®
S I M P L Y
A M A Z I N G
USER’S GUIDE
Compact
Canister
Vacuum
Mo d e ls
BB8 7 0 -ED
BB8 7 0 -Q D
BB8 7 0 -EW
•IMPORTANT•
SAVE THIS BOOKLET!
Includes:
• Safety Warnings
• Parts List
• Operating Instructions
• Accessories List
• Warranty
• Trouble Diagnosis
Download from Www.Somanuals.com. All Manuals Search And Download.
O N/ O FF
Switch
A
1
3
2
4
6
8
B
Stra p
Slot
IMPORTANT: DO NOT
REMOVE the dirt retaining
flap attached on the back of
the front plate. It must be left
in place for the unit to
operate properly and to
ensure cleaning
effectiveness.
SUCTION PORT
Plug cord into electrical outlet.
fig. 1a Insert end of shoulder
strap into slot in front
of on/off power
ADAPTER TUBE
switch. Pull through three to four inches and insert into plastic
clip. One inch of strap must be completely through clip. Insert
other end of strap through slot located at back of handle. Insert
end into clip and pull through. Adjust length by pulling strap
through clip. Strap must go through both front and back clips.
BLOWER
PORT
IMPORTANT: Before using shoulder strap, pull both ends to be sure it is secure.
5
fig. 1b Push the power switch located on handle to the “ON” (I) position.
fig. 2 The flexible hose uses a Shurlock® locking system that
prevents hose removal unless intended. To install hose, align
“J” slot in hose coupling with tab inside the suction port. Insert
hose in port. Twist collar clockwise to lock hose coulping in
port. Twist counterclockwise and pull to remove hose.
The extension wands and cleaning tools supplied with your
Oreck XL Compact Canister Vacuum lock together with
friction. Twist and push to be sure they lock tightly when
installing. Twist and pull to remove.
fig. 3 NOTE: When installing tools directly to blower or suction port
7
without using hose, tool adapter tube must be used.
fig. 4 The blower port is located at the rear of the machine. Installation
of tools is the same as described for suction port.
fig. 5 Locate caddy clip indents at top rear corners of appliance. Place
appliance on firm, nonslip surface or hold in your lap. Grasp
handle firmly. Place end of caddy in outside indent then strongly
push and pull other end of caddy into opposite indent. Be sure
rims on caddy openings face up. Avoid trapping fingers when
caddy snaps on; painful pinch could result. If caddy needs to be
removed, a large flat-head screwdriver inserted under caddy clip
at indent can be used to carefully pry caddy loose.
9
10
12
fig. 6 Pull cord through center opening in caddy and push until it is
seated at back of slot at rear of center opening in caddy.
fig. 7 Insert crevice tool, brush and fabric tool into caddy in spaces provided.
fig. 8 Twist cord dump to easily release stored cord.
11
fig. 9 Use only genuine Oreck XL filter bags. Stand unit on its back. Twist
knob counterclockwise to release front plate. Lift out front plate.
fig. 10 Remove used bag and insert fresh bag. The cardboard rim fits
smoothly into the recessed top.
fig. 9 Replace the front plate and close unit by turning knob clockwise.
WHITE GASKET
MICRO
FILTER
fig. 11 IMPORTANT: The white gasket glued in the housing must be in
place or unit will not operate properly. Replace if needed.
Stand unit on its back.
fig. 9 Stand unit on its back. Twist knob and lift out front plate.
fig. 10 Remove disposable bag.
fig. 12 Remove old filter from bottom inside unit. Replace with new filter.
A replacement filter is supplied in each package of 12 Oreck XL filter
3
Download from Www.Somanuals.com. All Manuals Search And Download.
bags or you may order filters separately.
ORECK MANUFACTURING COMPANY: (Oreck 21180 Johnson Road;
Long Beach, MS, USA 39560 gives you the following warranty for this
product only if it was originally purchased for residential use, not resale
from Oreck or an Oreck Authorized Retail Dealer.)
