Pentax GPS Receiver WG 2 User Manual

Before using GPS  
other type of navigation, or for surveying. PENTAX will not be held  
liable for any damages caused by use of this camera for any of the  
purposes mentioned above.  
Precautions for using GPS  
• The GPS function is set to off as the default. To use it, set [GPS On/  
Off] to [On].  
• GPS satellites always move. Depending on the situation (location,  
time etc.), positioning may take longer or be impossible.  
• To use the GPS function, you must be in an open area, such as out of  
doors.  
About GPS  
Hereby, PENTAX RICOH IMAGING CO.,LTD., declares that this  
SG661 GPS Module/GYSFDMASA-P1 is in compliance with the  
essential requirements and other relevant provisions of Directive 1999/  
5/EC.  
GPS means Global Positioning System. The camera receives signals  
from GPS satellites to determine its position and the time. This is called  
"positioning".  
• Positioning may be difficult or impossible in the following situations:  
- Under the water  
- Under the ground or indoors  
- In tunnels  
- Among high-rise buildings  
For a full version of the Declaration of Conformity (DoC), please refer to  
Utilities Guide for GPS  
Function of Optio WG-2 GPS  
The CE Mark is a Directive conformity mark of the European Union.  
Location of where images are shot can be recorded  
The latitude and longitude etc., of still pictures or movies can be  
recorded. You can see the positions of images you shot on a map by  
using the provided software.  
- Under elevated or near high-voltage electrical power lines  
- In the woods  
- Near mobile phones that use the 1.5 GHz band  
• When the GPS function is set to on, the camera performs positioning  
regularly even if it is turned off. Make sure to set [GPS On/Off] to [Off]  
(p.5) before turning off the camera when taking it where using  
electronic products is prohibited, such as hospitals or airplanes.  
• Positioning may take few minutes when using the GPS function for the  
first time, after not positioning for a long while, or after changing the  
battery.  
• The Geodetic system for this camera’s GPS function uses the World  
Geodetic System 1984 (WGS 84).  
• Using GPS or recording the positions of images you shot is prohibited  
in some countries or regions. Consult appropriate embassy or travel  
agent before travelling with a GPS camera.  
Before using GPS .......................................2  
Using the GPS .............................................5  
Saving log files  
The camera receives information from GPS satellites regularly and  
saves it to the SD Memory Card as a log file in KML format. The log files  
can be imported to Google Earth or Google Maps or other programs that  
can read KML files on your computer and you can display your locations  
on their maps.  
*Google, Google Earth and Google Maps are trademarks of Google Inc.  
Correct the clock using GPS information  
The camera corrects its clock automatically using time data received  
from GPS satellites.  
This manual describes how to use the Optio WG-2 GPS camera’s GPS function  
and precautions when using it. Please read this manual before using the GPS  
function with this camera.  
• Do not carry the camera in a metal container during positioning. If the  
camera is covered with metal, the positioning function cannot work.  
• In the following situations, the camera cannot receive GPS  
information. It starts positioning again immediately after being  
removed from the following situations:  
- When the alarm is set  
-
When the camera is connected to a computer with a USB cable  
- When the camera is connected to AV equipment with an AV or HDMI  
cable  
- For a minute after changing the battery  
54565  
R02BAB12  
• GPS function of this camera was designed and manufactured for  
personal digital camera use only. Do not try to use it as a navigation  
instrument for an aircraft, motor vehicle, personal navigation or any  
Printed in Indonesia  
3 㧙  
4 㧙  
2 㧙  
Using the GPS  
Displaying the GPS information recorded on captured image  
Record the GPS Information on Captured Images  
Recording and Saving a Log  
When [GPS On/Off] is set to [On], the received GPS information is  
recorded onto captured images.  
The following icons appear on the display.  
Receives GPS information with interval and duration you have set and  
records it to the camera as a log.  
1
Press the Q button after shooting still pictures or  
movies.  
Preparation for Using GPS Function  
The recorded log can be saved to the SD Memory Card as a log file (KML  
format).  
The camera enters Q mode and the image appears on the display.  
Set the [GPS On/Off] to [On] for receiving GPS information (latitude,  
longitude, altitude, date and time etc.).  
During receiving GPS information. [GPS On/Off] on the [GPS] setting is  
set to [On], and signals from GPS satellites are being received.  
(White)  
2
Press the 4 button until the  
GPS information is displayed.  
