Step Three
Arm Cuff Blood
Pressure Monitor
63-1514
5. Fasten the cuff snugly, leaving at least a
finger’s room in between the cuff and your
arm.
Attaching the Arm Cuff
1. Roll up your sleeve to prevent constricting
circulation to your arm.
2. Insert the plug
at the end of
the tube into
the jack on the
left side of the
monitor.
Step One
Installing Batteries
1. Press the tab to lift up the battery compartment cover.
3. Sit upright on
6. Place your arm on the table so the cuff is at
the same height as your heart. Be sure the
inflation tube lines up with your arm
2. Insert four AA batteries (not supplied) into the compartment as
indicated by the polarity symbols (+ and –) marked inside.
the chair, and
with your palm
face up, thread
the cuff through your arm until it reaches
your biceps, just above your elbow.
Step Two
Setting the Date and Time
1. Press MODE. The month digit flashes.
4. Adjust the cuff so the inflation tube is on the
top of your arm as shown. Leave the cuff’s
bottom edge about 0.8 to 1.2 inches (2 – 3
cm) above the crease of your elbow.
2. Repeatedly press (or hold down) SET to set
the correct month.
3. Repeat Steps 1 and 2 to set the date, hour,
and minute.
4. Press MODE to complete setting.
3. Pull down the cover then press the cover down to snap it in
place.
What’s Included
• Auto Inflatable Arm Cuff
When the display dims or the batteries weaken,
display. Replace the batteries.
appears on the
!
Or
• Monitor
Step Four
Measuring Blood Pressure
Using an AC Adapter
• Carry Pouch
You can also power the blood pressure monitor using a 6V DC, 1A
AC adapter. To connect an AC adapter to the blood pressure moni-
tor, attach a size M Adaptaplug to the adapter with its tip set to
positive. Insert the adapter’s barrel plug into the monitor’s DC 6V
jack. Then plug the adapter into a standard AC outlet.
1. PressSTART/STOP. All display segments appear briefly and the monitor automatically inflates to
160 mmHg, or the necessary inflation level. The systolic rate decreases gradually, appears,
G
TM
Optional Accessories
• Body Fat Analyzer
and ♥ flashes at the same rate as your heartbeat.
2. Once your blood pressure is detected, the monitor deflates slowly. The blood pressure reading
and pulse rate appear. The air pressure in the arm cuff releases.
• Environizer
3. To stop the measurement at any time, press START/STOP.
• Rechargeable Batteries
• Battery Charger
appears briefly when:
#
• You do not wrap or position the cuff around your arm correctly.
• You talk or move the body during measurement.
• You have incorrect posture.
• The batteries become weak and
flashes.
!
Download from Www.Somanuals.com. All Manuals Search And Download.
|