D1406-0
En
5.1ch Home Theater Speaker Package
HTP-593
*
2
9
4
0
1
8
7
4
*
Surround Speakers (SKR-590)
Supplied Accessories
Part Names
Make sure you have the following accessories.
Front Speakers (SKF-591)
Front Speakers (SKF-591)
Keyhole slot
(Blue)
Speaker cables 26 ft. (8.0 m)
(Gray)
Surround speakers
Speaker terminals
Powered Subwoofer (SKW-593/SKW-591)
(White)
Speaker cables 10 ft. (3.0 m)
(Red)
Front speakers
Center Speaker (SKC-591N/SKC-591)
Center Speaker (SKC-591N/SKC-591)
Speaker terminals
(Green)
Center speaker
Speaker cable 10 ft. (3.0 m)
Subwoofer
RCA cable 10 ft. (3.0 m)
SKC-591N (North American)
SKC-591 (Asian)
Keyhole slots
4 floor pads
Surround Speakers (SKR-590)
4 rubber stoppers*1
*1
Configuration of the rubber stoppers may be different from the
figure, such as being 2 sheets instead of 1 sheet, but the total
number will be same.
Keyhole slot
Speaker terminals
Caution
• The front grilles are not designed to be removed so do not
attempt to remove them forcibly, as this will damage
them.
1
Download from Www.Somanuals.com. All Manuals Search And Download.
4 Subwoofer (SKW-593/SKW-591)
Caution
Connecting the Speakers
The subwoofer handles the bass sounds of the LFE
(Low-Frequency Effects) channel and bass from the
satellite speakers when a crossover is specified. The
volume and quality of the bass output from your
subwoofer will depend on its position, the shape of
your listening room, and your listening position. In
general, a good bass sound can be obtained by
installing the subwoofer in a front corner, or at one-
third the way along the front wall, as shown.
• A mounting screw’s ability to support a
speaker depends on how well it’s
anchored to the wall. If you have
hollow walls, screw each mounting
screw into a stud. If there are no studs,
or the walls are solid, use suitable wall
anchors. Use screws with a head
diameter of 5/16" (9 mm) or less and a shank diameter of
1/8" (4 mm) or less. With hollow walls, use a cable/pipe
detector to check for any power cables or water pipes
before making any holes.
Wall
Speaker Connection Precautions
Read the following before connecting your speakers:
• Turn off your receiver before making any connections.
• Pay close attention to speaker wiring polarity.
Connect positive (+) terminals to only
3/16" to 7/16"
(5 to 10 mm)
positive (+) terminals, and negative (–)
terminals to only negative (–) terminals. If the
speakers are wired incorrectly, the sound will be out of
phase and will sound unnatural.
• Be careful not to short the positive and negative wires.
Doing so may damage your amp.
4 1
2
• Leave a gap of between 3/16" (5 mm) and 7/16" (10 mm)
between the wall and the base of the screw head, as
shown (We recommend that you consult a home
installation professional).
Powered
subwoofer
Front right
speaker
Front left
speaker
Center speaker
3
Enjoying Home Theater
Green
White
The Home Theater means that you can enjoy surround
sound with a real sense of movement in your own home —
Red
just like being in a movie theater or concert hall.
.
1 Front left and right speakers (SKF-591)
They should be positioned facing the listener at about
ear level, and equally spaced from the TV. Angle
them inward slightly so as to create a triangle, with
the listener at the apex.
*
Using the supplied
RCA cable, connect
the subwoofer’s
LINE INPUT to
your AV receiver’s
SUBWOOFER
Corner
position
2 Center speaker (SKC-591N/SKC-591)
1/3 of wall
position
Blue
Gray
Position it close to your TV (preferably on top)
facing forward at about ear level, or at the same
height as the front left and right speakers.
3 Surround left and right speakers (SKR-590)
PRE OUT jack.
Surround
Surround
Position them at the sides of the listener, or slightly
behind, about 2 to 3 feet (60 to 100 cm) above ear
level. Ideally they should be equally spaced from the
listener.
right
left
speaker
speaker
3
Download from Www.Somanuals.com. All Manuals Search And Download.
