RCA Headphones RS27116I User Guide

Safety Precautions  
This Class B digital apparatus complies with Canadian ICES-003.  
Cet appareil numérique de la classe B est conforme à la norme NMB-003  
du Canada.  
Safety Precautions  
System Connections  
Speaker Connections  
Connect the right speaker to the R terminal and the left speaker to the  
L terminal.  
USER MANUAL  
FCC Information  
This device complies with Part 15 of the FCC rules. Operation is subject to the  
following two conditions:  
Digital Music Studio  
with universal dock for iPod  
RS27116i  
Warnings:  
(1) This device may not cause harmful interference, and  
(2) This device must accept any interference received, including interference  
that may cause undesired operation.  
NOTE: Connecting speakers other than the speakers supplied with the  
unit may damage the unit.  
The AC adapter is used as disconnect device and it should remain readily  
operable during intended used. In order to disconnect the apparatus from  
the mains completely, the AC adapter should be disconnected from the  
mains socket outlet completely.  
NOTE: This equipment has been tested and found to comply with the limits  
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits  
are designed to provide reasonable protection against harmful interference  
in a residential installation. This equipment generates, uses, and can radiate  
radio frequency energy and, if not installed and used in accordance with  
the instructions, may cause harmful interference to radio communications.  
However, there is no guarantee that interference will not occur in a particular  
installation. If this equipment does cause harmful interference to radio or  
television reception, which can be determined by turning the equipment off  
and on, the user is encouraged to try to correct the interference by one or more  
of the following measures:  
RIGHT SPEAKER BOX  
LEFT SPEAKER BOX  
Minimum 10 cm (4 inches) distances around the apparatus for sufficient ventilations.  
Theventilationshouldnotbeimpededbycoveringtheventilationopenings  
with items such as newspaper, table-cloths, curtains, etc.  
No naked flame sources such as lighted candles should be placed on the  
apparatus.  
On Safety  
As the laser beam used in this compact disc player could be harmful to the  
eyes, do not attempt to disassemble the casing. Refer servicing to qualified  
personnel only.  
To AC  
outlet  
Do not put any foreign objects in the disc compartment. If you do so, the  
laser beam interlock may be defeated allowing the laser to remain on when  
the lid is opened.  
Do not put any foreign objects in the DC IN jack. Should any objects or  
liquids fall into the unit, disconnect the power supply and have the unit  
checked by qualified personnel before any further operation.  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit different from that to  
which the receiver is connected.  
To “DC IN 12V” jack  
AC adapter  
Consult the dealer or an experienced radio/TV technician for help.  
WARNING: Changes or modifications to this unit not expressly approved by  
the party responsible for compliance could void the user’s authority to operate  
the equipment.  
On Operation  
Since the CD system offers a wide dynamic range, the peaks of the high level  
inputs are recorded with high fidelity, and the noise level is very low. Do not  
turn up the volume while listening to a part of the disc with no audio signals  
or very low level inputs. If you do so, the speakers may be damaged when the  
peak level of the sound is played. The lens of the laser should be kept clean.  
Do not touch the lens. If you do so, the lens may be damaged and the unit will  
not operate correctly.  
Using the AC Adapter  
Using an AC adapter other than the one supplied with the unit may  
H
H
E
O
T
L
E
N
S
T
O
N
O
D
damage the unit. This AC adapter operates on AC 100-240V~50/60Hz.  
T
R
L
I
O
D
C
N
K
A
S
N
D
E
E
P
F
E
A
O
U
E
O
T
O
P
X
N
CAUTIONS:  
E
B
T
E
E
A
D
I
E
D
H
M
O
V
.
W
A
Before use, ensure the rated voltage of the adapter matches your  
local voltage.  
The included AC adapter is for use with this unit only. Do not use it  
with other equipment.  
If you are not going to use the unit for a long time, disconnect the  
AC adapter from the wall outlet.  
Whenever the AC adapter is plugged in to a wall outlet, electricity is  
running through the unit, even when the power switch is turned off.  
