Philips Clock Radio AJ3226 User Manual

AJ3226  
Clock Radio  
Register your product and get support at  
User Manual  
wnload from Www.Somanuals.com. All Manuals Search And Downlo  
English  
Congratulations on your purchase and welcome to Philips!  
To fully benefit from the support that Philips offers, register your  
CONTROLS (see fig. 1 )  
1 SLEEP - activates the radio for sleep function  
-
adjusts the sleep period  
2 Clock control  
- SET TIME : sets the clock time  
- SET AL 1: sets the alarm time for alarm 1  
- SET AL 2: sets the alarm time for alarm 2  
- CLOCK: to run on clock time  
3 UP / DOWN: adjusts the hours/ minutes for the clock and alarm times  
4 REPEAT ALARM / SLEEP OFF  
-
switches off the active alarm for a 6-7 minute period  
- switches off the sleep function  
5 Frequency indicator - shows the radio frequency of your selected waveband  
6 TUNING - tunes to radio stations  
7 BAND - select FM/MW waveband  
8 VOLUME - adjusts the sound level  
9 ALARM RESET - stops the active alarm for 24 hours  
0 DISPLAY - show the clock/ alarm times and status of the set  
! OFF • RADIO • AUX - switches off the set or selects the radio/AUX mode.  
@ AL 1, AL 2  
OFF switches off the alarm 1 or alarm 2  
RADIO activates the radio for alarm 1 or alarm 2  
BUZ activates the buzzer for alarm 1 or alarm 2  
# Battery door - opens to store a 9 volt 6F22 type battery (not included) for  
clock memory backup  
$ Mains lead - for AC mains supply  
%
Pigtail aerial  
-
improves FM reception  
^
AUX connects external audio source.  
-
wnload from Www.Somanuals.com. All Manuals Search And Downlo  
INSTALLATION  
POWER SUPPLY  
1
Check if the mains supply, as shown on the type plate located on the  
bottom of the set, corresponds to your local mains supply. If it does not,  
consult your dealer or service centre.  
2
3
Connect the mains lead to the wall socket.  
To disconnect the set from the mains supply completely, remove the plug from  
the wall socket.  
CLOCK MEMORY BACKUP  
The clock memory backup allows your alarm and clock time settings to be stored  
for up to a day when there is a power interruption e.g. mains failure. The com-  
plete clock radio and display illumination will be switched off. As soon as the  
mains supply returns, the display will indicate the correct time.  
1
2
Remove the battery door to insert a 9 volt 6F22 type battery (not included) for  
backup.  
Replace the battery door.  
NOTE: If no backup battery is installed or the power interruption is prolonged, you  
will need to set the clock and alarm times again.  
Batteries contain chemical substances so should be disposed of  
properly.  
For users in the U.K.: please follow the instructions on the lower left part  
of this sheet.  
The type plate is located on the bottom of the set.  
wnload from Www.Somanuals.com. All Manuals Search And Downlo  
RADIO  
You can use this set solely as a radio!  
1
2
3
4
5
Adjust OFF • RADIO • AUX to RADIO to switch on the radio.  
Select your waveband by adjusting the BAND switch  
Adjust TUNING to tune to your desired station  
Turn the VOLUME control to adjust the volume level  
Adjust OFF • RADIO • AUX to OFF to switch off the radio.  
.
.
.
To improve reception:  
FM:  
extend and position the pigtail for optimum reception  
.
MW:  
uses a built-in aerial inside the set. Direct the aerial by adjusting  
the position of your set  
.
SETTING THE CLOCK AND ALARM TIME  
The time is displayed using the 24-hour clock  
IMPORTANT! To adjust the clock and alarm times accurately, always make sure  
you press UP / DOWN separately and not simultaneously.  
1
2
Turn the clock control to SET TIME or SET AL 1 or SET AL 2 to set the  
clock or alarm time respectively.  
Press UP / DOWN repeatedly or hold down on the respective button to adjust  
the hours and minutes.  
3
4
Release UP / DOWN when you reach the correct setting.  
After you have set both the hour and minutes, turn the clock control to  
CLOCK to run on clock time.  
SELECTING THE ALARM MODE  
GENERAL  
If you wish to use the alarm, you must first set the alarm time first. You can  
choose from two different alarm modes to wake you up: by radio or buzzer.  
Select your choice of alarm mode by adjusting AL 1 or AL 2 to RADIO or  
BUZ.  
