Precor Bicycle Accessories PVS 15 User Manual

PVS-15  
Personal Viewing System  
Assembly and Operation Manual  
Cardio Theater Holdings, Inc.  
21420-D NW Nicholas Court #12-13  
Hillsboro, OR 97124  
(800) 776-6695  
(503) 645-8881  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Parts List:  
Master Set Up Package  
1
1
Master IR Remote Control  
Operations Manual  
Screen Controllers (1 for each Screen)  
Neoprene Mounting Pad (1 for each controller)  
DVD Player Master IR Remote (Optional)  
1
1
Screen Box  
1
1
1
1
1
1
4
15 inch LCD Screen  
AC Adapter  
Adapter Power Cord  
LCD Back Cover  
Controller Cable  
LCD Screen Hardware Package  
Wire Ties  
Stand Box  
2
1
1
1
1
1
8
Stand Feet  
Base Cross Bar  
Lower Vertical Tube  
Upper Vertical Tube (Short or Long Model)  
Base Cover  
Coax / Power Cable  
Hex Screws  
DVD Player Box (Optional)  
1
1
1
DVD Player  
12 Volt Power Cable  
Audio / Video RCA Patch Cord  
DVD Bracket (Optional)  
1
1
1
Long or Short Bracket (as ordered)  
Back Cover (Short Version Only)  
DVD Hardware Package  
2
Download from Www.Somanuals.com. All Manuals Search And Download.  
Stand Assembly  
Step 1  
Step 2  
Determine width of stand feet in relation to the  
cardio equipment. Use a 7/16 wrench to secure  
2 hex screws per leg.  
Insert lower vertical tube over center stub  
and hand install one 3/16 Allen head screw a  
few turns into vertical tube. Do not tighten  
at this time. (Clearance needed for Wires)  
Step 4  
Step 3  
Insert upper curved tube into lower tube. Do  
not install bolts until step 5 is performed,  
then adjust upper tube to desired height and  
install two Allen screws as shown above.  
Insert plastic base cover over lower vertical  
tube. Do not fasten down at this time.  
Step 6  
Step 5  
Mount power supply with 2 wire ties to the  
base assembly. Plug power supply connector  
into cable previously installed down vertical  
tube.  
Insert cable assemblies through upper tube  
opening and bring out lower tube hole as shown.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
Stand assembly- continued  
Step 7  
Step 8  
Route coax and AC power plug to center  
Opening of base cover and make sure to tighten lower  
bolt before installing cover.  
With cables properly placed in cover slot, secure  
base cover with 2 Allen head screws provided.  
Step 9  
Install last remaining Screw in upper tube  
Assembly and double-check all Fasteners for  
Tightness.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
DVD Player Assembly  
NOTE: Skip to Page 7 if not installing DVD Player  
Important: There are two models of DVD brackets.  
Short DVD Bracket  
For S Model Stand  
Long DVD Bracket  
For L Model Stand  
1: Run supplied Audio Video cable and DVD 12 Volt Power cable from  
opening at top of stand out through large round hole in upper tube of  
stand.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
2: Pull Audio/Video and 12 Volt Power cable wires through hole in DVD bracket  
and attach bracket to stand with 2 hex screws provided.  
IMPORTANT: When attaching Short Version, confirm that the large  
square opening on the rear of the bracket is positioned on the right  
side of the stand tube as shown.  
Short Version  
Long Version  
3: Plug Audio Video cable into the Video & Audio “Output” on the rear of the  
DVD player.  
4: Plug 12 Volt Power cable into 12 Volt input on rear of DVD player.  
5: Remove two security screws from top of DVD player.  
Attach DVD player to bracket with 4 Phillips screws provided.  
Short Version  
Attach back cover with 4 Phillips  
screws provided.  
Long Version  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
6: Connect DVD 12 Volt Power cable to main Coax / Power wire coming  
through top of stand.  
7: Connect the Video cable coming from the DVD player “Output” to the connector labeled  
“Video Y” on the back of the monitor and the cable going from the DVD players audio  
outputs to “Audio Left & Right” input on the back of the monitor.  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
LCD Screen Assembly  
1. Attach pivot assembly to back of LCD monitor using upper two mounting holes as  
shown in figure 1. Leave out the lower two mounting screws until after all wiring is  
installed onto back of monitor.  
