Parts Supplicd:
Proper Location
Powered Diversity TVAntenna
1. TVAntenna(2)
Mount the antenna on the inside rear window of the car.
2. Power Cord Holder(6)
3. Antenna Cable Holder(4)
4. Seal(2)
For optimum reception, mount the antenna pointing
down.(See Fig 2)
Leave a minimum of 1 inch space between the antenna
wires and the edge of the window.
Antenna
Loading coil
Location should not impair driver s view.
Do not mount near or next to an existing antenna.
Be certain that there is enough cable to reach the unit.
Antenna cable
Antenna plug
PLVWAN6
Trial fit the antenna-do not remove protective paper from
booster or antenna sections.
Installation Manual
Booster amp section
Power cord
Mini jack
Cigarette light plug
(Fig 1)
Y cable
Note:
1. Use only on vehicles with 12-14.4Volt battery
2. Avoid short circuits by disconnecting the negative(-)battery
cable before beginning installation.
3. Protect the wiring by wrapping adhesive tape around
exposed areas.
4. Antenna wires should not come in contact with moving
parts, areas of heat or sharp surfaces.
5. Avoid installing in areas that may become wet with rain.
Failure to do so may result in fire or electrical shock.
(Fig 2)
Download from Www.Somanuals.com. All Manuals Search And Download.
|