V2.0 (en)
safety precautions
safety precautions
WARNING: the apparatus shall not Be eXposed to dripping FCC information
the following markings and symbols are located on the back of the unit.
user Manual
this device complies with part 15 of the FCC Rules. Operation is subject
or splashing and that no oBJeCts Filled with liQuids,
suCh as Vases, shall Be plaCed on the apparatus.
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
this product
contains a low
laser device.
CLASS 1 LASER PRODUCT
APPAREIL À LASER DE CLASSE
1
PRODUCTO LASER DE CLASE
PRODUTO LASER CLASSE 1
1
CAUTION:
this equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. this equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
however, there is no guarantee that interference will not occur in a
particular installation. if this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
use oF Controls or adJustments or perFormanCe oF
proCedures other than those speCiFied may result in
haZardous radiation eXposure.
RS2693
WARNING: SHOCK HAZARD-DO NOT OPEN
the symbol for Class ii
(Double Insulation)
AVIS: RISQUE DE CHOC ÉLECTRIQUE-
NE PAS OUVRIR
ON SAFETY
the lightning flash with an arrowhead symbol, within the
equilateral triangle, is intended to alert the user to the presence
of uninsulated "dangerous voltage" within the product's enclosure
that may be of sufficient magnitude to cause an electric shock.
•
Before operating, make sure the voltage requirement of the mains
plug matches your local voltage.
•
disconnect the mains plug immediately if liquid spills into or onto the
unit, or if an object falls into the unit. the unit should not be used until
service by a qualified service personnel is completed.
do not open the cabinet. lasers used in rays employed by the unit
may damage your eyes. Any servicing should be done by qualified
service personnel.
the exclamation point within the equilateral triangle is intended
to alert the user to the presence of important operating and
maintenance (servicing) instructions in this owner’s manual.
•
•
•
•
•
reorient or relocate the receiving antenna.
increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
when you are not going to use the unit for a long period of time,
disconnect the mains plug.
CAUTION :
Invisible laser radiation when open and interlock failed or
defeated. Avoid direct exposure to beam.
•
Consult the dealer or an experienced radio / tV technician for help.
ON PLACEMENT
ATTENTION :
Radiation invisibles du laser en cas d'ouverture et de
•
do not leave, mount or use the unit in places which are extremely hot,
cold, dusty, or humid.
this Class B digital apparatus complies with Canadian iCes-003.
défaillance ou de mise hors service du dispositif de
verrouillage. Eviter toute exposition directe au faisceau.
DO NOT
TOUCH THE LENS.
•
allow adequate air circulation to prevent internal heat build-up. do
not place the unit on a surface or near materials (a curtain ex. rugs,
blankets, curtains, etc.) which might block the ventilation holes.
WARNING: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user's authority to
operate the equipment.
WARNING: ConneCting speakers other than the speakers
supplied with the unit, may damage the unit.
ON CONDENSATION
For your safety
•
when left in a heated room where it is warm and damp, water droplets
or condensation may form inside the Cd player. when there is
condensation inside the unit, the unit may not function normally. let it
stand for 1 to 2 hours before turning the power on, or gradually heat
the room and allow the unit to dry before use.
the aC power plug is polarized (one blade is wider than the
other) and only fits into AC power outlets one way. If the plug
won't go into the outlet completely, turn the plug over and try
to insert it the other way. If it still won't fit, contact a qualified
electrician to change the outlet, or use a different one. do
not attempt to bypass this safety feature.
CAUTION: to reduCe the risk oF Fire or eleCtriC shoCk, do
not remoVe CoVer (or BaCk). no user-serViCeaBle parts
inside. reFer to QualiFied serViCe personnel.
WARNING: to preVent Fire or shoCk haZard, do not
eXpose this applianCe to rain or moisture.
it's important to read this instruction prior to using your new product for
the first time.
- 1 -
- 2 -
- 3 -
service information
Before you Begin
important safety instructions
some of the following information may not apply to your particular product; however, as with any electronic product, precautions
Useful Advice
For your records
should be observed during handling and use.
•
do not use your system immediately after transporting it
from a cold place to a warm place, as condensation may
cause the system to malfunction. if moisture forms inside
this system, it may not operate properly. to correct the
problem, turn off the power and wait about 30 minutes for
moisture to evaporate.
in the event that service should be required, you may need the
model number. in the space below, record the date and place
of purchase:
•
•
•
•
•
•
•
•
read these instructions.
keep these instructions.
heed all warnings.
Follow all instructions.
model no.
date of purchase
place of purchase
do not use this apparatus near water.
Clean only with a dry cloth.
do not block any ventilation openings. install in accordance with the manufacturer’s instructions.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (Including amplifiers) that
produce heat.
•
•
•
This system is fitted with a laser. To avoid accidents, it is to
be opened by qualified technicians only.
never leave the tray open as dust could cover the laser lens
and / or the tray could be bumped into accidentally.
do not palce the system near wet areas such as bathrooms
and pool inside. avoid storing the system at humid places or
near abnormally heated areas.
Service information
this product should be serviced only by those specially trained
in appropriate servicing techniques. For instructions on how to
obtain service, refer to the warranty included in this guide.
•
do not defect the safety purpose of the polarized or grounding-type plug. a polarized plug has two blades with one wider than
the other. a grounding type plug has two blades and a third grounding prong. the wide blade or the third prong is provided for
your safety.
