C1957M (3/99)
RM2001 Series
VCR Rack Mount
®
IMPORTANT SAFEGUARDS AND WARNINGS
Prior to installation and use of this product, the following WARNINGS should be observed.
3500 Pelco Way
Clovis, CA 93612-5699
USA
1. Installation and servicing should be done by qualified installation and service personnel
only.
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
2. Installation should be done according to all local and national electrical and mechanical
codes, using only approved materials.
International Customers:
Tel (1-559) 292-1981
FAX (1-559) 348-1120
3. Use only installation methods and materials capable of supporting four times the
maximum weight of the VCR and rack mount.
Please thoroughly familiarize yourself with the information in this manual prior to installation
and operation.
DESCRIPTION
The RM2001 Rack Mount holds a single Pelco TLR Series VCR. This versatile rack mount will
fit any standard 19-inch (48.26 cm) wide console or rack configuration. The RM2001SD model
is the same as the RM2001, but is supplied with a lockable security door (not installed) having
a smoked Lexan® window. The rack mounts have a black polyester powder coat finish.
MODELS
RM2001
RM2001SD
Rack mount for TLR Series VCR. Does not include front door.
Rack mount for TLR Series VCR. Includes locking front door.
INSTALLATION
To install the RM2001 Series VCR Rack Mount:
NOTE: A security door (item 1),
backstop bracket (item 2), and
five 6-32 Phillips screws (item 3)
are shipped as loose equipment
for the RM2001SD model (refer
to Figure 1). The backstop
Steps 1 and 2 apply to both the RM2001 and RM2001SD VCR Rack Mounts:
1. Place the rack mount in the console or equipment rack, align the mounting holes, and
insert and tighten the required fasteners (not supplied).
2. Set the VCR into the rack mount, pushing it back until it stops at the backstop bracket
(RM2001 model) or the rear lip of the rack mount base (RM2001SD model).
bracket should be installed in the
hole provided in the rear of the
rack mount base whenever the
rack mount will be used with-
out the security door. If the
backstop bracket is installed
when using the security door,
the VCR will protrude and not
allow the door to close.
Step 3 applies to the RM2001SD VCR Rack Mount only:
3. Attach the security door (item 1) to the front of the rack mount with four 6-32 Phillips
screws (item 3). Refer to Figure 1 and Table A.
3
SHIPPED LOOSE
2
2
FOR RM2001SD
RM2001
INSTALLED
FOR RM2001
Table A. RM2001SD VCR Rack Mount
Loose Parts List
Item Qty
Description
Security door
Backstop bracket (see note)
Phillips screws, 6-32 x 1/4 in.
1
2
3
1
1
5
3
1
Figure 1. RM2001 Series VCR Rack Mount
Download from Www.Somanuals.com. All Manuals Search And Download.
|