■ Surround Speakers (SKR-590)
Terminal
Keyhole slot
Grille
Spring type color coded
Available
Fixed
Specifications
Type
Impedance
Full Range Closed Box
6 :
■ Powered Subwoofer (SKW-593/SKW-591)
Other
Non-magnetic shielding
Maximum input power 130 W
Type
Input sensitivity/Impedance
540 mV/20 k:
Bass-Reflex
Sensitivity
81 dB/W/m
■ Center Speaker
Frequency response
Cabinet capacity
80 Hz to 20 kHz
0.036 cubic feet (1.0 L)
SKC-591N (North American)
Type
Impedance
Maximum input power 130 W
Rated output Power (FTC)
2 Way Bass-Reflex
6 :
Dimensions (W × H × D) 4-1/2" × 9-1/16" × 3-3/4"
(115 mm × 230 mm × 96 mm)
(North American)
120 watts minimum continuous power,
4 ohms, driven at 100 Hz with a
maximum total harmonic distortion of
1 %
(incl. grille and projection)
Sensitivity
86 dB/W/m
65 Hz to 50 kHz
6 kHz
Weight
2.2 lbs. (1.0 kg)
Frequency response
Crossover frequency
Cabinet capacity
Dimensions (W × H × D) 16-9/16" × 4-1/2" × 4-11/16"
(420 mm × 115 mm × 119 mm)
Drivers unit
Terminal
Keyhole slot
Grille
3-1/4" (8 cm) Cone Speaker × 1
Spring type color coded
Available
Rated output Power (IEC)
(Asian)
0.10 cubic feet (2.8 L)
120 watts minimum continuous power,
4 ohms, driven at 100 Hz with a
maximum total harmonic distortion of
1 %
Fixed
Other
Non-magnetic shielding
(incl. grille and projection)
5.1 lbs. (2.3 kg)
3-1/4" (8 cm) Cone Woofer × 2
1" (2.5 cm) Balanced Dome × 1
Weight
Drivers unit
Specifications and appearance are subject to change
without prior notice.
Frequency response
Cabinet capacity
25 Hz to 150 Hz
1.34 cubic feet (38 L)
Dimensions (W × H × D) 12-1/2" × 18-7/16" × 15-11/16"
(317.5 mm × 468 mm × 398 mm)
(incl. projection)
Note
Terminal
Keyhole slot
Grille
Spring type color coded
Available
Fixed
For non-magnetic shielded speakers:
Weight
20.1 lbs. (9.1 kg)
Try moving the speakers away from your TV or monitor. If
discoloration should occur, turn off your TV or monitor,
wait 15 to 30 minutes, and then turn it back on again. This
normally activates the degaussing function, which
neutralizes the magnetic field, thereby removing any
discoloration effects.
Other
Non-magnetic shielding
Audio input
Drivers unit
Power supply
1 (RCA analog mono)
10" (25 cm) Cone Woofer × 1
(North American)
AC 120 V, 60 Hz
SKC-591 (Asian)
Type
Impedance
Maximum input power 130 W
Sensitivity
Frequency response
Crossover frequency
Cabinet capacity
Dimensions (W × H × D) 16-9/16" × 4-1/2" × 4-11/16"
(420 mm × 115 mm × 119 mm)
2 Way Bass-Reflex
6 :
(Asian) AC 220 - 240 V, 50/60 Hz
Power consumption
Other
35 W
86 dB/W/m
65 Hz to 50 kHz
6 kHz
Auto Standby function
Non-magnetic shielding
■ Front Speakers (SKF-591)
0.10 cubic feet (2.8 L)
Type
Impedance
2 Way Bass-Reflex
6 :
(incl. grille and projection)
Maximum input power 130 W
Weight
5.3 lbs. (2.4 kg)
Sensitivity
84.5 dB/W/m
Drivers unit
3-1/4" (8 cm) Cone Woofer × 2
1" (2.5 cm) Balanced Dome × 1
Spring type color coded
Available
Frequency response
Crossover frequency
Cabinet capacity
Dimensions (W × H × D) 6-1/8" × 14-7/8" × 6-5/8"
(155 mm × 378 mm × 169 mm)
55 Hz to 50 kHz
4 kHz
0.20 cubic feet (5.7 L)
Terminal
Keyhole slot
Grille
Fixed
(incl. grille and projection)
Other
Magnetic shielding
Weight
Drivers unit
5.7 lbs. (2.6 kg)
5" (12 cm) OMF Cone Woofer × 1
1" (2.5 cm) Balanced Dome × 1
SN 29401874
(C) Copyright 2014 Onkyo Corporation Japan. All rights reserved.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
|