Panasonic Impact Driver EY6506 U1 User Manual

ORDER NO.PTD0310U39C1  
F16  
Cordless Impact Driver  
EY6506-U1  
SPECIFICATIONS  
CONTENTS  
Page  
Page  
1 SCHEMATIC DIAGRAM  
2
2
3
4 TROUBLESHOOTING GUIDE  
5 EXPLODED VIEW  
5
7
8
2 WIRING CONNECTION DIAGRAM  
3 DISASSEMBLY/ASSEMBLY INSTRUCTIONS  
6 REPLACEMENT PARTS LIST  
© 2003 Matsushita Electric Works Ltd. All rights  
reserved. Unauthorized copying and distribution is a  
violation of law.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
EY6506-U1  
3 DISASSEMBLY/ASSEMBLY INSTRUCTIONS  
IHOW TO DISASSEMBLE MAIN UNIT.  
Ref. No. 1A  
Procedure 1A  
Removal of the Fixation cover and Housing.  
1. Remove four screws tightened with the fixation cover and take it  
out.  
2. Remove eight housing screws.  
Ref. No. 1B  
Procedure 1A 1B  
Removal and attachment of the Motor.  
(Removal)  
1. Take out the motor with the driving block from housing.  
2. Separate the motor assembly from the driving block.  
3. Take out the motor rotor assembly from the motor stator.  
NOTE :  
Make sure not to damage the magnet by motor rotor.  
(Attachment)  
1. Insert the motor rotor assembly into the stator.  
NOTE :  
Make sure that the motor stator has their own direction for proper  
assembly. If it is assembled wrongly, the rotation may be the  
opposite way.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
EY6506-U1  
Ref. No. 1C  
Procedure 1A 1B 1C  
Removal of the Driving Block.  
1. Remove the thrust plate.  
2. Take out the planet gears and pins slightly tapping the driving block  
on the table.  
Ref. No. 1D  
Procedure 1A 1B 1C1D  
Assembly of the Switch.  
1. Press fit the lead wires firmly.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
EY6506-U1  
4 TROUBLESHOOTING GUIDE  
(Refer to WIRING CONNECTION DIAGRAM)  
< TROUBLE >  
Does not operate.  
< CHECK >  
<CHECK BATTERY PACK.>  
< REMEDY >  
NO Replace battery pack.  
If no less than 12V DC is available across the (+) and (-) terminals,  
the battery pack is OK.  
The battery pack is sold separately as an optional accessory.  
See the nearest sales dealer for details. The battery pack has a  
limited life.  
NOTE:  
The pack should be replaced if;  
-
-
after being charged for the rated charging time the battery voltage  
is less than 12V DC or the usable time is extremely short.  
the battery leaks. Check battery for leaks and terminals for  
corrosion.  
OK  
<CHECK TERMINAL CONNECTIONS BETWEEN MAIN UNIT  
AND BATTERY PACK.>  
NO Repair contacts.  
Check for proper terminal contacts.  
OK  
<CHECK SWITCH BLOCK.>  
NO Contacts in switch block  
(See WIRING CONNECTION DIAGRAM.)  
are defective.  
Replace switch & FET  
block.  
Check continuity between following terminals.  
Inspection of the forward / reverse selection switch.  
When switch handle is depressed all the way:  
*
-
There should be 0between (A) - (D) , and between (B) - (C) ;  
when switch lever is set to forward side.  
-
There should be 0between (A) - (C) , and between (B) - (D) ;  
when switch lever is set to reverse side.  
*
Inspection of the brake.  
When switch handle is not depressed:  
-
There should be 0between (A) - (B) .  
OK  
<CHECK MOTOR BRUSH.>  
NO Replace motor  
brush assembly.  
A. Check the condition of carbon brush.  
(Do not touch between brush holder and holding spring.)  
B. There should be 0between motor lead wire and  
terminal of brush holder.  
OK  
<CHECK MOTOR ROTOR.>  
Check the condition of rotor if there is any wear, crack and deformation.  
NO Replace motor  
rotor assembly.  
OK  
<CHECK MOTOR STATOR.>  
Check the condition of motor case if there is any crack and deformation.  
NO Replace motor  
stator.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
EY6506-U1  
< TROUBLE >  
Does not speed-  
control.  
< CHECK >  
<CHECK FET.>  
< REMEDY >  
NO Repair the contact  
or replace switch  
Even if FET block is defective, it can not be replaced individually.  
Replace whole switch block.  
& FET block.  
