PPHP1594 PPHP1595
OWNER'S MANUAL
www pyleaudio com
Download from Www.Somanuals.com. All Manuals Search And Download.
PPHP1594 PPHP1595
ABOUT THE PPHP1594 PPHP1595
ABOUT THE PPHP1594 PPHP1595
Applications
Live sound reinforcement, speech and vocals, music playback in entertainment, A/V, and institutional venues -
especially when ease of use and portability are important factors.
Features
15" low-frequency driver with dual neodymium magnet for low-distortion and light weight.
Parallel Speakon connections allow daisychaining of a second speaker.
Integral 35mm pole mount receptacle with securing thumb screw.
Multi-angle enclosure for front of house or stage monitor application.
Extended low-frequency performance. Delivers powerful bass down to 40Hz.
Loudspeaker Placement and Mounting
The following guidelines will help you achieve optimum sound wherever you use your PPHP1594 PPHP1595 loud-
speakers:
Raise the speakers as high as possible. For best results try to get the high frequency horn at least 2 to 4 feet above the
heads of the audience. If the speakers are too low, the people in the back of the audience will not receive the best quality
of sound.
Place the speakers between the microphones and the audience. Feedback occurs when the microphones pick up sound
from the speakers and "feed" the sound back through the sound system. If space is limited, point the speakers away
from the microphones to reduce feedback.
Locate the speakers away from turntables. Low-frequency feedback occurs when the output of the speaker is picked up
by the tone arm of the turntable and is re-amplified. A heavy, solid turntable base and shock mounting can also reduce
this type of feedback in DJ applications.
Use more speakers in large or highly reverberant spaces. Spreading speakers throughout these spaces will produce
much better sound than trying to compensate with loudness level or equalization. For very long distances, the use of
another set of speakers on a delay is recommended.
Stand speakers upright for PA-Tilt the speakers back for stage monitoring. Upright stance Provides even Coverage over
a wide, PPHP1594 PPHP1595 speakers ane also designed with two slanted Positions for stage monitoring applications.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
PPHP1594 PPHP1595
TROUBLESHOOTING
TROUBLESHOOTING
What to do
Symptom
Likely Cause
Speaker not connected to
amplifier
Verify that speaker is connectedand that
the amp is on
No sound
Re-seat the cable at both ends.
Substitute a known-good cable
Speaker cable is faulty or
improperly connected.
Check VU meters on the source mixer
Verify that the tape or CD is playing.
Use headphones to verify that the
instrument is actually sending an
audio signal
Signal source(mixer, instrument,
etc.) Is not sending a signal.
NO sound. Speaker comes on.
Disconnect and re-seat signal cables.
Replace suspected cable with a
known-good cable
Faulty cables and connections
Excessive input signal, trying to
exceed the capabilities of the
speakers
Signal sounds distorted and very
loud.
Turn down the level controls on the
amplifier.
Use additional speakers.
Review the Owner's Manual for your
mixer and adjust controls as needed.
Input sensitivity (gain)
Signal sounds distorted even at
moderate volumes.
Mixer or other source is
overdriven
Channel faders
Master faders
Disconnect the devices that are connected
to your speaker one at a time. If the noise
goes away, the problem is with the source
or the connecting cable.
Noise or hiss heard at output
Noisy source device
Move the speakers so they do not point
the microphone's pickup pattern.
Microphones are pointed into the
speakers
Speakers feed back and howl when
the microphone volume is turned up
Locate the feedback frequency and reduce
it using an equalizer.
Equalizer settings art incorrect
Excessive gain
Reduce the gain at the mixer and move the
microphone closer to the sound source.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
PPHP1594 PPHP1595
SPECIFICATIONS
Specifications
• Rugged, Light-Weight Co-Polymer Enclosure
• Multi-angle enclosure for Front of House or Stage MonitorApplication
• Power Rating: 375W RMS 900W Peak
• Integral Frame 15'' Woofer w/Dual Neodymium Magnets
• 2'' Kapton VC
• 1'' Titanium Compression Driver, Ferro-Fluid Cooled
• Frequency Response (±3dB): 35Hz-20kHz
• 1W@1M SPL: 108dB
• Impedance: 8 Ohms
• Crossover Frequency: 2.8 KHz
• Inputs: Dual Speakon (Parallel)
• Integrated 35mm Speaker Mount
• Dimensions: 27.5''H x 17.5''W x 14.1''D
• Weight: 35.2 lbs.
Frequency Response
DBSPL
/1.0W/m
120
110
100
90
80
70
60
30
50
100
200 300
500
1K
2K
3K
5K
10K
20KHz
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Place
Stamp
Here
PYLE PRO Audio, Inc.
1600 63rd Street
Brooklyn, NY 11204
Download from Www.Somanuals.com. All Manuals Search And Download.
Thank you for purchasing this PYLE
product. To activate your
warranty, please mail this card
within 10 days.
Download from Www.Somanuals.com. All Manuals Search And Download.
|