SAFETY PRECAUTIONS
Warnings:
The AC adapter is used as disconnect device and it should remain readily
operable during intended used. In order to disconnect the apparatus from
the mains completely, the AC adapter should be disconnected from the
mains socket outlet completely.
Minimum 10 cm (4 inches) distances around the apparatus for sufficient
ventilations.
Batteries shall not be exposed to excessive heat such as sunshine, fire or
the like.
Theventilationshouldnotbeimpededbycoveringtheventilationopenings
with items such as newspaper, table-cloths, curtains, etc.
No naked flame sources such as lighted candles should be placed on the
apparatus.
SAFETY PRECAUTIONS
SYSTEM CONNECTIONS
Speaker Connections
Connect the right speaker to the R terminal and the left speaker to the
L terminal.
USER MANUAL
FCC Information
•
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
RS2128i
Digital Music Studio
with universal dock for iPod
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Note: Connecting speakers other than the speakers supplied with the
unit may damage the unit.
•
•
•
•
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
RIGHT
SPEAKER
BOX
LEFT
SPEAKER
BOX
On Safety
As the laser beam used in this compact disc player could be harmful to the
eyes, do not attempt to disassemble the casing. Refer servicing to qualified
personnel only.
To AC
outlet
•
•
•
Reorient or relocate the receiving antenna.
•
Do not put any foreign objects in the disc compartment. If you do so, the
laser beam interlock may be defeated allowing the laser to remain on when
the lid is opened.
Do not put any foreign objects in the DC IN jack. Should any objects or
liquids fall into the unit, disconnect the power supply and have the unit
checked by qualified personnel before any further operation.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
To “DC IN 13.5V” jack
AC adapter
•
•
Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to operate
the equipment.
On Operation
Since the CD system offers a wide dynamic range, the peaks of the high level
inputs are recorded with high fidelity, and the noise level is very low. Do not
turn up the volume while listening to a part of the disc with no audio signals
or very low level inputs. If you do so, the speakers may be damaged when the
peak level of the sound is played. The lens of the laser should be kept clean.
Do not touch the lens. If you do so, the lens may be damaged and the unit will
not operate correctly.
For the Customers in Canada
Using the AC Adapter
This apparatus complies with the Class B limits for radio noise emission set out
in radio interference regulations.
Using an AC adapter other than the one supplied with the unit may
damage the unit. This AC adapter operates on AC 100-120V~50/60Hz.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
CAUTIONS:
•
•
•
•
Before use, ensure the rated voltage of the adapter matches your
local voltage.
The included AC adapter is for use with this unit only. Do not use it
with other equipment.
If you are not going to use the unit for a long time, disconnect the
AC adapter from the wall outlet.
Whenever the AC adapter is plugged in to a wall outlet, electricity is
running through the unit, even when the power switch is turned off.
On Use
Never use the unit where it would be subject to:
-
-
-
-
-
-
Heat sources such as radiators or air ducts.
Direct sunlight.
Excessive dust.
This product contains a
low power laser device.
Moisture or rain.
Mechanical vibration or shock.
WARNING:
Uneven surface.
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSETHE UNITTO RAIN
OR MOISTURE.
• Do not place any heavy objects on top of the unit.
• When the unit is used with an AC power adapter, do not wrap the unit in
a cloth, blanket, etc. If you do so, the temperature inside and outside the
unit may rise considerably, resulting in malfunctioning of the unit.
• If the unit is brought directly from a cold to a warm location, or is placed
in a very damp room, the moisture may condense on the lens inside the
unit. Should this occur, the unit will not operate. In this case, remove the
disc and leave the unit in a warm place for several hours until the moisture
evaporates.
FM ANTENNA
TO AVOID ELECTRICAL SHOCK, DO NOT OPEN THE CABINET. REFER
SERVICING TO QUALIFIED PERSONNEL ONLY.
THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING
AND THAT NO OBJECTS FILLED WITH LIQUID, SUCH AS VASES, SHALL BE
PLACED ON THE APPARATUS.
•
Do not connect the FM antenna to an outside antenna.
It's important to read this instruction prior to using your new product
for the first time.
• Fortheunittooperateatitsbest, itshouldnotbesubjecttotemperatures
below 41°F (5°C) or above 95°F (35°C).
- 1 -
- 2 -
- 3 -
REMOTE CONTROL
LOCATION OF CONTROLS
CLOCK SETTING
LISTENING TO THE RADIO
Setting the clock can only be done in STANDBY mode.
1
1.
2.
3.
4.
5.
6.
7.
8.
9.
PRESET EQ Button
ON/STANDBY Button
SLEEP Button
PROG/MEM/ Button
RANDOM Button
Unit
1. Press the
unit on.
