Refer to the Symbol Web site
Application Programming Interface
(API) documentation. Refer to the
3Comâ /Palm Computing Web site
about the Palm IIIä series of
organizers.
C o n n e c t i n g t h e P r i n t e r
2. Drop the supply into the well. Make
sure the supply unwinds from the
top as shown.
O P E R A T I N G
Attach the organizer to the printer's
10-pin connector as shown.
I N S T R U C T I O N S
Use these operating instructions with
your Monarchâ 6015ä Printer. The
printer works with the Symbolâ SPT
1500 or the Palm IIIä series of
organizers. With these Palm
Computingâ connected organizers, the
printer can print receipts for retail,
health care, or industrial environments.
Palm Computing is a subsidiary of
3Comâ Corporation.
Platen Roller
10-Pin Connector
P o w e r i n g t h e P r i n t e r
The printer is powered by four (4) AA
batteries (not included). To replace the
batteries, see "Replacing the Batteries."
You can also use the optional AC power
adapter. The adapter must be
The printer can print text, bar codes,
and some limited graphics on thermal
direct receipt paper.
purchased separately.
3. Make sure some supply extends
Rechargeable batteries are preferred
over alkaline batteries.
If your organizer has a flip cover,
remove the cover before inserting
the organizer into the printer.
Use these instructions to
past the platen roller.
¨
¨
¨
¨
connect the printer
load supplies
4. Close the supply cover.
If using the optional power adapter,
plug the connector into the socket.
Plug the other end of the cable into a
grounded electrical outlet.
replace the batteries
clean the printhead.
L o a d i n g S u p p l i e s
C l e a n i n g
CAUTION
1. Open the supply cover by pressing
down with your thumbs and pulling
up with your index fingers.
The printer comes packaged with two
rolls of supply (one already loaded in
the printer). Batteries are not included.
Do not use sharp objects to clean
the printhead. This may damage the
printer and require a service charge.
Power connector
goes here
You may need to clean the printhead
and platen roller
P r o g r a m m i n g I n f o r m a t i o n
You may need to refer to the
¨
after printing approximately six rolls
of supply
Programmer's Manual available from
our Web site or in a printed version by
ordering part number TC6015PM. It
provides an explanation of how to use
the printer's command language.
¨
¨
whenever you load new supplies
when you see voids in the print.
1. Open the supply cover by pulling
back firmly on the supply cover.
Supply Cover
Strap
2. Remove the supply roll (when
cleaning the printhead).
TC6015OI Rev. AB 3/01
ã 2001
Monarch Marking Systems, Inc. All rights reserved.
Download from Www.Somanuals.com. All Manuals Search And Download.
|