INSTALLATION
DASH BOARD
METAL MOUNTING STRAP
HEX NUT
SPRING WASHER
CONSOLE
SLIDE BRACKET HOUSING
PLAIN WASHER
PLAIN WASHER
TAPPING SCREW
PLCD26
HEX BOLT
INSTRUCTION MANUAL
KEY PLATE
OPEN
CD/RECEIVER&ACTIVE DISPLAY
COMPACT
PLASTIC TRIM OUT
HOUR
DIGITAL AUDIO
MIN
KEY PLATE
TUNE
SEL
+
INT
MO
RPT
LOC
RDM
LUD
VOL
-
BD
PWR
MU
CLK
EQ
160WATTS
ANTI-THEFT FLIP DOWN DETACHABLE SYSTEM
AUTO-LOADING COMPACT DISC PLAYER
Please remove both bolts
which protect the core before
use.
AM/FM STEREO WITH MANUAL TUNING RADIO
7
Download from Www.Somanuals.com. All Manuals Search And Download.
TREBLE CONTROL
TROUBLE SHOOTING
a. Press the SEL button to select the treble mode until TRE appears on the display.
b. Press + or - to adjust the treble effect.
Before going through the check list, wiring connection, should any of the
problem persist after check list has been made, consult your nearest service
dealer.
BALANCE CONTROL
a. Press the SEL button to select the balance mode until BAL appears on the display.
b. Press the + button or - button to increase or decrease the sound level of
left or right speaker.
Symptom
No power
Cause
Solution
FADER CONTROL
The car ignition is not on.
If the power supply is properly
connected to the car accessory
switch the ignition key to " ACC "
a. Press the SEL button to select the fader mode until FAD appears on the display.
b. Press the + button or - button to increase or decrease the sound level of
front or rear speaker.
The fuse is blown
Replace the fuse
Presence of CD disc inside
the player
Remove the disc in the player
then put a new upward
Disc cannot
be loaded or
ejected
4. LCD ( LIQUID CRYSTAL DISPLAY)
Inserting the disc in upside
down
Insert the compact disc with
the label facing upward
5. TUNING BUTTON
During tuner mode, rotate it to select your desired radio broadcasting
station within FM/MW.
Compact disc is extremely
dirty or defective
Clean the disc or try to play a
new one
Temperature inside the
car is too high
Cool off until the ambient
temperature returns to normal
6. OPEN BUTTON
Condensation
Leave the player off for an
hour or so, then try again
Press it to flip down the front panel when you want to take away.
Press it to flip down the front panel then you can insert a disc into the
compartment or eject the disc by pressing the EJ button.
Volume is in minimum
Adjust volume to a desired level
No sound
Wiring is not properly
connected
Check wiring connection
7. POWER BUTTON
Press it to turn on or off the unit.
The installation angle
is more than 30 degrees
Adjust the installation angle
to less than 30 degrees
Sound skips
The disc is extremely
dirty or defective
Clean the compact disc/try to
play a new one
8. BAND BUTTON
At CD mode, press it to switch tuner mode.
Press it to select your desired radio band and the band which is selected
will be displayed on LCD.
The radio does
not work
Insert the antenna cable firmly
select a station manually
The antenna cable is not
connected
the signals are too weak
9. MUTE BUTTON
Press it to eliminate the sound temporarily when you need, press it again
to resume normal play state.
10. MO/INT BUTTON
MO MODE: Press it to select mono or stereo mode.
INT MODE:
During CD mode, press " INTRO "button to hear the first 10 seconds
of each track on the disc. Press this button again to restore the
player to its normal play mode.
Download from Www.Somanuals.com. All Manuals Search And Download.
11. LOC/RPT BUTTON
LOCAL/DISTANCE MODE:
DISC PLAY:
When in the radio mode, press them to select local or distance broadcast
station receive sensitivity. The word LOC will appear on LCD during local
state.
Attention: During AM mode, LOC is non-functional.
Cleaning discs
Before playing, clean the disc with a clean, lint-free.
Flip the disc in the direction of the arrow.
REPEAT MODE:
During CD mode. Press RPT button to repeat a single track.
12. LUD/RDM BUTTON
LUD MODE:
When reduce the volume to half level, press it to enhance the bass effect.
RDM MODE:
During CD mode, press " RDM " button and hold for 2 seconds,
it display " RDM " and Random function performs.
NOTE:
. Do not use so solvents such as benzine, thinners. Commercially available
cleaners or anti static spray damage the unit.
13. EQ BUTTON
Insert a disc with the label surface down. Doing so may damage the unit.
Press it to switch between 4 preset equalizer curves: FLAT, POP, CLAS,
ROCK. The sound quality will be changed.
Label
surface up
14. CLOCK ADJUSTMENT BUTTON
During frequency display, press it to change to clock function.
Press the button for more than 2 seconds, until time flashes. and you can adjust
time now.
Press the tune
button or
continually to adjust Hours and Minutes, when
NOTE:
. Do not try to insert another disc when one has been already inserted.
Doing so may damage the unit.
.Handle the disc by its edge. And to keep the disc clean, do not touch
the surface.
adjustment is completed, press CLK button to resume normal play state and retain
the adjustment
IMPORTANT:
MEMORY WIRE ( FOR BACKUP) AND POWER WIRE CAN NOT BE SWITCHED
OFF AT THE SAME TIME, ONCE IT HAPPENS, ALL THE FUNCTION WILL BE
TOTALLY IN DISORDER (DISTORTED DISPLAY IS ALSO INDICATED ).
IF IT REALLY HAPPENS, PLEASE FOLLOW THE INSTRUCTIONS AS MENTIONED
BELOW:
5 MINUTES LATER, PLEASE SWITCH ON THE MEMORY WIRE FIRST (CAN NOT
PASS THROUGH IGNITION SWITCH) AND THEN SWITCH ON THE POWER. IT WILL
RETURN TO NORMAL FUNCTION SOON.
.Do not stick paper or tape on the disc.
.Do not expose the disc to direct sunlight or heat sources such as hot air
ducts. Or leave it in a car parked in direct sunlight where there can be a
considerable rise in temperature.
Download from Www.Somanuals.com. All Manuals Search And Download.
|