The buzzers are at a set volume and cannot be adjusted. BUZ on AL 1 is a  
low tone buzzer while BUZ on AL 2 is a high tone.  
wnload from Www.Somanuals.com. All Manuals Search And Downlo  
SWITCHING OFF THE ALARM  
There are three ways of switching off the alarm. Unless you cancel the alarm  
completely, the 24 hour alarm reset option will be automatically selected after  
59 minutes, from the time your alarm time first goes off.  
24 HOUR ALARM RESET  
If you want the alarm mode to be stopped immediately but also wish to retain the  
same alarm setting for the following day:  
Press ALARM RESET during the alarm call.  
CANCELING THE ALARM COMPLETELY  
To cancel the set alarm time before it goes off, or during the alarm call:  
Adjust AL 1 or AL 2 to OFF position.  
REPEAT ALARM  
This repeats your alarm call at 6-7-minute intervals.  
1
During the alarm call, press REPEAT ALARM/SLEEP OFF.  
SLEEP  
About Sleep  
This set has a built-in timer which enables the set to be automatically switched  
off during radio playback after a set period of time. This allows you to lie back,  
listen and fall asleep. The maximum sleep time is 59 minutes.  
Setting SLEEP  
1
2
3
Check that the clock control is in CLOCK position.  
Set OFF • RADIO • AUX to OFF position.  
To set the sleep function, do one of the following:  
Press and hold SLEEP  
.
The display will begin to count down from 0:59 to 0:00 minutes.  
Hold down SLEEP, and press UP/DOWN repeatedly to adjust sleep time from  
59 minutes downward.  
To cancel sleep, press REPEAT ALARM/SLEEP OFF.  
wnload from Www.Somanuals.com. All Manuals Search And Downlo  
CONNECTING AN EXTERNAL DEVICE  
You can listen to your favourite music of the connected external device through  
your AJ3226’s speakers.  
1
2
Adjust OFF • RADIO • AUX to select AUX.  
Connect the AUX-IN cable of the set to an AUDIO OUT or headphone jack on  
an external device (such as MP3 player, or CD player).  
Notes for battery disposal  
Your product contains batteries covered by the European Directive  
2006/66/EC, which cannot be disposed with normal household waste.  
Please inform yourself about the local rules on separate collection of  
batteries because correct disposal helps to prevent negative conse-  
quences for the environmental and human health.  
Specifications  
AC Power.............................................220 – 230 V / 50 Hz  
Power Consumption  
Active...........................................................................5 W  
Standby.....................................................................<2 W  
Dimensions (w x d x h)....................174 x 62 x 159 (mm)  
Weight......................................................................0.52 kg  
wnload from Www.Somanuals.com. All Manuals Search And Downlo  
SAFETY INFORMATION  
Install the unit near the AC outlet and where the AC plug can be easily  
reached.  
Where the MAINS plug is used as the disconnect device, the disconnet device  
shall remain readily operable.  
Place the set on a hard and flat surface so that the system does not tilt.  
If you do not intend to use the set for a long time, withdraw the power plug  
from the wall outlet. In addition to this, it is advisable to remove the battery  
from the clock radio. This will prevent any danger of leakage and the clock  
radio will not be damaged.  
Do not expose the set, batteries to humidity, rain, sand or excessive heat  
caused by heating equipment or direct sunlight.  
The apparatus shall not be exposed to dripping or splashing.  
Adequate ventilation with a minimum gap of 15cm between the ventilation  
holes and surrounding surfaces is necessary to prevent heat build-up.  
The ventilation should not be impeded by covering the ventilation openings  
with items, such as newspapers, table-cloths, curtains, etc..  
No objects filled with liquids, such as vases, shall be placed on the appartus.  
No naked flame sources, such as lighted candles, should be placed on the  
apparatus.  
To clean the set, use a soft, slightly dampened chamois leather. Do not use  
any cleaning agents containing alcohol, ammonia, benzene or abrasives as  
these may harm the housing.  
Battery shall not be exposed to excessive heat such as sunshine, fire or the like.  
CAUTION  
Use of controls or adjustments or performance of procedures other than  
herein may result in unsafe operation.  
This set complies with the radio interference requirements of the  
European Union.  
wnload from Www.Somanuals.com. All Manuals Search And Downlo  
TROUBLESHOOTING  
If a fault occurs, first check the points listed below before taking the set for repair.  
