CS27326_3510is_IB_update 6/28/05 9:58 AM Page 1
Use and Care Guide
D-3510is
Download from Www.Somanuals.com. All Manuals Search And Download.
CS27326_3510is_IB_update 6/28/05 9:58 AM Page 4
Safety Instructions
1. Should the ALCI safety device trip (i.e.,
the reset button pops out) during use,
press the reset button. Should the hair
dryer fail to reset, call 800-736-4648.
Never operate this appliance if it has
been dropped in water.
ALCI Safety Device
This hair dryer is provided with an
appliance leakage circuit interrupter (ALCI)
safety device built into the plug. This device
is designed to make the unit inoperable
under some abnormal conditions, such as
accidental immersion in water. The ALCI
safety device is equipped with a test button
so that its operation can be checked.
This unit should be tested before each use
2. The dryer is designed to work on
ordinary household current only, 125
volts A.C., 60 Hz. It is not intended for
commercial use.
GROUND FAULT CIRCUIT
INTERRUPTERS CAN
SAVE A LIFE!
to confirm that the safety device is
operational.
3. This appliance is equipped with an
automatic thermal limiter, which will
To test:
cycle off when overheated and come
After plugging in your hair dryer:
back on when cooled down. If the unit
If you must use your hair dryer in the
cycles off, unplug the cord for several
minutes before restarting.
ALCI device.
1. Press the reset button on the
bathroom, install a GFCI* now!
Your local electrician can help you decide which type is best for you –
a portable unit that plugs into the electrical outlet or a permanent
unit installed by your electrician. The National Electrical Code now
requires GFCI’s in bathrooms, garages, and outdoor outlets of all
new homes.
4. This appliance has a polarized plug
2. Press the test button. The reset button
(one blade is wider than the other). As
will pop out. This verifies that the safety
a safety feature, this plug will fit in a
device is operating properly.
polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a
qualified electrician. Do not attempt to
3. Press the reset button to reactivate your
ALCI safety device.
Why do you need a GFCI?
Electricity and water don’t mix. If your hair dryer falls in water while
it’s plugged in, the electric shock can kill you– even if the switch is
“off.” A regular fuse or circuit breaker won’t protect you under these
circumstances. A GFCI offers you greater protection.
defeat this safety feature.
4. Your hair dryer is now ready for use.
Note: This unit may automatically trip
when unplugged. If so, the unit must be
reset after it is plugged in. If the dryer
doesn’t reset after following the above
testing procedure, call 800-736-4648.
A GFCI can save your life!
Compared to that, the price is small!
Don’t wait… install one now!
*GFCI is a sensitive device that reacts immedi-
ately to a small electric current leak by stopping
the electricity flow.
4
5
Download from Www.Somanuals.com. All Manuals Search And Download.
CS27326_3510is_IB_update 6/28/05 9:58 AM Page 6
Product Features
Thank you for purchasing the Remington® Protect & Shine™
ionic hair dryer with 3X protection – the ultimate defense against damage.
1875 watts
Complete ion protection & control Remington ion control technology.
Cool Shot
Removable
grille
Air concentrator
- /+
Ion
3 heat settings
Switch
OFF/LOW/HIGH
speed settings
Angled barrel for
easy handling when
drying the top of
your head
Cord with
hang loop
Ceramic Heat
Ionic Conditioning
Ceramic emits far-infrared,
radiant heat to help dry
water molecules inside the
hair strand. This fast and
efficient process helps
prevent heat damage to
the outer cuticle for less
frizz and shine.
Negative ions prevent static
and frizz, giving hair a more
healthy-looking shine.
Slow-Moving
Hot Air
Fast Air
High Speed
Airflow
A powerful fan design with a narrow
barrel creates a high-speed airflow to
help reduce hot spots and over-drying.
6
7
Download from Www.Somanuals.com. All Manuals Search And Download.
CS27326_3510is_IB_update 6/28/05 9:58 AM Page 8
How to Use
Hair Care Tips
■ To create a style with lots of body, apply
Cool Shot:
The Cool Shot sets the style by blowing a
cool stream of air. Press and hold cool shot
Basic Drying Techniques
Hair Care Tips
volumizing mousse to towel dried hair.
Distribute it evenly from roots to ends,
then blow dry as usual. Hair will be soft,
shiny, and full of volume.
1. Gently towel dry hair to remove excess
■ Keep the dryer about 8 inches away
from your head to avoid burning scalp or
damaging hair.
water. Avoid rubbing hair with towel –
button to set style. Release button to return
this creates split ends and frizziness.
to warm air flow.
Detangle hair with a wide-toothed comb.
■ Always keep the dryer pointed down the
hair shaft to smooth the cuticle and
create a silky, shiny style.
■ For a super smooth, salon-like blow dry,
finish by running a straightening iron
over dried hair.