WARNING: Unplug cord from electrical
outlet before servicing
PROBLEM
POSSIBLE SOURCE
AREAS TO CHECK
Oreck will repair or replace, free of charge, to the original purchaser, any
part that is found to be defective in material or workmanship within three
(3) years of the date of purchase; ten (10) years on housing. This
warranty applies to normal domestic use. Any commercial use of this
product will void this warranty.
Not plugged in
properly.
Be sure cleaner is
firmly plugged into
wall outlet.
CLEANER
WILL NOT RUN
No electricity in wall
outlet.
Check electrical
source–fuse or
circuit breaker.
This warranty does not cover the replacement of expendable or
consumable parts such as belts, brushes, bulbs, disposable bags and
other parts subject to normal wear unless they are defective in material or
workmanship.
Needs Service.
Take to service
center or call for
nearest service
center.
This warranty does not apply to any part subjected to accident, abuse,
alteration, misuse, damage caused by act of God, the use of voltages
other than indicated on the serial number displayed on this product or
service of this product by other than Oreck or a participating Factory
Authorized Service Center.
CLEANER
Filter bag is full.
Replace filter bag.
See “To Replace
Paper Filter Bag.”
DOES NOT PICK UP
OR HAS LOW
SUCTION
Oreck does not authorize any person or representative to assume or
grant any other warranty obligation with the sale of this product.
Hose / Wand tool is
clogged.
Clear obstruction.
Oreck’s warranty is valid only if you retain proof of purchase from Oreck
or an Oreck Authorized Retail Dealer for this product. If you purchase this
product from any other source, your purchase is “AS IS,” which means
Oreck grants you no warranty, and that you, not Oreck, assume the entire
risk of the quality and performance of this product, including the entire
cost of any necessary servicing or repairs of any defects.
Air leak due to
missing or damaged
gasket.
Replace Gasket
ALL OTHER SERVICING SHOULD BE DONE BY AN
ORECK AUTHORIZED SERVICE CENTER.
This warranty is in addition to your statutory and other legal rights.
Reconditioned units carry a 6 month warranty from date of purchase.
CALL CUSTOMER SERVICE HOT LINE
0 8 4 5 6 0 3 0 1 5 3
Whenever calling, please be sure to have your model and serial
number from data plate.
WARNING: Unplug cord from electrical
outlet before servicing.
•
•
IMPORTANT: Ma ke su re filt e r b a g is in p la ce . Do not operate
cleaner without filter bag. Damage to motor may occur.
1
Be sure bag gasket is in place. If the white bag gasket is damaged or
lost, replace at once.
10
(Part No. 72017-02)
3
4
•
For best results, change disposable filter bag regularly even if it is not
completely full. An extremely dirty bag or a bag close to full will affect
the suction of the cleaner and can create excessive motor heat that
could damage the motor. A good practice is to change filter bag every
30 days even if it is not full.
8
•
•
Do not pick up moist material or liquids.
2
9
If fine materials such as soot, cement, plaster dust, copy machine
powder, etc. are picked up, the bag surface may seal and suction will
be reduced. Change bag when this occurs.
7
5
6
•
•
Clean the disposable bag cavity and the outside of the canister with a
damp (not wet) cloth.
ITEM
IMPORTANT: DO NOT REMOVE the dirt retaining flap attached on
the back of the front plate. It must be left in place for the unit to operate
properly and to ensure cleaning effectiveness.
1. Vacuum cleaner housing with paper filter bag and micro filter
installed
2. Adjustable shoulder strap
3. Flexible hose with built-in adapter for easy insertion in vacuum or
blower port
4. Crevice tool
5. Fabric tool
ITEM
PART #
6. Bare floor and wall tool
1. Replacement Treated Filter Bags,
12 pk. with 1 Micro Filter
2. Replacement Micro Filter
3. Replacement White Bag Gasket
4. Oreck Fresh Air® Tabs
7. Tool adapter tube for fitting tools directly to vacuum when not
using hose
PKBB12DW
72005-01
72017-02
AIRTABS
8. Two extension wands
9. Dusting brush
10. Tool Caddy
72080-07 REV B
©2005 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are owned and used
06/05 ECN# R-8022
under the authority of Oreck Holdings, LLC.
Download from Www.Somanuals.com. All Manuals Search And Download.
|