CR9961
3BandSingleAlarm
ClockRadio
Please read this manual before use
Download from Www.Somanuals.com. All Manuals Search And Download.
3
Controls
(Top)
2
1
4
5
6
1. Hour button
2. Minute button
3. Sleep button
4. Time button
5. Alarm off button
6. Snooze button
Download from Www.Somanuals.com. All Manuals Search And Download.
3
Controls
(Left)
(Right)
7
8
9
10
11
7. Function switch
8. Tuning control
10. Volume control
11. Back-up battery compartment
9. Wave Band selector
Download from Www.Somanuals.com. All Manuals Search And Download.
4
Switching on and setting the time
Before using your clock radio you must first set the correct time.
1. Place the unit on a flat surface. Plug the mains lead into a wall socket
and switch on the wall socket.
2. The clock display will flash 12:00. Ensure that the Function switch
is set to the 'Off' position.
3. Press and hold down the Time button.
4. Whilst holding down the Time button press the Hour or Minute
buttons to set the correct time. Release the buttons when the
correct time is reached. The clock uses a 12 hour display with a PM
indicator. Ensure that the correct 12 hour cycle is selected.
3
2
4
4
If you need any further advice, please call our Technical Helpline on :-
Download from Www.Somanuals.com. All Manuals Search And Download.
5
02087580338(Mon-Fri)
Listening to the Radio
1. Switch on your clock radio by sliding the Function switch to the
'On' position. The LED dial pointer will light up indicating that the
radio is switched on
1
2. Slide the Waveband switch to the required waveband.
3. Tune in to the desired station by rotating the Tuning control. The
station frequency is indicated in the dial scale.
The Wire aerial located on the rear of your clock radio is for FM
reception. The wire should be fully extended and positioned for
optimum reception.
For MW and LW reception there is a built in ferrite aerial. Rotate your
clock radio to the position giving best reception.
4. Adjust the volume by rotating the Volume control.
5. The radio can be switched off by sliding the Function switch to the
'Off' position.
3
2
5
4
Download from Www.Somanuals.com. All Manuals Search And Download.
6
Setting alarm time
The alarm can be set to wake you by either the buzzer or the radio.
1. Press and hold down the ALARM/OFF button.
1
2
2. Whilst holding down the ALARM/OFF button press the Hour or
Minute button to set the correct time. Release the buttons when
the correct time is reached. The clock uses a 12 hour display with
a PM indicator. Ensure that the correct 12 hour cycle is selected.
2
Checking alarm time
1. To check the Alarm time, press the ALARM/OFF button. The Alarm
time will appear in the display.
1
If you need any further advice, please call our Technical Helpline on :-
Download from Www.Somanuals.com. All Manuals Search And Download.
7
02087580338(Mon-Fri)
Setting the alarm to wake to buzzer
1. Set the alarm time as previously described. Set the function switch
to the 'Buzz' position. The Alarm indicator will light.
1
The buzzer alarm will sound every day at the preset time for 1 hour
and 59 minutes. To turn off the alarm until the next day press the
ALARM/OFF button. To turn off the alarm permanently set the
Function switch to the 'Off' position.
Setting the alarm to wake to radio
1. Set the alarm time as previously described. Set the function switch
to the 'Auto' position. The Alarm indicator will light.
Ensure that the volume is set to the correct level and the desired
station is tuned in
1
The radio alarm will sound every day at the preset time for 1 hour
and 59 minutes. To turn off the alarm until the next day press the
ALARM/OFF button. To turn off the alarm permanently set the
Function switch to the 'Off' position.
Download from Www.Somanuals.com. All Manuals Search And Download.
8
Snooze control
1. The buzzer or radio alarm can be silenced for 9 minutes by pressing
the Snooze button. This sequence can be repeated several times
during the alarm period.
1
Sleep timer
1. The radio can be set to switch off automatically after a preset time
has elapsed.
2
2. Press and release the Sleep button, 59 minutes is displayed. The
radio will be on for 59 minutes then turn off automatically.
3. For a shorter sleep time hold down the Sleep button and the
Minute button, the display will count from 59 to 0. Release the
buttons when the desired sleep time is reached.
3
3
4. The sleep time can be extended to 1 hour and 59 minutes by holding
down the Sleep button and pressing the Hour button once.
4
5
4
5. To set the sleep time for duration between 1 hour 59 minutes and
1 hour, hold down the Sleep button and the Minute button, the
display will count from 1 hour 59 minutes to 1 hour. Release the
buttons when the desired sleep time is reached.
