4/9C["+P/9CNN"5RGCMGT
40-4094
OWNER’S MANUAL — Please read before using this equipment.
Your RadioShack 2-Way In-Wall Speaker
your speaker flush with the ceiling or wall,
making it ideal for unobtrusive use in a
surround-sound system. The frame and grille
can also be painted to match the room’s
decor.
"+/2146#06"
#
#
1
2
features a crossover, a 6 / -inch woofer for
rich lows, and a 1-inch tweeter for crisp
highs. The speaker can handle up to 100
watts of music power. The wing-type
mounting system makes it easy to mount
If an icon appears at the end of a paragraph, go
to the box on that page with the corresponding
icon for pertinent information.
— Warning
— Important
#
Rý
. — Caution
° — Hint
± — Note
+056#..#6+10
24'2#4+0)"6*'".1%#6+10
To mount your speaker, you need the
following items (not supplied, available at
your local RadioShack or online at
RadioShack.com).
24'2#4+0)"6*'"52'#-'4
If you choose to paint the frame and grille,
paint them and let them dry before you
connect the speaker wire or mount the
speaker.
• drywall or keyhole saw
• wire stripper
To remove the grille for painting, insert a
paper clip into one of the grille openings, then
pull up. Or, you can carefully twist the plastic
frame back and forth until the grille edge
becomes exposed, then lift the grille to
remove it.
• Phillips screwdriver
• pencil or marker
• 18–20 gauge speaker wire
1. Be sure the mounting surface is between
3
1
8
4-
/ inch and 1 / inch thick, with at least a
4
3
2 / -inch clearance behind the mounting
surface and no wall studs or other
objects to block the back of the speaker.
2. Remove the inner cardboard disc from
the supplied template/paint mask and
keep it for later. Use the outer portion as
a template to mark the cutout hole size
and location for mounting the speaker.
Carefully remove the dust cloth from behind
the grill and replace it after you are finished
painting.±
±"016'"±"
Do not paint the speaker element. We
recommend you spray-paint the grille so paint
does not block the holes.
You can also paint the frame to match your
wall or ceiling. To prevent paint from entering
the speaker, remove the grille and insert the
supplied cardboard paint mask. After the
paint is dry, remove the paint mask and
replace the grille.
Paint Mask
3. Use a drywall or keyhole saw to cut the
."%#76+10".
Be sure not to cut into any existing wiring or
hole..
plumbing hidden behind the wall.
%100'%6+0)"6*'"52'#-'4"9+4'5
Your local RadioShack store sells a wide
selection of speaker wire. We recommend
you use wire that is color-coded or marked on
one side to help you connect the wire
correctly.
2. Separate about 4 inches of speaker wire
at each end.
±"016'5"±"
1
/4 inch
•
•
Avoid routing the speaker wire near electrical
wires.
1. Route the speaker wire to the speaker
from the receiver.±
4 inches
Do not nail or staple the speaker wire.
© 2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
Download from Www.Somanuals.com. All Manuals Search And Download.
|