Revolabs Fusion Microphone System - Polycom HDX 9001/9002 Setup Guide
NOTES AND CAUTIONS:
This setup guide will guide you through the steps needed to properly connect a
Revolabs Fusion Microphone System to a Polycom HDX 9001/9002 video codec.
1. Connecting the Cables
2. Configuring the HDX 9001/9002 Video Codec
Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Fusion Microphone System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Fusion 4 or 8 Channel Microphone System
2. Polycom HDX 9001/9002 video codec
3. QTY 2 RCA-RCA male cable with QTY 2 Polycom Audio Adapter Cable (P/N
2457-23492-001) or equivalent*
**OR**
4. QTY 2 Revolabs 07-POLHDX-01 Audio Cables*
5. Amplified speakers
*POLYCOM HDX 9000 SERIES VIDEO CODECS HAVE PHOENIX CONNECTORS FORAUDIO INPUT/OUTPUT WHILE REVOLABS
FUSION PRODUCTS USE RCACONNECTORS FORAUDIO INPUT/OUTPUT. THE POLYCOM AUDIO ADAPTER CABLE (P/N2457-
23492-001)CONVERTS TWO PHOENIX CONNECTORS INTO FEMALE RCACONNECTORS. OTHERWISE,A TECHNICIAN COULD
SIMPLY CUT OFF THE ENDS OF TWO RCACABLES AND CONNECT PER THIS DIAGRAM (REFERENCED FROM THE POLYCOM
INTEGRATOR’S REFERENCE MANUAL FOR THE VSX SERIES VERSION 8.7,AUGUST 2007):
Download from Www.Somanuals.com. All Manuals Search And Download.
Configuring the HDX 9001/9002 Video Codec
CONFIGURING THE AUDIO MENUS OF THE HDX 9001/9002VIDEO CODEC
1. Select SYSTEM
2. Select ADMIN SETTINGS and enter the Administrator password (if needed)
3. Select AUDIO
4. Select AUDIO SETTINGS
5. Disable POLYCOM MICROPHONES by removing the check mark. Having
Revolabs and Polycom microphones will increase ambient noise, add to echo
cancellation problems, and reduce articulation
6. Verify LIVE MUSIC MODE is disabled by removing the check mark. Polycom
noise suppression is turned off when this is active
7. Select INPUTS/OUTPUTS
8. Confirm or modify the following settings:
a. INPUT TYPE is LINE INPUT
b. INPUT TYPE LEVEL is 50% or 5
c. ECHO CANCELLER is OFF
d. LINE OUTPUT MODE is FIXED
e. LINE OUTPUT LEVEL is 100% or 10
9. Press OK to save all changes
NOTE: You must use your Fusion remote control to control the room volume
for both the audio and video conference calls. Adjusting the volume in the
video codec will cause echo.
Download from Www.Somanuals.com. All Manuals Search And Download.
|