Always there to help you
Register your product and get support at
HTL2100
HTL2100B
HTL2100C
HTL2100G
HTL2100S
HTL2100T
HTL2100W
Question?
Contact
Philips
User manual
Download from Www.Somanuals.com. All Manuals Search And Download.
matches room temperature before
connecting it to the power outlet.
Parts of this product can be made of
glass. Handle with care to avoid injury and
damage.
1 Important
•
Read and understand all instructions before you
use your product. If damage is caused by failure to
follow instructions, the warranty does not apply.
Risk of overheating!
•
Never install this product in a confined
space.Always leave a space of at least four
inches around the product for ventilation.
Ensure curtains or other objects never
cover the ventilation slots on the product.
Safety
Risk of electric shock or fire!
Risk of contamination!
•
Never expose the product and accessories
to rain or water. Never place liquid
containers, such as vases, near the product.
If liquids are spilt on or into the product,
disconnect it from the power outlet
immediately. Contact Consumer Care to
have the product checked before use.
Never place the product and accessories
near naked flames or other heat sources,
including direct sunlight.
•
Do not mix batteries (old and new or
carbon and alkaine, etc.).
Danger of explosion if batteries are
incorrectly replaced. Replace only with the
same or equivalent type.
Remove batteries if they are exhausted or
if the remote control is not to be used for
a long time.
Batteries contain chemical substances, they
should be disposed of properly.
•
•
•
•
•
•
Never insert objects into the ventilation
slots or other openings on the product.
Where the mains plug or an appliance
coupler is used as the disconnect device,
the disconnect device shall remain readily
operable.
Risk of swallowing batteries!
•
The product/remote control may contain
a coin/button type battery, which can be
swallowed. Keep the battery out of reach
of children at all times! If swallowed, the
battery can cause serious injury or death.
Severe internal burns can occur within two
hours of ingestion.
If you suspect that a battery has been
swallowed or placed inside any part of the
body, seek immediate medical attention.
When you change the batteries, always
keep all new and used batteries out of
reach of children. Ensure that the battery
compartment is completely secure after
you replace the battery.
•
•
Disconnect the product from the power
outlet before lightning storms.
When you disconnect the power cord,
always pull the plug, never the cable.
•
•
Risk of short circuit or fire!
•
Before you connect the product to the
power outlet, ensure that the power
voltage matches the value printed on the
back or bottom of the product. Never
connect the product to the power outlet if
the voltage is different.
•
If the battery compartment cannot be
completely secured, discontinue use of the
product. Keep out of reach of children and
contact the manufacturer.
Risk of injury or damage to the SoundBar!
•
Never place the product or any objects
on power cords or on other electrical
equipment.
•
If the product is transported in
temperatures below 5°C, unpack the
product and wait until its temperature
3
EN
Download from Www.Somanuals.com. All Manuals Search And Download.
When this crossed-out wheeled bin symbol is
attached to a product it means that the product
is covered by the European Directive 2002/96/
EC. Please inform yourself about the local
separate collection system for electrical and
electronic products.
This is CLASS II apparatus with double
insulation, and no protective earth provided.
Mains fuse
Please act according to your local rules and
do not dispose of your old products with your
normal household waste.
Correct disposal of your old product helps to
prevent potential negative consequences for the
environment and human health.
This information applies only to products with a
UK mains plug.
This product is fitted with an approved molded
plug. If you replace the fuse, use one with:
•
•
•
the ratings shown on the plug,
a BS 1362 approval, and
the ASTA approval mark.
Contact your dealer if you are not sure about
what type of fuse to use.
Caution: To conform with the EMC directive
(2004/108/EC), do not detach the plug from
the power cord.
Your product contains batteries covered by the
European Directive 2006/66/EC, which cannot
be disposed with normal household waste.
Please inform yourself about the local rules
on separate collection of batteries because
correct disposal helps to prevent negative
consequences for the environmental and
human health.
Copyright in the U.K.
•
Recording and playback of material may
require consent. See Copyright Act 1956
andThe Performer’s Protection Acts 1958
to 1972.
Help and support
com/support to:
Care for your product
•
•
•
download the user manual and the quick
start guide
watch video tutorials (available only for
selected models)
find answers to frequently answered
questions (FAQs)
Use only microfiber cloth to clean the product
Care of the environment
•
•
email us a question
chat with our support representative.