On Use  
Never use the unit where it would be subject to:  
This product contains a low  
power laser device.  
This Audio System has  
earned the ENERGY STAR.  
-
-
-
-
-
-
Heat sources such as radiators or air ducts.  
Direct sunlight.  
Excessive dust.  
Moisture or rain.  
WARNINGS:  
Mechanical vibration or shock.  
Uneven surface.  
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO  
RAIN OR MOISTURE.  
• Do not place any heavy objects on top of the unit.  
FM ANTENNA  
TO AVOID ELECTRICAL SHOCK, DO NOT OPEN THE CABINET. REFER  
SERVICING TO QUALIFIED PERSONNEL ONLY.  
When the unit is used with an AC power adapter, do not wrap the unit in a  
cloth, blanket, etc. If you do so, the temperature inside and outside the unit  
may rise considerably, resulting in malfunctioning of the unit.  
Do not connect the FM antenna to an outside antenna.  
THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR  
SPLASHING AND THAT NO OBjECTS FILLED WITH LIQUID, SUCH AS  
VASES, SHALL BE PLACED ON THE APPARATUS.  
• If the unit is brought directly from a cold to a warm location, or is placed  
in a very damp room, the moisture may condense on the lens inside the  
unit. Should this occur, the unit will not operate. In this case, remove the  
disc and leave the unit in a warm place for several hours until the moisture  
evaporates.  
• Fortheunittooperateatitsbest, itshouldnotbesubjecttotemperatures  
below 41°F (5°C) or above 95°F (35°C).  
For Customers in Canada  
It's important to read this instruction prior to using your new product  
for the first time.  
This apparatus complies with the Class B limits for radio noise emission set out  
in radio interference regulations.  
- 1 -  
- 2 -  
- 3 -  
Volume Adjustment  
Remote Control  
Location of Controls  
Listening to the Radio  
To Adjust the Volume  
Battery Replacement  
Unit (Rear View)  
1. Press the STANDBY/ON button to turn the unit  
Adjust the VOLUME levels to obtain the desired  
volume.  
When the battery becomes weak, the operating distance of the remote  
control is greatly reduced and you will need to replace it.  
on.  
2. Press the FUNCTION button repeatedly to select  
Note: If the remote control is not going to be used for a long time, remove  
the battery to avoid damage caused by battery leakage corrosion.  
20  
21  
radio mode.  
For Personal Listening  
3. Press the BAND/ STOP button to select a band  
Connect headphones (Ø3.5mm stereo mini plug) to the PHONES jack.  
Adjust the VOLUME level to the desired level.  
When headphones are connected, the speakers are automatically  
muted.  
(AM/FM).  
WARNINGS:  
Do not dispose of battery in fire; battery may explode or leak.  
Battery shall not be exposed to excessive heat such as sunshine, fire  
or the like.  
4. Press the  
or  
button to tune in to a station.  
22  
23  
5. Adjust the volume levels  
Searching for a Station Automatically  
Danger of explosion if battery is incorrectly replaced. Replace only  
with the same or equivalent type.  
24  
Remote Control  
Press and hold the  
searching for a station, then release. After tuning in a station, the  
search stops.  
or  
button until the tuner starts  
CAUTION: When discarding batteries, environmental problems must  
be considered and local rules or laws governing the disposal of these  
batteries must be strictly followed.  
1
1.  
2.  
3.  
4.  
5.  
6.  
7.  
8.  
9.  
PRESET EQ Button  
ON/STANDBY Button  
SLEEP Button  
PROG/MEM/  
RANDOM Button  
The search may not stop at a station with a very weak signal.  
8
9
10  
2
3
4
5
Presetting Stations  
20. AUX IN jack  
21. DC IN 12V Jack  
22. Right & Left Speaker Terminals  
23.  
Earphone Jack  
Button  
The unit can store a total of 20 stations in memory (10FM, 10AM).  
Presetting allows you to tune in to a station directly.  
