bank Select
knob make it easy to find the patches you want
General MIDI compatible
Includes Emagic SoundDiver software for
patch editing
•
•
•
•
•
User: No. 017 Adrenaline
•
•
Preset-A: No. 023 PsychoRhodes
Preset-B: No. 052 Blade Racer
Preset-E: No. 095 Dimensional
Session: No. 182 DCO Sweeper.
Initialize
Using the Category Function
This function resets the settings of the patch,
performance, and rhythm sets to the factory default
settings. Use the following procedure to initialize the
JV-1010:
The Category function allows you to search for
patches based on instrument type. Use the following
procedure to select a patch by category:
1. Press the VALUE knob to select Patch mode
1. Press VALUE knob to switch to a mode other
than the patch mode.
(PATCH).
2. Turn the CATEGORY/BANK knob to select a
2. Hold down the VOLUME knob and press the VALUE
knob.
category.
3. Turn the CATEGORY/BANK knob to select
PIANO (Factory Reset).
3. Turn the VALUE knob to select the desired
patch.
4. Press the VALUE knob to display “Sur.”
5. Press the VALUE knob to initialize the JV-1010.
TBS98
© 1999 Roland Corporation U.S., 5100 S. Eastern Ave., Los Angeles CA 90040
Faxback # 20094
Page 1
Download from Www.Somanuals.com. All Manuals Search And Download.
|