5
6. To end the sleep function prematurely, press the Snooze button.
6
If you need any further advice, please call our Technical Helpline on :-
Download from Www.Somanuals.com. All Manuals Search And Download.
9
02087580338(Mon-Fri)
Headphones
1. A Headphone Socket (3.5mm) located on the back of the unit is
provided for use with either headphones or an earpiece. Inserting
a plug automatically mutes the internal loudspeaker.
1
Download from Www.Somanuals.com. All Manuals Search And Download.
10
Specifications
Power Requirements
Mains
Circuit Features
Loudspeaker
8 ohms
0.8 Watts
FM
AC 230 volts, 50Hz
only
Output power
Aerial System
Back-up Battery
IECsize6F22/06PP(6LR61, PP3)
Wire Aerial
Frequency Coverage
FM
87.5 - 108MHz
525 - 1605kHz
150 - 285kHz
MW/LW
Built-inFerriteBaraerial
MW
LW
The Company reserves the right to amend the specification without notice.
If you need any further advice, please call our Technical Helpline on :-
Download from Www.Somanuals.com. All Manuals Search And Download.
11
02087580338(Mon-Fri)
General
Fuse
Do not allow this unit to be exposed to moisture (e.g. dripping or
splashing) or to temperatures exceeding 70 degrees centigrade. It is
recommended that the FM band be used wherever possible as better
results in terms of quality and freedom from interference will usually be
obtained than on the MW/LW bands.
This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug
(BS1363). If another type of plug is used a 5A fuse should be fitted in
the plug, adaptor or distribution board.
IFINDOUBT-CONSULTAQUALIFIEDELECTRICIAN.
Back-upBattery(notnecessaryfortheunittofunction)
Mainssupply
Slide the battery cover catch in the direction of the arrow. Open the
battery cover. Fit a 9 volt IEC size 6F22/06PP (6LR61, PP3) or equivalent
battery into the compartment. Observe the correct polarity as shown
inside the battery compartment. Replace the battery cover.
The CR9961 will operate from a supply of AC 230volts, 50Hz
only.
For your convenience this product is supplied with a plug which is fitted
with a fuse of the appropriate rating. If the plug supplied is not suitable
for your socket outlet, it should be removed by unscrewing the plug top,
the terminal screws and removing the cable.
The time and alarm settings will be retained during a temporary failure
of the AC mains supply. The LED display will not be operational. The
display will be extinguished to conserve battery life, but the memory will
retain details of the time and alarm time settings.
The correct style of plug to suit your household together with a correctly
rated fuse should be fitted.
IFINDOUBT-CONSULTAQUALIFIEDELECTRICIAN
If your clock radio is not to be used for a prolonged period of time, remove
the battery to avoid damage by battery leakage.
IMPORTANT: DO NOT make any connection to the larger terminal which
is marked with the letter E or by the safety earth symbol
Green or Green-and-yellow.
or coloured
The Nameplate is located
on the underside of your
clock radio.
The wires in the mains lead are coloured in accordance with the
following codes :-
BLUE - NEUTRAL
BROWN - LIVE
As these colours may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:-
The wire coloured BLUE must be
connected to the terminal marked N
or coloured BLACK.
The wire coloured BROWN must be
connected to the terminal marked L
or coloured RED.
Download from Www.Somanuals.com. All Manuals Search And Download.
12
Notes
Download from Www.Somanuals.com. All Manuals Search And Download.
13
Notes
Download from Www.Somanuals.com. All Manuals Search And Download.
14
Guarantee
This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component
breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced
free of charge.
The guarantee does not cover:
1. Damage resulting from incorrect use.
2. Consequential damage.
3. Receivers with removed or defaced serial numbers.
Procedure:
Any claim under this guarantee should be made through the dealer from whom the instrument was purchased. It is likely that your Roberts' dealer
will be able to attend to any defect quickly and efficiently, but should it be necessary the dealer will return the instrument to the company’s service
department for attention. In the event that it is not possible to return the instrument to the Roberts' dealer from whom it was purchased, please
contact Roberts Radio Technical Services department at the address shown on the rear of this manual before taking further action.
These statements do not affect the statutory rights of a consumer.
If you need any further advice, please call our Technical Helpline on :-
Download from Www.Somanuals.com. All Manuals Search And Download.
02087580338(Mon-Fri)
ROBERTS RADIO TECHNICAL SERVICES
97-99WortonRoad
IsleworthMiddlesex
TW76EG
Technical Helpline:- 020 8758 0338 (Mon-Fri)
Issue 1
Download from Www.Somanuals.com. All Manuals Search And Download.
|