•
•
main plug is used as the disconnected device, it shall remain
operable and should not be obstructed during intended use.
to be completely disconnected the apparatus from supply
mains, the main plug of the apparatus shall be disconnected
from the mains socket outlet completely.
ensure minimum distance around the apparatus for
sufficient ventilation. The ventilation should not be impeded
by covering the ventilation openings with items, such as
newspaper, etc.
No naked flame source, such as lighted candles, should be
placed on the apparatus.
when you are not going to use the unit for a long period of
time, disconnect the aC power cord.
If the provided plug does not fit into your wall outlet, consult an electrician for replacement of the obsolete outlet.
protect the power cord from being walked on or pinched particularly
at plugs, convenience receptacles, and the point where they exit from the apparatus.
Only use attachments / accessories specified by the manufacturer.
Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus.
when a cart is used, use caution when moving the cart / apparatus combination to avoid injury from tip-over.
•
technical information
•
•
technical information
product: Cd micro system
Band: rCa
model: rs2693
Power Supply: AC 120V ~ 60Hz
Portable Cart
Warning
•
•
•
•
•
unplug this apparatus during lightning storms or when unused for long periods of time.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way,
such as the power cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate normally, or has been dropped.
excessive sound pressure form earphones and headphones
can cause hearing loss.
- 4 -
- 5 -
- 6 -
system Connections
general Controls
3.
Stop Button
press to stop playing a disc while in Cd mode.
Rear Panel
Front Panel
1. CONNECTING THE SPEAKERS
Connect the wires from the left & right speaker to the corre-
sponding speaker terminals.
Note: Connecting speakers other than the speakers
supplied with the unit, may damage the unit.
4. POWER ON Indicator
11
12
1
2
3
indicates when the unit is on.
5. PROG (Program) Indicator
when lit, it indicates that the unit is in programmable
playback mode.
6. Radio Frequency Indicator
displays the current frequency selected.
7. Function Selector (STANDBY·TUNER·AUX·CD)
8. Headphone Jack
13
14
15
4
5
6
7
16
RIGHT
SPEAKER
LEFT
SPEAKER
9.
Play / Pause Button
press to start / pause playing a disc while in Cd mode.
20
8
9
17
18
1
10. Tuning Knob
rotate this knob to tune in the desired station.
11. CD Drawer
10
21
22
2
19
12.
Skip / Search
Button
13. Remote Sensor
14. CD Display
15. Repeat Indicators (REPEAT ONE / REPEAT ALL)
16. Radio Band Switch (AM·FM)
17. LINE-IN Jack
To AC Wall
Outlet
2. CONNECTING THE AC POWER CORD
Connect the aC power cord into a wall outlet.
23
Connect the cable from external audio equipment to this
jack.
1.
REPEAT Button
press to repeat one track / all tracks.
2. PROG (Program) Button
note:
20. FM Antenna
18. Open / Close Button
press to open / close the disc door.
19. Volume Control Knob
•
to prevent electric shock, match wide blade of aC power
cord to wide slot of aC power outlet, then fully insert.
when you are not going to use the unit for a long period
of time, disconnect the aC power cord.
21. Right Speaker Connector
22. Left Speaker Connector
23. AC Power Cord
press to combine your favorite tracks and play them in the
order you define.
•
rotate this knob to adjust the volume.
Connect the aC power cord to the wall outlet.
- 9 -
- 7 -
- 8 -
- 10 -
remote Control
radio operations
ATTENTION
Remote Control (Only for CD Function)
1. slide the FunCtion selector to tuner.
the power on indicator lights up.
2. slide the Band selector to desired band (am/Fm).
• Remove the protective plastic tab before operating the remote
control.
BAND
3
TUNER
AUX
AM
FM
4
5
6
1
2
STANDBY
CD
• To change battery
1. Open the battery door.
4. adjust the volume level.
3. tune into a station.
2. insert one Cr2025 (3V) size battery.
1. Skip / Search
Button
2. PROG (Program) Button
3. Play / Pause Button
- TUNING +
- VOLUME +
4. Skip / Search
5. Stop Button
Button
BATTERY REPLACEMENT
6.
REPEAT Button
FOR BETTER RECEPTION
when the battery becomes weak, the operating distance of the
rotate the unit to get the best
receiving position.
remote control is greatly reduced and you will need to replace
it.
USING THE REMOTE CONTROL CORRECTLY
• Point the remote control at the REMOTE SENSOR located on
the unit.
• When there is a strong ambient light source, the performance
of the remote’s infrared may be degraded, causing unreliable
operation.
Fully unwind the wire antenna.
then extend the wire antenna
and place it in the position that
sounds best.
(when the Fm broadcast signal
is strong, it can receive Fm
stereo Broadcast.)
CAUTION: danger of explosion if battery is incorrectly
replaced. replace only with the same or equivalent type.
NOTE: DO NOT CONNECT
TO AN OUTSIDE ANTENNA.
WARNING: Battery should not be exposed to heat such as
sunshine, fire or the like.
• The operating range for remote operation is approximately 13
feet (4 m).
AFTER LISTENING, slide the FunCtion selector to standBy.
- 13 -
- 11 -
- 12 -
Download from Www.Somanuals.com. All Manuals Search And Download.
|