-
100 0038  
Recording a Log at a Set Interval and Duration  
When the GPS information is recorded on captured images (p.6) and  
recorded to the camera as a log (p.8), saved to the SD Memory Card as  
a log file (p.10) or the camera corrects its clock automatically (p.14),  
[GPS On/Off] need to be set to [On].  
GPS information has been received. [GPS On/Off] on the [GPS] setting is  
set to [On], and signals from GPS satellites have been received.  
If the camera did not receive GPS  
information, the values are displayed  
as “--“.  
1
Use the four-way controller (23) to select [GPS] on the  
[WSetting] menu.  
GPS information has not been received. [GPS On/Off] on the [GPS]  
setting is set to [On], but signals from GPS satellites have not been  
received.  
02 / 02/'12 06: 25: 00  
GPS  
N
35 45' 52"  
(Red)  
W
139 41' 29"  
Edit  
*The positioning time is displayed in  
GPS time (time data received from  
GPS satellites). This may be different  
from the time you have set on the  
camera.  
2
3
Press the four-way controller (5).  
1
Use the four-way controller (23) to select [GPS] on the  
[WSetting] menu.  
GPS error. To recover from an error, turn off the camera, remove and then  
re-insert the battery and turn on the camera again. If  
Positioning  
time  
Positioning  
latitude and  
longitude  
The [GPS] screen appears.  
is still displayed,  
the built-in GPS unit may be malfunctioning. Contact your nearest  
PENTAX Service Center.  
Use the four-way controller  
(23) to select [GPS  
Logging].  
GPS  
2
3
4
5
Press the four-way controller (5).  
When [GPS On/Off] is set to [Off], no icon is displayed.  
GPS On/Off  
On  
Off  
The [GPS] screen appears.  
GPS Logging  
• Only when is displayed on the capture mode screen, the GPS  
information is recorded onto images.  
The image on which the GPS information is recorded can be imported to the  
supplied software "MediaImpression 3.5 for PENTAX" and the position at which  
the image was shot can be displayed on the map (Windows only.)  
Use the four-way controller (23) to select [GPS On/  
Off].  
If you cannot select this menu, set  
[GPS On/Off] to [On].  
GPS Time Sync  
• When [GPS On/Off] is set to [On], the camera performs positioning  
regularly even if it is turned off, which reduces the battery life.  
MENU  
Select an image in the preview screen and click  
to display map.  
(position) on [Property] area  
Press the four-way controller (5).  
4
5
Press the four-way controller (5).  
A pull-down menu appears.  
*To display map, you need to connect to the Internet.  
• When recording GPS information onto a movie, the data at the start of  
recording is saved.  
The [GPS Logging] screen appears.  
1 [Media Browser Interface] (Operating Manual p.209)  
Use the four-way controller  
(23) to select [Off] or [On].  
GPS  
• When dividing a movie, the GPS information before dividing is  
displayed.  
Use the four-way controller  
GPS Logging  
Record log  
Off  
On  
GPS On/Off  
(23) to select [Record log],  
and press the four-way  
controller (5).  
Off: Does not receive GPS  
information  
On: Receives GPS information  
GPS Logging  
GPS Time Sync  
• When adding a title picture to a movie, the GPS information of the  
movie is displayed.  
Save log data  
Off  
Discard log data  
• When shooting in (Interval Shot) mode, GPS information may not  
be recorded onto images.  
MENU  
Cancel  
OK  
OK  
The [Record log] screen appears.  
MENU  
• When [GPS On/Off] is set to [On], the camera performs positioning  
regularly even if it is turned off, which reduces the battery life.  
The guide of battery life: Approx. 60 hr.  
(When [GPS On/Off]: [On], [Logging Interval]: [15 sec.] and the  
camera is turned off to receive GPS information continuously.)  
• Before changing the battery, set [GPS On/Off] to [Off].  
6
Use the four-way controller (23) to select [Logging  
Interval], and press the four-way controller (5).  
A pull-down menu appears.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
5 㧙  
6 㧙  
7 㧙  
8 㧙  

Paxar Printer TCMPCL2PR User Manual
Philips Cassette Player AQ6512 01Z User Manual
Philips Cordless Telephone VOIP8410 User Manual
Philips Projection Television 25PT522B User Manual
Playskool Portable Radio 06095 User Manual
PMC Sierra Network Card PM5347 User Manual
Polaroid Security Camera IP100 User Manual
Poulan Trimmer 545212831 User Manual
ProForm Exercise Bike 831215211 User Manual
PYLE Audio Blu ray Player PLTTB9U User Manual