Remove the FET circuit block and check the lead wire terminals.  
These terminals are open normally when there is an open circuit (  
between the green and yellow lead wires, and between the blue and  
yellow lead wires.  
)  
NOTE:  
*
FET is weak against static electricity.  
** The resistance value may be some differences depends on the  
measurement range.  
Does not vibrate  
or weakness of  
vibration.  
<CHECK ANVIL.>  
Check wear condition of anvil. If no less than 1mm from  
the corner at (A) side or 0.5mm from the corner at (B) side,  
anvil is OK.  
NO Replace anvil.  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
EY6506-U1  
5 EXPLODED VIEW  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
EY6506-U1  
6 REPLACEMENT PARTS LIST  
NOTE:  
*B=only available as set  
*C=available individually  
Ref.No.  
1
Part No.  
Part Name  
HOUSING AB SET  
CLICK SPRING  
&
Description  
Remarks  
Per Unit  
WEY6506K3078  
EY6481L0177  
WEY6506H4057  
WEY6504L0987  
WEY7300K1167  
WEY6605L0857  
WEY6605L0197  
WEY6404K3717  
WEY6506H3747  
WEY6505L0867  
EY6225L6977  
WEY6506L1127  
WEY574B6967  
WEY6506L1377  
WEY7300L6957  
WEY6506L0877  
WEY6506L0157  
WEY6506L1147  
WEY6506L0317  
WEY6506L0847  
WEY6506L1137  
WEY6506L1357  
WEY6506L1347  
WEY6506L0837  
WEY6506L1067  
WEY6506L1457  
WEY6606L4957  
WEY6506L1467  
WEY6506L1187  
WEY6506L2308  
WEY6506Y3247  
WEY6506Y2007  
EY6261B6027  
WEY6506L0887  
WEY6506K9217  
EY6230K9218  
EY6230L0207  
WEY6505X7928  
WEY6506K8108  
1
1
1
1
1
1
1
1
1
1
1
1
2
1
27  
1
1
1
1
1
1
2
2
1
1
1
1
1
1
1
1
1
2
1
4
8
1
1
1
2
3
FIXATION COVER ASSEMBLY  
O-RING  
4
47  
5
C-TYPE RING  
6
THRUST PLATE  
BIT HOLDER SPRING  
BIT HOLDER  
7
8
9
FIXATION COVER  
SLIDER  
10  
11  
12  
13  
14  
15  
16  
17  
18  
19  
20  
21  
22  
23  
24  
25  
26  
27  
28  
29  
30  
31  
32  
33  
34  
35  
36  
37  
38  
-
STEEL BALL  
3.5  
ANVIL  
STEEL BALL  
*B  
*B  
(2PCS/PK)  
HAMMER  
STEEL BALL  
(27PCS/PK)  
THRUST PLATE  
HAMMER SPRING  
SPRING FIXING PLATE  
DUST PREVENT RUBBER  
THRUST PLATE  
DRIVING SHAFT  
PLANET GEAR  
*B  
*B  
(2PCS/PK)  
(2PCS/PK)  
PIN  
THRUST PLATE  
DRIVING BLOCK  
RING GEAR  
BEARING  
MOTOR ROTOR ASSEMBLY  
STATOR  
BRUSH ASSEMBLY  
F/R SELECTOR HANDLE  
SWITCH  
SEMS SCREW  
*C  
K3-5  
THRUST PLATE  
M-TIGHT SCREW  
TORX TAPPING SCREW  
DUST PREVENTIVE PLATE  
PHILLIPS BIT  
OPERATING INSTRUCTIONS  
*C  
*C  
K4-22  
K3-20  
(+) 65mm  
**Battery Pack, and Tool Case are available as an optional accessory.  
See the nearest sales dealer for details.  
***For replacement parts of charger, see the charger service manual.  
Charger complete set is available as an optional accessory. See the nearest sales dealer for details.  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  

Miele Clothes Dryer T 4423 C User Manual
Multi Tech Systems Network Card RF820 User Manual
NETGEAR Switch XS712T 100NES User Manual
NordicTrack Home Gym NTEVEL59011 User Manual
Nortel Networks Network Router 600r User Manual
Nostalgia Electrics Blender MSH 105 User Manual
Numark Industries DJ Equipment DXM09 User Manual
NuTone Ventilation Hood WHV 30BD WHV 36BD User Manual
Oregon Scientific Thermometer THN122N User Manual
Palsonic Digital Photo Frame DPF8128WH User Manual