SAFeTy PrecAuTionS
SySTeM connecTionS
LocATion oF conTroLS
uSer MAnuAL
on Safety
using FM and AM Antennas
Front View
1
rear View
As the laser beam used in this compact disc player could be harmful to the eyes, do not attempt
to disassemble the casing. Refer servicing to qualified personnel only.
Do not put any foreign objects in the disc compartment. If you do so, the laser beam interlock
may be defeated allowing the laser to remain on when the lid is opened.
Should any objects or liquids fall into the unit, disconnect the power supply and have the unit
checked by qualified personnel before any further operation.
Uncoil the FM antenna at the back of the unit, make sure it is fully extended. You’ll also
need to connect the AM loop antenna to the back of the unit if you listen to AM stations.
Rotate the AM loop antenna for better reception.
rS2696i
•
2
3
4
12
Speaker connections
Connect the right speaker to the R (R+ & R-) terminals and the left speaker to the L (L+ & L-)
•
13
14
terminals.
on operation
5
6
7
8
9
note: Connecting speakers other than the speakers supplied with the unit may damage
15
Since the CD system offers a wide dynamic range, the peaks of the high level inputs are recorded
with high fidelity, and the noise level is very low. Do not turn up the volume while listening to a part of
the disc with no audio signals or very low level inputs. If you do so, the speakers may be damaged
when the peak level of the sound is played. The lens of the laser should be kept clean. Do not touch
the lens. If you do so, the lens may be damaged and the unit will not operate correctly.
20
21
the unit.
16
17
18
AM loop
antenna
19
10
on use
RIGHT
SPEAKER
BOX
LEFT
SPEAKER
BOX
22
23
Never use the unit where it would be subject to:
Heat sources such as radiators or air ducts.
-
-
-
-
-
-
11
Direct sunlight.
Excessive dust.
Moisture or rain.
Red(+) and Black(-)
Mechanical vibration or shock.
Red(+) and Black(-)
Uneven surface.
1.
2.
3.
4.
5.
6.
cD Door
PLAy/PAuSe button
13.
oPen / cLoSe button
L
• Do not place any heavy objects on top of the unit.
• when the unit is used with an AC power plug, do not wrap the unit in a cloth, blanket, etc.
If you do so, the temperature inside and outside the unit may rise considerably, resulting in
malfunctioning of the unit.
• If the unit is brought directly from a cold to a warm location, or is placed in a very damp room,
the moisture may condense on the lens inside the unit. Should this occur, the unit will not
operate. In this case, remove the disc and leave the unit in a warm place for several hours
until the moisture evaporates.
• For the unit to operate at its best, it should not be subject to temperatures below 41°F (5°C)
or above 95°F (35°C).
Additional safety information
Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids,
such as vases, shall be placed on the apparatus.
Always leave sufficient space around the product for ventilation. Do not place product in or
on a bed, rug, in a bookcase or cabinet that may prevent air flow through vent openings.
Do not place lighted candles, cigarettes, cigars, etc. on the product.
Connect power plug only to AC power source as marked on the product.
Care should be taken so that objects do not fall into the product.
Do not attempt to disassemble the cabinet. This product does not contain customer
serviceable components.
14. Standby indicator
15. TiMer indicator
16. remote Sensor
17. ProG / MeM /
TuninG + /
TuninG - /
LcD Display
button
button
To AC
outlet
It’s important to read this instruction prior to using your new product for the
first time.
button
button
FuncTion button
18. MeM.uP /
cAuTionS:
19. AuX in Jack
20. AM Antenna Terminal
21. FM Antenna
22. right & Left Speaker Terminals
23. Ac Power cord
•
•
•
Ensure that the mains supply in your house complies with that indicated on the
identification sticker located on the back of your unit. (AC 120V ~ 60Hz)
7.
8.
9.
10.
STAnDby/on button
PreSeT eQ button
VoLuMe (- / +) Knob
earphone Jack
SAFeTy PrecAuTionS
If you are not going to use the unit for a long time, disconnect the AC power plug from
the wall outlet.
This unit is designed for continuous use. Switching off the unit to standby mode does
not disconnect it from the mains supply. To completely isolate the equipment, remove
the plug from the mains jack as some components remain connected to the electrical
supply.
11. iPod Docking
12. SToP / bAnD button
•
•
VoLuMe ADJuSTMenT
To Adjust the Volume
Adjust the VOLUME levels to obtain the desired volume.
•
•
•
•
reMoTe conTroL
*SEE MARKING ON REAR OF PRODUCT*
The lightning flash with an arrowhead symbol, within the equilateral triangle, is intended
to alert the user to the presence of uninsulated “dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude to cause an electric shock.
1
For Personal Listening
Connect headphones (Ø3.5mm stereo mini plug) to the
1.
PreSeT eQ button
Precautions
earphone
2.
3.
on / STAnDby button
SLeeP button
•
This compact disc player uses a laser to read the music on the disc. The laser mechanism
corresponds to the cartridge and stylus of a record player. Although this product incorporates
a laser pick-up lens, it is completely safe when operated according to directions.
Discs rotate at high speed inside the player. Do not use damaged, warped, or cracked discs.
Do not touch the pick-up lens which is located inside the disc compartment. To keep dust
from collecting on the pick-up lens, do not leave the compartment door open for an extended
period of time. If the lens becomes dirty, clean it with a soft brush, or use an air blower brush
designed for camera lenses.
jack. Adjust the VOLUME levels to obtain the desired volume.
When headphones are connected, the speakers are automatically muted.
Warning: Excessive sound pressure from earphone and headphones can cause hearing
loss.
