Radio Shack Baby Toy 60 479 User Guide

1 2  
P LE A S E ! D O N O T R E T U R N T H IS  
P LE A S E ! D O N O T R E T U R N T H IS  
P R O D U C T T O A N Y R E TA IL S T O R E !  
P R O D U C T T O A N Y R E TA IL S T O R E !  
W e b Fsor ainty qeue:stiowns owr prowblem.sinwithttheis prroaducct ptleaisve ceontatctousyat:.c o m  
Email: info@interactivetoy.com  
Phone: Outside North America: +1 416 444 6873  
Inside North America: 1 866 214 2220  
Address: Interactive Toy Concepts  
Thank you for purchasing the MicroFighters, the worlds smallest and most progressive digital  
proportional radio control aircraft. To insure safe and reliable operation, please read the entire  
contents of this manual before removing the aircraft from its package.  
1192 Martin Grove Road  
Toronto, Ontario, Canada  
PACKAGE CONTENTS  
Please Note:  
MicroFighters is an advanced aircraft  
that uses sophisticated onboard technology  
unlike any found in similar aircrafts. Even  
experienced pilots should read the full contents  
of this manual carefully to receive the  
most from your flying experience.  
MicroFighters  
•Transmitter  
1PC  
1PC  
M9W 5M9  
Antenna  
1PC  
•Instruction manual  
Landing gear  
•Spare Propeller  
IMPORTANT SAFETY INFORMATION  
1PC  
1PC  
Do not touch the running propeller!  
Adult supervision is required!  
Do not modify your MicroFighters! Do not point the antenna directly at the plane! Do not use in strong winds, use only in  
VERY mild conditions! Do not use in rain, snow or around heavy debris! Do not use near electrical lines! Do not use around  
smoke or flames! Do not use around water! Do not use around electricity! Do not use in crowded areas! Do not use around  
air conditioning! Do not use around air vents! Do not use around ceiling fans! Do not use around large obstacles! Do not use  
in very small spaces! Do be conscious of changes in your area! Any changes or modifications to this product are strictly  
prohibited and will void product warranty. Keep moving propellers away from eyes, hands, hair and loose clothing. Always turn  
off your MicroFighters and transmitter when not in use. Always remove batteries from transmitter during storage. Always place  
transmitter with NEW alkaline batteries for optimal performance. Keep your Pilots manual in a safe place for future use. Only  
use the provided charger included with the MicroFighters to charge the lithium polymer battery installed in the MicroFighters.  
2PCS  
Parts Index  
4
6
7
MICROFIGHTERS  
TRANSMITTER  
5
1.Propeller  
4
1. Throttle control  
2. Steering control  
2.Horizontal tail  
3. Wing  
1
3
2
5
4.Charge port  
5.ON/OFF Switch  
3. Charging lead compartment  
4. Antenna  
IMPORTANT BATTERY INFORMATION  
5. Steering Trim knob  
6. Power LED Red”  
7. Charging LED Green”  
To prevent damage during  
shipping, your MicroFighters  
is securely fastened in the  
package. Please insure that  
all tie downs and fastening  
locations have been unfastened  
before attempting to remove the  
aircraft from its package.  
Use only batteries recommended in this instruction manual. Do not mix old and new batteries.  
Battery installation should be performed by an adult. Be careful to install the batteries with the correct polarity, as indicated.  
Do not use rechargeable batteries. Do not mix alkaline, standard, lithium, rechargeable, or different types of batteries.  
The supply terminals are not to be short-circuited. Exhausted batteries are to be removed as they will hinder performance.  
Never leave a battery unattended while it is being charged. Never leave a battery unattended in the presence of children.  
MicroFighters charging time will increase with usage as the condition of the AA cells diminish. Battery performance may  
greatly influence flight characteristics. MicroFighters Li-Po rechargeable battery is not replaceable.  
MicroFighters takes 6 AA battery (not included).  
