Register your product and get support at
Presenter
SNP6000
EN User manual
nload from Www.Somanuals.com. All Manuals Search And Down
2
3
4
nload from Www.Somanuals.com. All Manuals Search And Down
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the
following measures:
to confirm successful numbering
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:Any changes or modifications not expressly approved
by the party responsible for compliance could void the user’s
authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1)This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment.This transmitter must not be
co-located or operating in conjunction with any other antenna or
transmitter.
nload from Www.Somanuals.com. All Manuals Search And Down
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS
2
LASER PRODUCT
Wavelength
:
645
-
660nm
1mW
Maximum Power
<
IEC 60825-1:1993
EN 60825-1:1994
+
A1:1997
+
A2:2001
A1:2002
+
A2:2001
+
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE
INSTRUCTIONS
Complies with
IDA Standards
DB100486
nload from Www.Somanuals.com. All Manuals Search And Down
EN
1
Overview of the product (Fig. 1)
a
LED indicator
b
Control buttons;
Button
Presenter
Air mouse
Play/Stop
Click to open the file
Blank screen
Previous slide
Next slide
No function
Left mouse click
Right mouse click
Laser pointer
Laser pointer
c
d
e
Mode switch ( : Presenter; :Air mouse)
Nano Dongle
Battery compartment
2
Switch on the product
CCaution
• Keep the Nano Dongle out of reach of children.
1 Open the battery compartment.
2 Insert 2 AAA batteries with correct polarity (+/-) as indicated (Fig. 2).
3 Take out the Nano Dongle (Fig. 3).
4 Close the battery compartment.
5 To use the product as a presenter, switch to .
• To use the product as an air mouse, switch to
.
3
Get started
1 Ensure that your notebook is switched on and active.
2 Ensure that your floating presenter is switched on.
3 Plug the Nano Dongle into a USB host on your notebook.
nload from Www.Somanuals.com. All Manuals Search And Down
»Auto-connection starts.
»The LED blinks upon every successful communication between
the floating presenter and the Nano Dongle.
E Tip
• Upon the first installation on Mac, Keyboard Set Assistant may appear
and prompt that the keyboard cannot be identified. Click Continue to
finish the installation, and then the floating presenter works accordingly.
• After use, insert the Nano Dongle into your floating presenter for
storage (Fig. 4).
4
Troubleshooting
Problem
Solution
No transmission.
Ensure that you use the product within
effective range.
Light on your product
blinks 3 times.
Replace batteries on the product.
Light on your product
does not blink.
1. Ensure that the product is switched on.
2. Replace batteries on the product.
The mouse does not work. Ensure that you switch on the mouse
mode.
5
Disposal of your old product
Your product is designed and manufactured with high quality materials
and components, which can be recycled and reused.
When this crossed-out wheeled bin symbol is attached to a product it
means that the product is covered by the European Directive 2002/96/EC.
Please inform yourself about the local separate collection system for
electrical and electronic products.
Please act according to your local rules and do not dispose of your old
products with your normal household waste. Correct disposal of your
old product helps to prevent potential negative consequences for the
environment and human health.
nload from Www.Somanuals.com. All Manuals Search And Down
Your product contains batteries covered by the European Directive
2006/66/EC, which cannot be disposed with normal household
waste.Please inform yourself about the local rules on separate collection
of batteries because correct disposal helps to prevent negative
consequences for the environmental and human health.
nload from Www.Somanuals.com. All Manuals Search And Down
© 2010 Koninklijke Philips Electronics N.V.
All rights reserved.
Specifications are subject to change
without notice.Trademarks are the
property of Koninklijke Philips Electronics
N.V. or their respective owners.
UM_V3.1
nload from Www.Somanuals.com. All Manuals Search And Down
|