Vectra
MIC-1 Electret Condenser Microphone
The Vectra MIC-1 stereo microphone fits most digital video and DSLR cameras. This
microphone offers more natural improved sound over what you will normally get with the mic
built in to your camera or camcorder. Its high sensitivity and strong directional capability gives
you superb clarity for subjects that are further away. The Vectra MIC-1 offers a selectable pick-
up pattern to get the best sound depending on the scene you are recording.
Important Notes:
The microphone is a sensitive precision instrument. DO NOT subject it to impact or
excessive vibration. Keep it away from high temperatures and humidity.
If the microphone is operated near an amplifier you will experience feedback. If this
happens, move the microphone away from the amplifier or turn down the volume of the
amplifier.
Changing the mode switch while recording will cause the switch noise to be recorded.
If the windscreen gets wet from rain or other sources, it should be dried in a cool, dry
place. Avoid drying in direct sunlight to prevent deterioration of the foam.
Package includes:
MIC-1 Electret Condenser Microphone
Wind Screen
CR2 battery
Storage bag
Instruction Manual
Installing or changing the battery
The battery must be installed in order for the microphone to operate.
1. Push the battery cover backward and lift off.
2. Push the battery towards the front of the microphone to remove.
3. Put the new battery into the battery compartment. Be sure to observe the correct polarity.
4. Replace the battery cover and slide into place.
Download from Www.Somanuals.com. All Manuals Search And Download.
Figure 1
Figure 2
1. Wind Screen: Cover on the microphone
to reduce the wind noise and sound of
breath.
2. AF light: When you switch "OFF" to
"ON", the light will flash then off. When
the light flashes or glows during use it
indicates low power and the battery
should be replaced.
3. Power/Mode switch
4. Battery cover
5. Accessory shoe connector
6. Mini stereo plug
7. Cable clip: Use this to remove slack in
the cable.
Mode switch
Download from Www.Somanuals.com. All Manuals Search And Download.
ON
OFF
90°
Microphone is on
Microphone is off
Picks up sound in a limited area or from a further distance
Picks up sound in a big area or a closer distance
120°
Specifications:
Frequency response: 30-1800Hz
Sensitivity: -40dB (0dB=1V/Pa at 1KHz)
Direction: Uni-direction
Output Impendency: 200
S/N Radio: 76dB (1KHz at 1Pa)
Max SPL: 120dB (at 1KHzs1%T.H.D.)
Power Requirements: DC 3V (CR2 battery)
Length of Cable: 11 in./28cm
Dimensions: .98 x 5.12 x 2.36"/25 x 130 x 60mm
Weight: 1.59 oz/45g (without battery)
Code 8026
Made in China
Vectra • Fairfield, CT 06825
Download from Www.Somanuals.com. All Manuals Search And Download.
|