Follow the instructions on the website to select
your language, and then enter your product
model number.
Alternatively, you can contact Consumer Care
in your country. Before you contact, note down
the model number and serial number of your
product.You can find this information on the
back or bottom of your product.
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
EN
4
Download from Www.Somanuals.com. All Manuals Search And Download.
2 Your SoundBar
Remote control
This section includes an overview of the
remote control.
Congratulations on your purchase, and
welcome to Philips!To fully benefit from
the support that Philips offers, register your
a
Main unit
AUX
COAX
b
c
j
This section includes an overview of the main
unit.
AUDIO-
IN
OPTICAL
i
h
BASS
VOLUME
TREBLE
SURR
g
f
d
e
a
b
a SURR indicator
Lights up when you selectVirtual Surround
sound.
b Source indicators
Source indicator lights up when a source
is selected.
•
•
•
•
COAXIAL: Lights up when you switch
to coaxial input source.
OPTICAL: Lights up when you switch
to optical input source.
AUX: Lights up when you switch to
analog input source.
AUDIO-IN: Lights up when you switch
to audio input source (3.5mm jack)
a
(Standby-On)
Switch the SoundBar on or to standby.
b COAX
Switch your audio source to the coaxial
connection.
c OPTICAL
Switch your audio source to the optical
connection.
5
EN
Download from Www.Somanuals.com. All Manuals Search And Download.
d TREBLE +/-
Increase or decrease treble.
Rear connectors
e SURR
Toggle between stereo and virtual
surround sound.
f
Mute or restore volume.
d
g BASS +/-
Increase or decrease volume.
a
h VOLUME +/-
Increase or decrease volume.
b
c
i AUDIO-IN
Switch your audio source to audio input
connection (3.5mm jack).
j AUX
Switch your audio source to the AUX
a AUDIO IN-AUX
connection.
Connect to an analog audio output on the
TV or an analog device.
Connectors
b DIGITAL IN-COAXIAL
Connect to a coaxial audio output on the
TV or a digital device.
This section includes an overview of the
connectors available on your SoundBar.
c DIGITAL IN-OPTICAL
Connect to an optical audio output on the
TV or a digital device.
Side right
d AC MAINS~
Connect to the power supply.
a
a AUDIO-IN
Audio input from an MP3 player (3.5mm
jack).
EN
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Option 2: Connect audio through a
digital coaxial cable
3 Connect
Good quality audio
This section helps you connect your SoundBar
to aTV and other devices.
For information about the basic connections of
your SoundBar and accessories, see the quick
start guide.
Note
• For identification and supply ratings, refer to the type
plate at the back or bottom of the product.
• Before you make or change any connections, make sure
that all devices are disconnected from the power outlet.
1 Using a coaxial cable, connect the
COAXIAL connector on your SoundBar
to the COAXIAL/DIGITAL OUT
connector on theTV or other device.
•
The digital coaxial connector might be
labeled DIGITAL AUDIO OUT.
Connect audio fromTV and
other devices
Option 3: Connect audio through
analog audio cables
Play audio fromTV or other devices through
your Soundbar speakers.
Use the best quality connection available on
yourTV, Soundbar, and other devices.
Basic quality audio
1 Using an analog cable, connect the AUX
connectors on your SoundBar to the
AUDIO OUT connectors on theTV or
other device.
Option 1: Connect audio through a
digital optical cable
Best quality audio
DVD
TV
1 Using an optical cable, connect the
OPTICAL connector on your SoundBar to
the OPTICAL OUT connector on theTV
or other device.
•
The digital optical connector might be
labeled SPDIF or SPDIF OUT.
7
EN
Download from Www.Somanuals.com. All Manuals Search And Download.
Equalizer
4 Use your
SoundBar
Change the high frequency (treble) and low
frequency (bass) settings of the SoundBar.
1 Press TREBLE +/- or BASS +/- to change
the frequency.
This section helps you use the SoundBar to play
audio from connected devices.
» All Source indicators on the main unit
blink twice when treble or bass is set
to the maximum or minimum value.
Before you start
•
Make the necessary connections described
in the quick start guide and the user
manual.
MP3 player
•
Switch the SoundBar to the correct source
for other devices.
Connect your MP3 player to play your audio
files or music.
