Onkyo Home Theater System htp 690 User Manual

E
n
5.1ch Home Theater Speaker Package  
HTP-690/SKS-HT690  
Front speaker (SKF-690)  
Center speaker (SKC-690)  
Surround speaker (SKR-690)  
Powered subwoofer (SKW-780)  
4 floor pads  
(Green)  
RCA cable 10 ft.  
(3.0 m)  
(White)  
(Red)  
(Blue)  
(Gray)  
Speaker cable 10 ft.  
(3.0 m)  
Front speakers  
Surround speakers  
Speaker cables 26 ft.  
(8.0 m)  
Speaker cables 11 ft.  
(3.5 m)  
Center speaker  
Subwoofer  
Front  
Standby/On indicator  
Red: Subwoofer in standby mode  
Blue: Subwoofer on  
12 rubber stoppers* (For Front/Surround speakers)  
With the Auto Standby function, the SKW-780  
automatically turns on when an input signal is  
detected in Standby mode. When there’s no input  
signal for a while, the SKW-780 automatically enters  
Standby mode.  
4 rubber stoppers*  
*
Configuration of the rubber stoppers may be different from the figure, such as being 2 sheets instead of 1 sheet, but the total number will be same.  
Rear  
OUTPUT LEVEL control  
This control is used to adjust the volume of  
780  
the subwoofer.  
LINE INPUT  
This RCA input should be connected to the  
subwoofer pre out on your AV receiver with  
supplied RCA cable.  
SKF-690  
SKR-690  
SKC-690  
Speaker terminals  
To AC outlet  
Speaker terminals  
Note  
Using the Rubber Stoppers for a More Stable Platform  
• The Auto Standby function turns the subwoofer on when the input signal exceeds a  
certain level. If the Auto Standby function does not work reliably, try slightly increasing  
or decreasing the subwoofer output level on your receiver.  
• If the Standby/On indicator lights (both red and blue LEDs) several seconds or minutes  
after the sound output stopped, this means that the amp protection circuit has been  
activated. In this case, set the OUTPUT LEVEL control to the center position, and  
disconnect the power cord from the AC outlet. Wait at least 10 seconds, and then  
reconnect the power cord. If that doesn’t solve the issue, contact your Onkyo dealer.  
We recommend using the supplied rubber stoppers to achieve  
Rubber stoppers  
the best possible sound from your speakers.  
The rubber stoppers prevent the speakers from moving,  
providing a more stable platform.  
Rubber stoppers  
Bottom of the  
SKF-690  
SKR-690  
Setting the Subwoofer Level  
To set the level of the subwoofer, use the OUTPUT LEVEL  
control. Set it so that bass sounds are evenly balanced with the  
treble sounds from the other speakers. Because our ears are less  
sensitive to very low bass sounds, there’s a temptation to set the  
level of the subwoofer too high. As a rule of thumb, set the  
subwoofer level to what you think is the optimal level, and then back it off  
slightly.  
Bottom of the  
SKC-690  
Attaching and detaching the speaker grilles  
The front, center and surround speakers have detachable grilles.  
See the right illustrations to attach or detach them.  
Removal  
Replacement  
Using the Floor Pads for Subwoofer  
If the subwoofer is placed on a hard floor  
(wood, vinyl, tile, etc.) and playback is very  
loud, the subwoofer’s feet may damage the  
flooring. To prevent this, place the supplied  
pads underneath the subwoofer’s feet. The pads  
also provide a stable base for the subwoofer.  
Pad  
Enjoying Home Theater  
Specifications  
Powered Subwoofer (SKW-780)  
Center Speaker (SKC-690)  
The Home Theater means that you can enjoy surround sound with a real sense of movement in your own home — just like being in  
a movie theater or concert hall.  
Type  
Bass-Reflex  
Type  
2 Way Closed Box  
Input sensitivity/Impedance 550 mV/20 k  
Impedance  
6 Ω  
Rated output Power (FTC)  
120 watts minimum continuous power, 4  
ohms, driven at 100 Hz with a maximum  
total harmonic distortion of 1 %  
Maximum input power  
Sensitivity  
Frequency response  
Crossover frequency  
Cabinet capacity  
Dimensions (W × H × D)  
130 W  
Front left and right speakers (SKF-690)  
82 dB/W/m  
70 Hz to 50 kHz  
7 kHz  
They should be positioned facing the listener at about ear level,  
and equally spaced from the TV. Angle them inward slightly so as  
to create a triangle, with the listener at the apex.  
Surround left and right speakers (SKR-690)  
Position them at the sides of the listener, or  
slightly behind, about 2 to 3 feet (60 to  
100 cm) above ear level. Ideally they should be  
equally spaced from the listener.  
Frequency response  
Cabinet capacity  
Dimensions (W × H × D)  
25 Hz to 150 Hz  
1.3 cubic feet (37 L)  
0.046 cubic feet (1.3 L)  
10-13/16" × 19-15/16" × 16-3/16"  
(275 mm × 507 mm × 411 mm)  
(incl. projection)  
10-7/8" × 4-5/16" × 4-5/16"  
(277 mm × 110 mm × 110 mm)  
(incl. grille and projection)  
Center speaker (SKC-690)  
Position it close to your TV  
Weight  
25.6 lbs. (11.6 kg)  
10" (25 cm) Cone Woofer × 1  
AC 120 V, 60 Hz  
163 W  
Weight  
Drivers unit  
3.7 lbs (1.7 kg)  
(preferably on top) facing forward at  
about ear level, or at the same height  
as the front left and right speakers.  