2. Install monitor assembly onto upper stand tube using (3) M4 X 10mm socket head  
cap screws as shown in Figure 2  
3. Install power connector from harness that was installed into stand assembly  
earlier, to input on back of monitor labeled “DC12V” as shown in figure 3.  
4. Plug Screen Controller cable from stand harness to telephone type RJ45 plug on  
back of monitor. (Figure 4)  
Figure 1  
Figure2  
Figure 3  
Figure 4  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  
LCD Screen Assembly (continued)  
5. Remove slip-on antenna connector from monitor by pulling straight down  
connection (Figure 5).  
on  
Screw slip-on connector onto coax cable and then push assembly back into the  
monitor’s antenna connector. (Figure 6)  
6. Attach Back Cover plate using 2 M4 x 10mm black screws. (Figure 7)  
Note: Before securing back cover, confirm that all cables connected to  
LCD screen have sufficient slack for tilting the monitor and are not that  
they are not intertwined.  
Figure 5  
Figure 6  
Figure 7  
7. Pull excess wires through hole of Lower Vertical Tube on stand and conceal inside  
bottom plastic Base Cover.  
8. Plug 110AC power cord into AC outlet.  
9. Plug screen control cable into controller.  
10. Power On LCD screen and test functions  
9
Download from Www.Somanuals.com. All Manuals Search And Download.  
Mounting Screen Controller  
CNTE-4  
CNTE-16  
1. Remove backing from neoprene mounting pad and place either vertically  
or horizontally around equipment handrail as appropriate as shown below.  
2. Insert two nylon wire ties (provided) through the bottom holes in the  
mounting bracket on the rear of the Screen Controller.  
3. Attach wire ties as tightly as possible around the horizontal or vertical bar so the  
controller can’t be rotated. This is very important to keep moisture out of the  
controller and to keep from damaging the electronics inside unit.  
ΝΟΤΕ: Do not place controller where it would interfere with the cardio unit  
controls or display panel. The Screen Controller mounting bracket may  
be removed with pliers and mounted with Super Lock Velcro to any flat  
surface.  
10  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Auto Programming TV Channels  
The following requires the LCD Screen Master IR Remote Control Unit  
1. Press menu button on Master IR Remote.  
2. Scroll Down to “Install” then press “Select”.  
3. Select “Auto Search” and press “Select”.  
4. Select Cable, HRC or Air (Check local cable company for HRC)  
5. Note: Programming may take up to 3 minutes.  
Manually Add or Erase Channels:  
1. Manually select channel using Master IR Remote.  
2. Press menu button on Master IR Remote.  
3. Scroll Down to “Install” and then press “Select”.  
4. Scroll to “Store/Clear”.  
5. Select “Store” or “Clear”  
6. Choose next channel and repeat.  
11  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Cable Management System  
The Optional Cable Management System is used to cover the antenna cable and  
power cords that run between the individual stands. It consists of a metal bracket  
that connects to the bottom of the monitor stand and a plastic two-channel  
extrusion that can be cut to length with common hand tools.  
5 foot Cable Management extrusion.  
Cable Management  
Mounting bracket  
Bottom view of bracket  
mounted with four screws  
Installation Instructions  
Step 1  
After monitors are mounted to stands and the proper spacing between equipment  
has been determined, measure distance between stands and cut Cable  
Management extrusion to length.  
Step 2  
Remove Allen Head screw from plastic bottom cover of stand. Place mounting  
bracket over same hole and re-install the Allen Head screw.  
Step 3  
Place Cable Management extrusion into end of bracket and install 4 self tapping  
screws, two on each side of bracket.  
Repeat on opposite side of extrusion.  
12  
Download from Www.Somanuals.com. All Manuals Search And Download.  
RF Distribution  
Below is a diagram of a typical install. Please note that the tap values are dependant on  
having a 35 db signal at the output of the signal amplifier. It is best to use a quality  
amplifier that has a variable output so that you can adjust it to match 35 db even if your  
input is either lower or higher.  