8
2
3
4
5
6
The exclamation point within the equilateral triangle is intended to alert the user to
the presence of important operating and maintenance (servicing) instructions in this
user manual.
4.
ProG / MeM /
ProG / MeM /
rAnDoM button
button (same as
button on the unit)
9
•
•
10
5.
6.
7.
8.
9.
•
•
•
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN OR
MOISTURE.
TO AVOID ELECTRICAL SHOCK, DO NOT OPEN THE CABINET. REFER SERVICING TO
QUALIFIED PERSONNEL ONLY.
THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING AND THAT
NO OBjECTS FILLED wITH LIQUID, SUCH AS VASES, SHALL BE PLACED ON THE
APPARATUS.
11
12
MeM.uP /
button
cLocK SeTTinG
Setting the clock can only be done in STANDBY mode.
If the unit is plugged in with the supplied AC power plug and the unit is in standby
mode, the standby indicator illuminates.
SToP / bAnD button
FuncTion button
TiMer button
Headset safety
•
Have a Blast-just Not in your eardrums! Make sure you turn down the volume on the
unit before you put on headphones. Increase the volume to the desired level only after
headphone are in place.
Do not play your headset at high volume. Hearing experts warn against extended high-
volume play.
If you experience ringing in your ears, reduce volume or discontinue use.
You should use with extreme caution or temporarily discontinue use in potentially hazardous
situations. Even if your headset is an open-air designed to let you to hear outside sounds, do
not turn up the volume so high that you are unable to hear what is around you.
Excessive sound pressure from earphones and headphone can cause hearing loss.
•
10. DiSPLAy button
11. buttons
12. VoLuMe + / - buttons
13. PLAy / PAuSe button
/
13
7
•
AM
1. Press and hold the ProG/MeM/
button until the hour digits
DO NOT TOUCH THE LENS
CAUTION: INVISIBLE LASER RADIATION
CLASS 1 LASER PRODUCT
blink.
•
•
APPAREIL À LASER DE CLASSE 1
wHEN OPEN AND INTERLOCK FAILED OR
PRODUCTO LASER DE CLASE 1
DEFEATED
AVOID EXPOSURE TO BEAM
PRODUTO LASER CLASSE 1
using the remote control correctly
2. Tap the
or
button to adjust the desired hours then tap the
button once to confirm. The minute digits will begin
•
•
•
Point the remote control at the REMOTE SENSOR located on the unit.
when there is a strong ambient light source, the performance of the infrared REMOTE
SENSOR may be degraded, causing unreliable operation.
ProG/MeM/
to blink.
AM
Double insulation when servicing use only
This product contains a low
identical replacement parts.
power laser device.
iMPorTAnT SAFeTy inSTrucTionS
•
The recommended effective distance for remote operation is about 19 feet (6 meters).
Fcc information
To change battery
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
3. Tap the
or
button to adjust the desired minutes then tap the
button once to start clock.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
ProG/MeM/
AM
(1) This device may not cause harmful interference, and
ATTenTion
1. Open the battery door.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Remove the plastic sheet
before operating the remote
control.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized
plug has two blades with one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wide blade or the third prong are provided for
your safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protectthepowerplugfrombeingwalkedonorpinchedparticularlyatplugs,convenience
receptacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightening storms or when unused for a long period of
time.
noTe: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
AM
12:00 PM = NOON time, and “PM” appears.
2. Insert one CR2025 (3V) size battery.
notes:
•
•
During CD playback, press the DiSPLAy button once to display the current time.
In RADIO mode, press the DiSPLAy button once to display the current time.
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
WArninG: Changes or modifications to this unit not expressly approved by the party responsible
LiSTeninG To THe rADio
•
1. Press the
STAnDby/on button to turn the unit on.
2. Press the FuncTion button to Tuner mode.
3. Press the SToP/bAnD button to select a band (FM/AM).
button to tune in to a station.
5. Adjust the volume levels.
for compliance could void the user’s authority to operate the equipment.
battery replacement
For customers in canada
When the battery becomes weak, the operating distance of the remote control is greatly
reduced and you will need to replace it.
This apparatus complies with the Class B limits for radio noise emission set out in radio interference
4. Press the
or
regulations.
note: If the remote control is not going to be used for a long time, remove the battery to
avoid damage caused by battery leakage corrosion.
14. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as the power-supply cord or plug is damaged, liquid has
spilled or objects have fallen into the apparatus, the apparatus
hasbeenexposedtorainormoisture,doesnotoperatenormally,
or has been dropped.
This Class B digital apparatus complies with Canadian ICES-003.
Searching for a Station Automatically
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
WArninGS:
•
Press and hold the
or
button until the tuner starts searching for a station, then
Warnings:
•
•
•
•
Do not dispose of battery in fire; battery may explode or leak.
Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
release. After tuning in a station, the search stops.
The search may not stop at a station with a very weak signal.
The AC power plug is used as disconnect device and it should remain readily operable during
intended used. In order to disconnect the apparatus from the mains completely, the AC power
plug should be disconnected from the mains socket outlet completely.
Minimum 10 cm (4 inches) distances around the apparatus for sufficient ventilations.
The ventilation should not be impeded by covering the ventilation openings with items such as
newspaper, table-cloths, curtains, etc.
•
Portable Cart Warning
•
•
cAuTion: When discarding batteries, environmental problems must be considered and
local rules or laws governing the disposal of these batteries must be strictly followed.
•
No naked flame sources such as lighted candles should be placed on the apparatus.
- 1 -
- 2 -
- 3 -
- 4 -
Download from Www.Somanuals.com. All Manuals Search And Download.
|