Pelican Home Safety Product StealthLite2400 User Manual

TM  
PELICAN  
LAMP REPLACEMENT  
BATTERY INSTALLATION  
1. Remove lens housing by turning counter-  
clockwise.  
1. Remove lens housing by turning counter-clockwise.  
2. Remove the lamp and contact module.  
3. Replace the contact module and lamp.  
4. Replace lens housing squarely on threads and turn  
clockwise while pressing on the lens housing  
slightly.  
TM  
2. Remove the lamp and contact module.  
3. Remove used batteries and replace with fresh  
batteries as shown on the outside of the  
engraved body.  
4. Replace the contact module and lamp.  
5. Replace lens housing squarely on threads and  
turn clockwise while pressing on the lens hous-  
ing slightly.  
StealthLite 2400  
23215 Early Ave. • Torrance, CA 90505 USA  
Tel (310) 326-4700 • FAX (310) 326-3311  
Cat. #2400  
TM  
PELICAN CANADA  
10221-184 St. • Edmonton, Alberta T5S 2J4  
Tel (780) 481-6076 • FAX (780) 481-9586  
PRODUCT SPECIFICATIONS  
Lamp Type:  
Battery Type:  
Battery Brand:  
Xenon  
4 AA Cell Alkaline (Included)  
Eveready® Energizer®  
TM  
PELI PRODUCTS, S.L.U.  
ON/OFF  
c/ Casp, 33-B Pral. • 08010 • Barcelona, Spain  
Tel (+34) 93.467.4999 • FAX (+34) 93.487.7393  
REPLACEMENT PARTS  
Swing the switch lever to the right (light facing away  
from you) until light activates. To turn light off, swing  
the switch lever to the left (light facing away from  
you) until light goes off.  
SUBMERSIBLE  
CAT #  
2401  
2404  
DESCRIPTION  
O-RING  
LAMP MODULE  
© PELICAN PRODUCTS 2010  
2403-311-001 5-0697 Rev A AU/10  
All trademarks and logos displayed herein are registered and unregistered  
trademarks of Pelican Products, Inc. and others.  
CAUTION: Read This Notice Before Use.  
Hydrogen Gas Absorber Pellets  
WARNING – Explosion Hazard - Batteries must  
only be changed in non-hazardous locations  
Eveready and Energizer are registered trademarks of Eveready Battery Company, Inc.  
Located inside the flashlight are catalyst pellets which  
are present to absorb hydrogen gas that could possibly  
be emitted by defective, leaking, reversed polarity or  
heavily discharged batteries. If the pellets become wet,  
let them air dry. Pelican Products assumes no liability  
for any brand batteries which are defective or cause  
injury to anyone when used in any Pelican flashlight.  
23215 Early Ave. • Torrance, CA 90505 USA  
Tel (310) 326-4700 • FAX (310) 326-3311  
WARNING –  
Explosion Hazard - Substitution of components  
may impair suitability for use in hazardous locations  
TM  
PELICAN CANADA  
10221-184 St. • Edmonton, Alberta T5S 2J4  
Tel (780) 481-6076 • FAX (780) 481-9586  
CAUTION:  
If light is not to be used for some time, remove  
batteries to prevent possible leakage and corrosion.  
TM  
WARNING! STATIC HAzARD - clean only with a  
damp cloth  
PELI PRODUCTS, S.L.U.  
c/ Casp, 33-B Pral. • 08010 • Barcelona, Spain  
Tel (+34) 93.467.4999 • FAX (+34) 93.487.739 • www.peli.com  
Advertencia - Peligro de explosión - Las baterías  
sólo deben sustituirse o cargarse en zonas no peli-  
grosas.  
TM  
StealthLite 2400  
PELICAN LEGENDARY LIFETIME  
GUARANTEE OF EXCELLENCE  
Battery Replacement  
Cat. #2400  
Do not mix battery brands or use Nicad or zinc  
Carbon Batteries. Do not mix old and new batteries.  
Replace all batteries at the same time.  
Pelican Products, Inc. guarantees its products for a  
lifetime against breakage or defects in workmanship.  