2. Press the FUNCTION button to radio mode.
3. Press the BAND/ STOP button to select a band
(AM/FM).
4. Press the
STANDBY/ON button to turn the
•
If the unit is plugged in with the supplied AC adapter and the unit is
in standby mode, the standby indicator illuminates.
1
10
8
9
10
2
3
4
5
11
12
13
14
15
2
3
1. Press and hold the PROG/MEM/ button until
22
23
21
4
5
6
the hour digits blink.
11
MEM.UP /
Button
16
or
button to tune in to a station.
BAND / STOP Button
FUNCTION Button
TIMER Button
17
18
5. Adjust the volume levels.
12
13
7
8
9
6
7
19
Searching for a Station Automatically
10. DISPLAY Button
11. Button
12. VOLUME +/- Buttons
13. PLAY/PAUSE Button
•
Press and hold the
for a station, then release. After tuning in a station, the search
stops.
or
button until the tuner starts searching
2. Tap the
or
button to adjust the desired
/
20
hours then tap the PROG/MEM/ button
once to confirm. The minute digits will begin to
blink.
•
The search may not stop at a station with a very weak signal.
Using the Remote Control Correctly
Presetting Stations
1. CD Door
2. LCD Display
3. MEM.UP/ Button
13. Remote Sensor
14. BAND / Button
•
•
Point the remote control at the REMOTE SENSOR located on the unit.
Whenthereisastrongambientlightsource,theperformanceoftheinfrared
REMOTE SENSOR may be degraded, causing unreliable operation.
The effective maximum distance for remote operation is approx. 19
feet (6 meters).
The unit can store a total of 20 stations in memory (10FM, 10AM).
Presetting allows you to tune in to a station directly.
15.
16.
PLAY/PAUSE Button
/ TUNING + Button
1. Tune in to a desired station.
4.
5. FUNCTION Button
6. Earphone Jack
STANDBY/ON Button
•
3. Tap the
or
button to adjust the desired
2. Press the PROG/MEM/ button. The preset number will blink and
the“MEM”indicator will be shown on the display.
3. Press the MEM.UP/ button to select the preset number.
4. Press the PROG/MEM/ button again to store it in memory.
5. Repeat steps 1-4 to store other stations.
17. AUX IN Jack
18. SLEEP Button
minutes then tap the PROG/MEM/
once to start clock.
button
To Change Battery
7. DISPLAY Button
8. PROG/MEM/ Button
9. - VOLUME + Buttons
10. OPEN Knob
11. STANDBY Indicator
12. TIMER Indicator
19.
/ TUNING - Button
ATTENTION
1. Open the battery door.
20. iPod Docking
21. DC IN 13.5V Jack
22. Right & Left Speaker Terminals
23. FM Antenna
Remove the plastic sheet
before operating the
remote control.
12:00 PM = NOON time, and“PM”appears.
Tuning in to a Preset Station
Press the BAND/ STOP button to select AM or FM then press the MEM.
2. Insert one CR2025 (3V) size battery.
UP/
button to select a preset number.
Notes:
For Better Reception
•
During CD playback, press the DISPLAY button
once to display the current time.
FM: Fully unwind the antenna wire. Extend the antenna wire and place it
in the position that sounds best.
•
In RADIO mode, press the DISPLAY button once
to display the current time.
VOLUME ADJUSTMENT
Note: Do not connect the FM antenna to an outside antenna.
AM: Reposition the unit to get better AM reception.
Notes:
Battery Replacement
When the battery becomes weak, the operating distance of the remote
To Adjust the Volume
control is greatly reduced and you will need to replace it.
Note: If the remote control is not going to be used for a long time, remove
the battery to avoid damage caused by battery leakage corrosion.
Use the - VOLUME + buttons to adjust the VOLUME levels.
•
When the reception is good, the “STEREO” indicator will appear on
the display.
For Personal Listening
•
To prevent interference to the AM signal, please keep the AC adapter
3.17 feet (1 meter) away from the main unit.
WARNINGS:
Connect headphones (Ø3.5mm stereo mini plug) to the PHONES jack.
Adjust the VOLUME levels to obtain the desired volume.
•
•
Do not dispose of battery in fire; battery may explode or leak.
Battery shall not be exposed to excessive heat such as sunshine, fire
or the like.
When headphones are connected, the speakers are automatically
disconnected.
•
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type.
CAUTION: When discarding batteries, environmental problems must
be considered and local rules or laws governing the disposal of these
batteries must be strictly followed.
- 4 -
- 5 -
- 6 -
- 7 -
811-622891W080 ENGLISH.indd
1
5/6/2009 11:08:05
Download from Www.Somanuals.com. All Manuals Search And Download.
|