These tap values and db readings are based on RF theory.  
13  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Specifications:  
15” Color LCD Monitor  
Visible Screen Size  
Pixel Range  
304.1(H) X 228.1(V)  
0.297(H) X 0.297(V)  
Type  
Visual Angle  
Horizontal Frequency  
Vertical Frequency  
Display Color  
a-si TFT Liquid Crystal Display  
upper 55’/lower 65’, left 70’/right 70’  
31~60 KHz(Auto Set)  
56~75 Hz(Auto Set)  
16.2M Color  
Input/Video Signal  
TV Color System  
Channel Memory  
Receiving Channel  
Video Input Color  
Power Adaptor  
Analog 0.714Vp_p Positive(75ohm)  
PAL,SECAM,NTSC  
100 Channel—PAL System  
181Ch (113ch CATV)—NTSC System  
PAL/SECAM/NTSC  
Input :100~240V @.1A max – Output: 12Vdc@3A  
0’C~40’C  
10%~85%  
Operating Temperature  
Conditions Humidity  
DVD Player (Optional)  
Please see DVD Manual in DVD Box  
14  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Warranty  
Cardio Theater™ warrants the Personal Viewing System to be free from defects  
in material and workmanship for the following period of time from date of  
shipment, provided that the products have not been subject to mechanical,  
electrical, or other abuse or modifications.  
Cardio Theater LCD Screen  
Cardio Theater Screen Controller  
1 Years Parts & Labor  
1 Year Parts & Labor  
Quick Change Headphone Jack 90 Days (from original installation)  
Should the LCD Screen, DVD Player or Controller be deemed defective by  
Cardio Theater, a return authorization number will be issued. Cardio Theater  
will not accept returns without a return authorization number. Cardio  
Theater reserves the right, at their option, to repair or replace the equipment after  
verification of defect.  
Equipment that fails after the warranty period expires will be repaired at the  
current price of part and labor after authorization from the customer. Repairs are  
warranted for 90 days.  
This warranty is in lieu of all other warranties expressed or implied.  
FCC Compliance Statement  
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant  
Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference.  
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in  
accordance with the instructions, may cause harmful interference to radio communications.  
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does  
cause harmful interference to radio or TV reception, please contact Cardio Theater Inc. for trouble shooting  
guidance.  
DOC Class B Notice  
This digital apparatus does not exceed Class limits for radio noise emission as set out in the Radio Interference  
Regulations of the Canadian Department of Communications.  
The user is cautioned that changes or modifications not expressly approved by  
the manufacturer of the equipment could void the user’s authority to operate the  
equipment.  
WARNING: To Prevent Fire Or Electrical Shock, Do Not Expose This Appliance  
To Rain Or Moisture.  
15  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Technical Support  
Technical Support Numbers  
Telephone 1-800-776-6695  
Technical Support Hours:  
6:00 AM to 5:00 PM Monday through Friday PST.  
Write To:  
Cardio Theater Holdings, Inc.  
21420-D NW Nicholas Court #12-13  
Hillsboro, OR 97124  
Notice  
Due to continuing advancements in technology, Cardio Theater Holdings, Inc.  
reserves the right to make changes in hardware, packaging, and any  
accompanying documentation without prior written notice.  
Cardio Theater PVS and Cardio Theater Quick Change Headphone Jack are  
registered trademarks of Cardio Theater Holdings, Inc.  
© 2003 Cardio Theater Holdings, Inc., all rights reserved  
16  
Download from Www.Somanuals.com. All Manuals Search And Download.  
17  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Peavey Music Mixer PA 400 User Manual
Pelco Car Satellite TV System Brrdp User Manual
Pelco Door 2 C2485M A 1 05 User Manual
Pelco TV Mount C2234M User Manual
Philips Biscuit Joiner MCD515 User Manual
Philips TV Mount 32FWF1013 User Manual
Philips Universal Remote 26PW6341 37 User Manual
Planar Car Video System PL2410W User Manual
Poulan Lawn Mower 187007 User Manual
Poulan Snow Blower PP524A User Manual