24. FM Antenna  
Location of Controls  
11  
MEM.UP /  
Button  
1. Tune in to a desired station.  
BAND / STOP Button  
FUNCTION Button  
TIMER Button  
2. Press the PROG/MEM/  
(
) button. The preset number will blink  
Unit (Front View)  
Clock Setting  
Setting the clock can only be done in STANDBY mode.  
12  
13  
14  
15 16 17  
and theMEMORYindicator will flash on the display.  
18  
19  
6
7
1
3. Press the MEM.UP/  
button to select the preset number.  
) button again to store it in memory.  
10. DISPLAY Button  
11. Button  
12. VOLUME +/- Buttons  
13. PLAY/PAUSE Button  
4. Press the PROG/MEM/  
(
/
If the unit is plugged in with the supplied AC adapter and the unit is  
in standby mode, the standby indicator illuminates.  
2
5. Repeat steps 1-4 to store other stations.  
3
4
5
Tuning in to a Preset Station  
AM  
1. Press and hold the PROG/MEM/  
(
) button  
6
7
Press the BAND/ STOP button to select AM or FM band, then press the  
until the hour digits blink.  
8
Using the Remote Control Correctly  
MEM.UP/  
button to select a preset number.  
9
10  
11  
12  
Point the remote control at the REMOTE SENSOR located on the  
unit.  
2. Press the  
or  
button to adjust the desired  
)button  
For Better Reception  
hoursthenpressthePROG/MEM/  
once to confirm. The minute digits will begin to  
blink.  
(
FM: Fully unwind the antenna wire. Extend the antenna wire and place it  
in the position that sounds best.  
When there is a strong ambient light source, the performance of  
the infrared REMOTE SENSOR may be degraded, causing unreliable  
operation.  
AM  
AM  
AM  
Note: Do not connect the FM antenna to an outside antenna.  
AM: Reposition the unit to get better AM reception.  
Notes:  
13  
3. Press the  
or  
button to adjust the desired  
The effective maximum distance for remote operation is approx. 19  
feet (6 meters).  
minutes then press the PROG/MEM/  
button once to start clock.  
(
)
1. LCD Display  
11. DISPLAY Button  
12. SLEEP Button  
13. iPod Docking  
14. VOLUME - Button  
15. VOLUME + Button  
When the reception is good, the“((STEREO))”indicator will appear on  
the display.  
To Change Battery  
2.  
STANDBY Indicator  
3. TIMER Indicator  
4. Remote Sensor  
ATTENTION  
1. Open the battery door.  
Notes:  
TopreventinterferencetoAMradiosignals,pleasekeeptheACadapter  
at least 3 feet (approx. 1 meter) away from the main unit.  
Remove the plastic sheet  
before operating the  
remote control.  
12:00 PM = NOON time, “PMwill be display for  
times between Noon and Midnight.  
Tap the DISPLAY button once to display the  
current time.  
5.  
STANDBY/ON Button  
6. MEM.UP/  
Button  
16.  
17.  
/ TUNING + Button  
/ TUNING - Button  
2. Insert one CR2025 (3V) size battery.  
7. BAND/ STOP Button  
8. FUNCTION Button  
18. OPEN Knob  
19. CD Door  
9.  
PLAY/PAUSE Button  
10. PROG/MEM/ Button  
- 4 -  
- 5 -  
- 6 -  
- 7 -  
811-711691W062 ENG RCA.indd  
1
2009-05-22 15:05:33  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Razor Mobility Scooter 13111290 User Guide
Ricoh All in One Printer 1106EX User Guide
Rinnai Headphones REH 20DT User Guide
Samson Musical Instrument D2500 User Guide
Samsung Cell Phone 616960039358 User Guide
Samsung DVD Player DVD VR350 User Guide
Samsung Laptop NP900X3C A01US User Guide
Samsung Refrigerator RF266 User Guide
Sanyo CD Player VA EXD1W User Guide
Sears Planer 113 User Guide