This guarantee does not cover the lamp or batteries  
(rechargeable or alkaline). Any liability, either expressed  
or implied, is limited to replacement of the product.  
This guarantee is void if the Pelican product has been  
abused beyond normal and sensible use.  
INSTRUCCIONES DE FUNCIONAMIENTO  
PRECAUCION:  
INSTALACION DE LAS PILAS  
Si no se va a usar la linterna por algún tiempo, retire  
las pilas para evitar la posibilidad que ocurra una  
fuga y corrosión.  
Lamp Replacement  
Lamp replacement may only be performed  
in a non-hazardous area.  
1. Retire el bastidor de la lente girándolo en  
sentido contrario de las agujas del reloj.  
2. Retire el módulo de la bombilla y el contacto.  
3. Saque las pilas gastadas y sustitúyalas por pilas  
nuevas tal y como se indica en la parte exterior del  
cuerpo de la linterna.  
4. Vuelva a colocar el módulo de la bombilla y el  
contacto.  
5. Vuelva a colocar el bastidor de la lente sobre la  
rosca y gire en el sentido de las agujas del reloj al  
mismo tiempo que ejerce un poco de presión sobre  
el mismo.  
This guarantee does not cover shark bite, bear attack or  
damage caused by children under five.  
REEMPLAZO DE LA BOMBILLA  
1. Retire el bastidor de la lente girándolo en  
sentido contrario de las agujas del reloj.  
DO NOT MODIFY THIS PRODUCT!  
Lifetime Guarantee does not cover Roto Molded or  
for full details.  
2. Retire el módulo de la bombilla y el contacto.  
WARRANTY RETURN POLICY  
Send all items for repair or replacement directly to  
Pelican Products Customer Service Department  
(postage paid). Please call for a return authorization  
number. Per our guarantee, Pelican Products will  
replace or repair any broken or defective products.  
Upon receipt of goods, Pelican Products will notify  
you of any handling and return postage charges.  
If your local retailer does not stock the above acces-  
sory parts, you may order them directly from Pelican  
Products. Send check or money order in U.S. dol-  
lars, or order by phone using MasterCard or VISA  
(ask for Customer Service). SORRY, NO C.O.D.’s.  
Subject to sales tax. Allow 2-3 weeks delivery time.  
Pelican Products pays postage and handling charg-  
es. POSTAGE PAID FOR U.S. zIP CODES ONLY.  
3. Vuelva a colocar el módulo de la bombilla y el  
contacto.  
4. Vuelva a colocar el bastidor de la lente sobre la  
rosca y gire en el sentido de las agujas del reloj  
al mismo tiempo que ejerce un poco de presión  
sobre el mismo.  
ENCENDIDO / APAGADO  
Para encender la linterna (con el extremo de la bombilla  
apuntando en la dirección opuesta a usted), gire la  
palanca del interruptor hacia la derecha hasta que se  
encienda. Para apagarla, gire la palanca del interrup-  
tor hacia la izquierda (con el extremo de la bombilla  
apuntando en la dirección opuesta a usted), hasta que  
se apague.  
ESPECIFICACIONES DEL PRODUCTO  
Tipo de bombilla:  
Xenón  
Tipo de pila:  
4 AA Cell Alkaline (Included)  
Marca de las pilas: Energizer® de Eveready®  
Advertencia - Peligro de explosión - La sustitución  
de componentes puede afectar a la idoneidad de su  
uso en zonas potencialmente explosivas.  
PIEZAS DE REPUESTO  
NO. DE CAT.  
DESCRIPCION  
2401  
Junta tórica  
2404  
Módulo de la bombilla  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Philips Cordless Telephone XL370 User Manual
Philips DVR HDT 8520 User Manual
Philips Headphones SBC HL300U User Manual
Philips Headphones SHC2000 User Manual
Philips Universal Remote SRU3004 User Manual
Pioneer Car Video System DEH 11E User Manual
Planar Film Camera A480 PL User Manual
Polaroid Digital Camera captiva SLR User Manual
Poulan Chainsaw 1950 1975 2055 2050 2075 2150 2155 2175 2350 2375 2150PR LE Series User Manual
Poulan Tiller PPFT55 User Manual