For straight, smooth hair:
With the dryer turned off, attach the
concentrator to the end of the nozzle. Brush
2. Be sure dryer is turned off. Plug dryer
into an electrical outlet.
hair from underneath using a large, round
brush or paddle brush. Pull hair down until
3. Set dryer ion switch to negative (-)
drying ion position. Turn the dryer on
■ To help prevent heat damage and add
shine, spritz damp hair with a heat
protection spray before blow drying.
■ For a quick touch-up between sham-
poos, mist hair to dampen it, then style
with dryer.
the hair is fully extended and taut. Run the
and set it to a high heat and speed.
dryer slowly down the length of the hair
Remove some of the additional moisture
several times until dry. Repeat with all
form your hair by briskly blowing it all
sections of hair until it is completely dried.
over, using your fingers to “comb”
Lock in the style with the Cool Shot.
through hair.
For curly hair:
Use dryer on a low heat and speed setting
4. When hair is almost dry, lower the heat
and speed to the desired settings and
and move it quickly about your head. As
begin to style.
you dry your hair, scrunch it with your
favorite styling product or twirl strands of
hair around your fingers to add definition.
5. Set ion switch to positive (+) styling ion
position. Divide hair into manageable
When finished drying, lock in the style with
sections. Begin at the nape of your neck
the Cool Shot.
and brush hair, following the movement
of the brush with the dryer. Continue
working your way up to your scalp, then
to the sides and the front, drying small
sections at a time.
RECOMMENDED SETTINGS
HAIR TYPE
Airflow
Heat
Short and Curly
Low
Low
Short and Sculptured
Mid-Length and Sculptured
Mid-Length and Sleek
High
Low
6. Once your desired style is achieved, push
the Cool Shot button to set the style with
a cool flow of air.
Low
High
Medium
Medium
High
Mid-Length or Long and Curly Low
Long and Sculptured
Long and Sleek
High
High
High
High
8
9
Download from Www.Somanuals.com. All Manuals Search And Download.
CS27326_3510is_IB_update 6/28/05 9:58 AM Page 10
Warranty
Cleaning and Maintenance
Full Two-Year Warranty
Spectrum Brands, Inc.
Maintenance Instructions
The dryer needs minimum maintenance to
ensure the best performance and long life.
Storage
Spectrum Brands, Inc. warrants this product
against any defects that are due to faulty
material or workmanship for a two-year
period from the original date of consumer
purchase. This warranty does not include
damage to the product resulting from
accident or misuse.
When not in use, unplug the unit. Allow it to
cool, and store out of reach of children in a
safe, dry location. Never wrap the cord
around the appliance, as this will cause the
cord to wear prematurely and break. Handle
cord carefully, and avoid jerking, twisting, or
straining it, especially at plug connections.
Money-back Offer
If within 30 days after you have purchased
your Remington® branded product, you are
not satisfied and would like a refund, return
it with the sales slip indicating purchase
price and date of purchase to the retailer
from whom it was purchased. Spectrum
Brands, Inc. will reimburse all retailers who
accept the product within 30 days from the
date of purchase. If you have any questions
concerning the money-back guarantee,
please call 800-736-4648.
■ Keep all intake openings clear of dust
accumulation. See “Cleaning Instructions”
below. No other maintenance or
lubrication is required.
If the product should become defective
within the warranty period, we will repair it
or elect to replace it free of charge. Please
call 800-736-4648.
■ If the cord becomes twisted due to use,
periodically straighten it. Store appliance
and cord where they will not be damaged.
Do not wrap cord around dryer.
125 VAC 60 Hz
■ Do not attempt to repair the appliance
yourself.
SPECTRUM BRANDS, INC. SHALL
NOT BE RESPONSIBLE FOR ANY
INCIDENTAL, SPECIAL OR
Questions or comments:
Call 800-736-4648
or visit www.remington-products.com
Cleaning Instructions
The air filter should be cleaned regularly,
since a dirty or clogged filter will impair the
efficiency of the dryer.
CONSEQUENTIAL DAMAGES.
This warranty gives you specific legal rights
and you may also have other rights which
vary from state to state. Some states do not
allow the exclusion or limitation
of incidental, special, or consequential
damages.
REMINGTON and PROTECT&SHINE
are trademarks of ROVCAL, INC.
1. To clean air filter, make sure dryer is
turned off and unplugged.
©2005 ROVCAL, INC.
06/05 Job# CS27326
Spectrum Brands, Inc.
800-736-4648
T2207838
2. Gently rotate the air inlet grille counter-
clockwise while lifting the air filter away
from the dryer.
MADE IN CHINA
This product is listed by
Underwriters Laboratories, Inc.
and bears the mark.
3. Use a soft bristle brush to gently remove
any particles that are lodged in filter.
4. If the unit is dirty, wipe it with a damp
cloth.
5. To replace the air inlet after cleaning,
align locking tabs and rotate clockwise
to secure.
10
11
Download from Www.Somanuals.com. All Manuals Search And Download.
CS27326_3510is_IB_update 6/28/05 9:58 AM Page 12
Download from Www.Somanuals.com. All Manuals Search And Download.
|