mypod™
refillable coffee holder
(model 09402)
Replaces the Philips* Senseo* model HD7810/15,
HD7810/65, and HD7810/75 pod holder.
instructions
Before using the Presto® MyPod™ refillable coffee holder with your Philips* Senseo* pod coffee maker, be sure the coffee maker is in good working
condition.
Important Information
1. Your coffee maker is not designed to brew all grinds of coffee.
Coffee scoop
Refillable coffee holder
It is instead designed for use with the pods that accompany
the unit. You can enjoy similar results by using a drip coffee
maker grind when using the Presto® MyPod™ refillable coffee
½ fill line
Retractable
lifting pin
holder. If you grind your coffee from beans, be sure that the
texture feels no coarser than table salt and no finer than sugar.
You can tell by the coffee produced if you have the right
grind; if too fine, little or no coffee will be dispensed; if too
coarse, a weaker than desired brew will be produced.
Fig. A
2. Your coffee maker will dispense more coffee with the Presto®
MyPod™ refillable coffee holder than it does when using the
pods that accompany the unit. Depending on the size of the
cup used, it may overflow.
Compacting
cover
Coffee filter
Note: We recommend that you remain by the coffee
maker during the brew cycle. You can stop the flow at any
time, by pressing the indicator light button on the coffee
maker.
*Senseo and Philips are trademarks of Koninklijke Philips Electronics N.V. LTD. LIAB. CO.
National Presto is not affiliated with that company.
©2006 by NPI, Inc.
Fig. B
3. When using the Presto® MyPod™ refillable coffee holder, your coffee maker will not produce crème.
Flat
side up
Brewing Coffee
Before first use, wash the coffee scoop, refillable coffee holder, and compacting cover in warm, soapy water. Rinse
thoroughly.
1. Place a Presto® MyPod™ coffee filter in the refillable coffee holder. Moisten the filter slightly to prevent slippage
inside the holder.
2. Using the coffee scoop (Fig. A), pour 1 to 1½ scoops of ground coffee on the filter in the refillable coffee holder.
Use 1 scoop for normal strength coffee and 1½ scoops for stronger coffee. Do not use more than 1½ scoops of
coffee.
Fig. C
Using a damp paper towel, brush off any coffee grounds on the rim of the holder before placing the holder in the
coffee maker.
Use a drip coffee maker grind NOT an espresso grind of coffee. If you grind your own coffee, it should have
a texture which feels no finer than sugar and no coarser than table salt.
3. Position the compacting cover over the coffee grounds so the flat side is facing up (Fig. B) and push it down firmly
and completely to compact the coffee grounds. Depress retractable lifting pin before use.
4. Remove the pod holder that came with your Philips* Senseo* pod coffee maker. Replace it with the Presto® MyPod™ refillable coffee holder (Fig.
C) and follow the manufacturer’s instructions for brewing coffee.
Removing and Cleaning Holder
1. Your Philips* Senseo* coffee maker operates under high pressure. After coffee is done brewing, before opening unit, wait approximately one
minute to allow pressure to reduce and excess water to drain through unit. It is normal for a small amount of dripping to occur once the brewing
cycle is complete.
2. Slowly open lid on your coffee maker and using the handle, carefully remove the coffee holder from the coffee maker. Use caution when removing
coffee holder from coffee maker as there may still be some hot water/coffee in holder that may drip. Let coffee holder cool down or run coffee
holder under cold water and then lift off compacting cover using the retractable lifting pin (Fig. A). Discard coffee grounds.
1
Download from Www.Somanuals.com. All Manuals Search And Download.
|