If you are unable to remedy a problem by following these hints, consult your dealer or  
service center.  
WARNING: Under no circumstances should you try to repair the set yourself, as this  
will invalidate the warranty. Do not open the set as there is a risk of  
electric shock.  
Problem  
Possible Cause  
Remedy  
No sound/power  
Volume not adjusted  
Adjust the volume  
Occasional crackling sound during FM broadcast  
Weak signal  
Adjust the position of the Pigtail  
Continuous crackling/hiss disturbance during MW broadcast  
Electrical interference from TV, computer, fluorescent lamp, etc.  
Move set away from other electrical equipment  
The alarm does not function  
Alarm time not set and or alarm mode not selected  
Set the alarm time and / select alarm mode  
Volume too low for RADIO  
Adjust the volume  
Radio alarm not adjusted to radio station  
Tune to a radio station  
wnload from Www.Somanuals.com. All Manuals Search And Downlo  
ENVIRONMENTAL INFORMATION  
We have reduced packaging to the minimum for easy separation into two  
materials: paper and cardboard.  
Your set consists of materials which can be recycled if disassembled by a special-  
ized company. Please observe local regulations on the disposal of packing materi-  
als and old equipment.  
Disposal of your old product  
Your product is designed and manufactured with high quality materials and com-  
ponents, which can be recycled and reused.  
When this crossed-out wheeled bin symbol is attached to a prod-  
uct it means the product is covered by the European Directive  
2002/96/EC.  
Please inform yourself about the local separate collection system for electrical  
and electronic products.  
Please act according to your local rules and do not dispose of your old products  
with your normal household waste. The correct disposal of your old product will  
help prevent potential negative consequences for the environment and human  
health.  
wnload from Www.Somanuals.com. All Manuals Search And Downlo  
Important notes for users in the U.K.  
Mains plug  
This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this  
type of plug proceed as follows:  
1
2
3
Remove fuse cover and fuse.  
Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or BSI approved type.  
Refit the fuse cover.  
If the fitted plug is not suitable for your socket outlets, it should be cut off and an  
appropriate plug fitted in its place. If the mains plug contains a fuse, this should  
have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribu-  
tion board should not be greater than 5 Amp.  
Note: The severed plug must be disposed of to avoid a possible shock hazard  
should it be inserted into a 13 Amp socket elsewhere.  
How to connect a plug  
The wires in the mains lead are coloured with the following code: blue = neutral  
(N), brown = live (L). As these colours may not correspond with the colour mar-  
kings identifying the terminals in your plug, proceed as follows:  
Connect the blue wire to the terminal marked N or coloured black.  
Connect the brown wire to the terminal marked L or coloured red.  
Do not connect either wire to the earth terminal in the plug, marked E (or e) or  
coloured green (or green and yellow).  
Before replacing the plug cover, make certain that the cord grip is clamped over  
the sheath of the lead - not simply over the two wires.  
Copyright in the U.K.  
Recording and playback of material may require consent. See Copyright Act 1956  
and The Performer’s Protection Acts 1958 to 1972.Protection Acts 1958 to 1972.  
wnload from Www.Somanuals.com. All Manuals Search And Downlo  
Meet Philips at the Internet  
W
AJ3226  
Specifications are subject to change without notice.  
2013 © WOOX Innovations Limited. All rights reserved.  
This product was brought to the market by WOOX Innovations  
Limited or one of its affiliates, further referred to in this  
document as WOOX Innovations, and is the manufacturer of the  
product. WOOX Innovations is the warrantor in relation to the  
product with which this booklet was packaged. Philips and the  
Philips Shield Emblem are registered trademarks of Koninklijke  
Philips N.V.  
wnload from Www.Somanuals.com. All Manuals Search And Downlo  
Printed in China AJ3226_UM_12_V5.0  

Peerless Industries TV Video Accessories FLD UNV User Manual
Pelco Security Camera C1457M C User Manual
Philips Battery Charger R6B4A245 User Manual
Philips Cell Phone CTX503WHT 00 User Manual
Philips Computer Hardware PSC 604 User Manual
Philips Electric Toothbrush HX6711 02 User Manual
Philips Network Router SL400i User Manual
Philips Speaker System SPA7210 17 User Manual
Pioneer Projection Television PRO 510HD User Manual
Poulan Chainsaw 952802143 User Manual