What you need
Adjust the volume
•
•
An MP3 player.
A 3.5mm stereo audio cable.
1 Press VOLUME +/- to increase or
1 Using the 3.5mm stereo audio cable,
connect the MP3 player to the AUDIO-IN
connector on your SoundBar.
decrease a volume level.
•
•
To mute sound, press (MUTE).
To restore the sound, press (MUTE)
again or press VOLUME +/-.
2 Press AUDIO-IN.
» All Source indicators on the main unit
blink twice when a volume is set to the
maximum or minimum value.
3 Press the buttons on the MP3 player to
select and play audio files or music.
Auto standby
Choose your sound
When playing media from a connected device,
the SoundBar automatically switches to standby
if:
This section helps you choose the ideal sound
for your video or music.
•
•
no button is pressed for 30 minutes, and
no audio play from a connected device.
Surround sound mode
Experience an immersive audio experience with
surround sound modes.
Apply factory settings
1 Press SURR to select a surround mode.
•
[Virtual Surround]: Creates a highly
surround listening experienceThe
SURR indicator on the main unit lights
up.
You can reset your SoundBar to the default
settings programmed at the factory.
1 In mute mode, quickly press AUX twice.
» The factory settings is restored.
•
[Stereo]:Two-channel stereo sound.
Ideal for listening to music.
EN
8
Download from Www.Somanuals.com. All Manuals Search And Download.
5 Wall mount
Note
• Improper wall mounting may result in accident, injury or
damage. If you have any query, contact Consumer Care
in your country.
• Before wall mounting, make sure the wall can support
the weight of your SoundBar.
Screw length/diameter
Depending on the type of wall mounting your
SoundBar, make sure that you use screws of a
suitable length and diameter.
3 - 3.5mm
> 25mm
For information about how to wall mount your
SoundBar, see the quick start guide.
9
EN
Download from Www.Somanuals.com. All Manuals Search And Download.
6 Product
specifications
Note
• Specifications and design are subject to change without
notice.
Amplifier
•
•
•
•
Total output power: 40W RMS (+/- 0.5 dB,
10%THD)
Frequency response: 20 Hz-20 kHz /
±3 dB
Signal-to-noise ratio: > 65 dB (CCIR) /
(A-weighted)
Input sensitivity:
•
•
AUX: 650 mV
AUDIO-IN: 400 mV
Audio
•
S/PDIF Digital audio input:
•
•
Coaxial: IEC 60958-3
Optical:TOSLINK
Main unit
•
Power supply: 220-240V~, 50 Hz
•
•
•
•
•
Power consumption: 40 W
Standby power consumption: ≤ 0.5 W
Speaker impedance: 8 ohm (full range)
Speaker drivers: 4 x 54.5 mm (2")
Dimensions (WxHxD):
845 x 74.5 x 94 mm
•
Weight: 2.0 kg
Remote control batteries
•
1 x CR2025
EN 10
Download from Www.Somanuals.com. All Manuals Search And Download.
7 Troubleshooting
Warning
• Risk of electric shock. Never remove the casing of the
product.
To keep the warranty valid, never try to repair
the product yourself.
If you have problems using this product, check
the following points before you request service.
If you still have a problem, get support at www.
philips.com/support.
Sound
No sound from SoundBar speakers.
•
Connect the audio cable from your
SoundBar to yourTV or other devices.
Reset your SoundBar to its factory settings.
On the remote control, select the correct
audio input.
•
•
•
Make sure that the SoundBar is not muted.
Distorted sound or echo.
•
If you play audio from theTV through the
SoundBar, make sure that theTV is muted.
11 EN
Download from Www.Somanuals.com. All Manuals Search And Download.
8 Notice
This section contains the legal and trademark
notices.
Compliance
This product complies with the radio
interference requirements of the European
Community.
Trademarks
Manufactured under license from Dolby
Laboratories. Dolby and the double-D symbol
are trademarks of Dolby Laboratories.
EN 12
Download from Www.Somanuals.com. All Manuals Search And Download.
2013 © WOOX Innovations Limited.All rights reserved.
Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and
are used by WOOX Innovations Limited under license from Koninklijke Philips N.V.
HTL2100_12_UM_V7.0
Download from Www.Somanuals.com. All Manuals Search And Download.
|