WIRELESS INFRARED SURROUND HEADPHONE
PLVWH1
Download from Www.Somanuals.com. All Manuals Search And Download.
Precautions
* Operate the transmitter on 12V 100mA. Operate the headphone
system on3V DC (size AAAbatteries x 2).
* Turn off the power of the transmitter and the system is not in use.
* Do not open the cabinet. Refer servicing to qualified personnel
only.
* Do not leave the system in a location near heat sources such as
radiators or airducts, or in a place subject to direct sunlight,
excessive dust, moisture, rain, mechanical vibrantion, or shock.
* Do not use alcohol, benzine or thinner to clean the cabinet.
Headphone
1. Infrared sensors
2. Power Switch
3. Stereo / mono
4. Volume Controls
5. Battery Compartment Door
6. Ear pad
7. Adjustableheadband
IR Stereo Headphone
1. Open the battery compartment door on the right of the
headphone.
2. Insert two size AAAbatteries with correct polarity.
3. Close the battery compartment.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
How to use
1. Turn on the audio/video equipment
connected to thetransmitter.
2. Turn on the power switch for
headphone.
4. Turn on the stereo switch for
stereo effect. For Mono
3. Adjust volume control on the
left side. Do not cover the sensors
while adjusting volumes.
audio/video equipment, turn
the switch to the mono position.
5. Receiving Positions
The headphon/Receiver receives audio signals omni-directionally
and in line-of-sight within certain effective ranges.
For best reception, use th headphone. within 5 meters from the emitter
of the transmitter.
Specifications:
* POWER REQUIREMENTS: 3VDC (1.5V AA x 2)
* TYPE: OPEN AIR DYNAMIC
* DRIVE UNIT: 40 mm MYLAR CONE
* IMPEDANCE: 32 OHM +-6.4 OHM
* FREQUENCY RESPONSE: 20 Hz ~ 23 KHz
* S.P.L.: 98 dB / NOM. DEV
* DISTORTION: 1 PERCENT THD AT NOM. DEV.
* BATTERY LIFE (AT 10mv OUTPUT): ABOUT 48 HOURS
WEIGHT: ABOUT 170 gr. (EXCLUDING BATTERIES)
3
Download from Www.Somanuals.com. All Manuals Search And Download.
|