8
8. ON/OFF switch  
1
2
3
BEFORE FLYING  
1. Use a Phillips head screw driver (cross head) to loosen  
FCC NOTE: U.S. ONLY  
screw and remove cover .  
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may  
not cause harmful interference. 2) This device must accept any interference received including interference that may cause  
undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible  
for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to  
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These Limits are designed to provide  
reasonable protection against harmful interference in a residential installation. This generates, uses and can radiate radio  
frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio  
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment  
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,  
the user is encouraged to try and correct the interference by one or more of the following measures: - Reorient or relocate the  
receiving antenna - Increase the separation between the equipment and receiver - Connect the equipment to an outlet on a  
circuit different from that to which the receiver is connected - Consult the dealer or an experienced radio/TV technician for help.  
2. Insert 6AA batteries in the correct polarity as indicated  
inside the battery door cover.  
3. Place cover back and re-tighten screw .  
4. Screw antenna in place.  
CHARGING THE MICROFIGHTERS  
1. Make sure the power switch of the MicroFighters is  
in the OFF position. NOTE: Always switch OFF the plane  
after flying!  
2. Make sure the controller antenna is collapsed to avoid  
breaking it while not flying and to prevent accidentally  
interfering with another RC aircraft on the same frequency.  
3. Remove the charge lead on the transmitter and  
insert it into the charge port on the MicroFighters.  
NOTE: Always insure you insert the charge lead using the correct orientation.  
4. Turn the transmitter switch to the ON position.  
5. Green LED will blink indicating plane is now being charged.  
6. Charge the MicroFighters fully which typically takes about 30 min.  
Industry Canada Notice: Canada only.  
This radiocommunication device complies with all the requirements of Industry Canada Standard RSS-310.  
Operation is subject to the following two conditions: 1) This device may not cause harmful interference.  
2) This device must accept any interference received, including interference that may cause undesired operation.  
Field Strength and measurement distance: 27.145MHz – 54.95 dBV/m at 3 meters. 49.860MHz - 63.86 dBV/m at 3 meters.  
7. Green LED will stop blinking and light steadily, indicating that the plane is fully charged.  
8. Remove lead and place back inside storage compartment.  
9. Turn transmitter OFF.  
Limited 30-day warranty  
This product is warranted by Interactive Toy Ltd. against manufacturing defects in material and workmanship  
under normal use for thirty (30) days from the date of purchase. Please retain proof of purchase.  
10. If you forget to turn off the transmitter and are not moving the control sticks, after 3 minutes  
the red LED will start blinking to remind you to turn it off!  
AirRage Series and MicroFighters are registered  
NOTE: The MicroFighters will enter sleep mode if idle over 3 minutes. To "wake up", power off both your  
Microfighters and the transmitter, and then turn on again. If battery is low the green LED will blink.  
trademarks of Interactive Toy Concepts © 2009  
Lithium Polymer  
All rights reserved. Manufactured by and distributed  
Rechargeable Batteries  
by Interactive Toy Concepts Ltd.  
must be recycled or  
TIP: Unlike other types of rechargeable batteries, Lithium Polymer rechargeable batteries do not require a full charge for operation.  
However it is necessary to FULLY charge on the first flights for best results. *Shorter Charges = Shorter Flight Times.  
Precaution: This product is design to operate in altitude below 4000ft! If the operation geographic environment is over the designed altitude,  
Products and colors may vary.  
disposed of properly.  
MADE IN CHINA.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
the flight time may shorten and the product may not function correctly.  

Radio Shack Clock Radio 63 968 User Guide
Radio Shack Motorized Toy Car 60 1241 User Guide
RCA Portable CD Player RP2910 User Guide
Roland Lawn Mower KR 3 User Guide
Rosewill Computer Drive RC503 User Guide
Ryobi Brush Cutter RY30570 User Guide
Samsung Projection Television HC P4241W User Guide
Sangean Electronics Radio 180 User Guide
Sanus Systems Automobile Electronics VLT14 User Guide
Screenlife Video Games Twilight User Guide