Drivers unit  
Power supply  
Power consumption  
Other  
3-1/4" (8 cm) Cone Woofer × 2  
1" (2.5 cm) Balanced Dome Tweeter × 1  
Spring type color coded  
Detachable  
Terminal  
Grille  
Insert nut  
Other  
Auto Standby function  
Non-magnetic shielding  
Available (1/4-20UNC)  
Magnetic shielding  
Front Speakers (SKF-690)  
Type  
Impedance  
2 Way Closed Box  
Surround Speakers (SKR-690)  
6 Ω  
130 W  
Type  
Full Range Closed Box  
Maximum input power  
Sensitivity  
Frequency response  
Crossover frequency  
Cabinet capacity  
Dimensions (W × H × D)  
Impedance  
6 Ω  
79 dB/W/m  
70 Hz to 50 kHz  
7 kHz  
Maximum input power  
Sensitivity  
Frequency response  
Cabinet capacity  
Dimensions (W × H × D)  
130 W  
Corner  
80 dB/W/m  
80 Hz to 20 kHz  
0.032 cubic feet (0.9 L)  
position  
Subwoofer (SKW-780)  
0.032 cubic feet (0.9 L)  
The subwoofer handles the bass sounds of the LFE (Low-Frequency Effects)  
channel and bass from the satellite speakers when a crossover is specified.  
The volume and quality of the bass output from your subwoofer will depend  
on its position, the shape of your listening room, and your listening position.  
In general, a good bass sound can be obtained by installing the subwoofer in  
a front corner, or at one-third the way along the front wall, as shown.  
4" × 6-11/16" × 4-1/8"  
(102 mm × 170 mm × 105 mm)  
(incl. grille and projection)  
1/3 of wall  
position  
4" × 6-11/16" × 4-1/8"  
(102 mm × 170 mm × 105 mm)  
(incl. grille and projection)  
Weight  
Drivers unit  
2.2 lbs (1.0 kg)  
Weight  
2.0 lbs (0.9 kg)  
3-1/4" (8 cm) Cone Woofer × 1  
1" (2.5 cm) Balanced Dome Tweeter × 1  
Drivers unit  
Terminal  
Grille  
3-1/4" (8 cm) Cone × 1  
Spring type color coded  
Detachable  
Terminal  
Grille  
Insert nut  
Other  
Spring type color coded  
Detachable  
Insert nut  
Other  
Available (1/4-20UNC)  
Magnetic shielding  
Connecting the Speakers  
Available (1/4-20UNC)  
Magnetic shielding  
Specifications and appearance are subject to change without  
prior notice.  
Front right  
speaker  
Front left  
speaker  
Powered  
subwoofer  
Note  
Center speaker  
For non-magnetic shielded speakers:  
Try moving the speakers away from your TV or monitor. If discoloration should occur, turn off your TV or monitor, wait 15 to 30  
minutes, and then turn it back on again. This normally activates the degaussing function, which neutralizes the magnetic field,  
thereby removing any discoloration effects.  
780  
Red  
White  
Green  
Speaker Connection  
Precautions  
2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN  
Tel: 072-831-8023 Fax: 072-831-8163  
Read the following before connecting your  
speakers:  
• Turn off your receiver before making any  
connections.  
• Pay close attention to speaker  
wiring polarity. Connect  
18 Park Way, Upper Saddle River, N.J. 07458, U.S.A.  
Tel: 800-229-1687, 201-785-2600 Fax: 201-785-2650  
Liegnitzerstrasse 6, 82194 Groebenzell, GERMANY  
Tel: +49-8142-4401-0 Fax: +49-8142-4401-555  
*
Using the supplied RCA cable,  
connect the subwoofer’s LINE  
INPUT to your AV receiver’s  
SUBWOOFER PRE OUT jack.  
Blue  
Gray  
positive (+) terminals to only  
positive (+) terminals, and  
negative (–) terminals to only negative (–)  
terminals. If the speakers are wired  
incorrectly, the sound will be out of phase  
and will sound unnatural.  
• Be careful not to short the positive and  
negative wires. Doing so may damage  
your amp.  
The Coach House 81A High Street, Marlow, Buckinghamshire, SL7 1AB, UK  
Tel: +44-(0)1628-473-350 Fax: +44-(0)1628-401-700  
Unit 1 & 12, 9/F, Ever Gain Plaza Tower 1, 88, Container Port Road, Kwai Chung,  
N.T., Hong Kong. Tel: 852-2429-3118 Fax: 852-2428-9039  
Surround right  
speaker  
Surround left  
speaker  
Y1104-1  
1301, 555 Tower, No.555 West NanJin Road, Jin an, Shanghai,  
China 200041, Tel: 86-21-52131366 Fax: 86-21-52130396  
SN 29400785  
(C) Copyright 2011 ONKYO SOUND & VISION CORPORATION Japan. All rights reserved.  
* 2 9 4 0 0 7 8 5 *  
Download from Www.Somanuals.com. All Manuals Search And Download.  

MTD Snow Blower 310 180 000 User Manual
Nady Systems Headphones HM 20U User Manual
Nilfisk ALTO Air Compressor CLE80 User Manual
NXP Semiconductors Network Router LPC2917 User Manual
Oki Printer 6200n User Manual
Oki Printer M184 User Manual
Omnimount TV Mount 10041 User Manual
Panasonic Cell Phone EBH63 User Manual
Panasonic Headphones RPWF6000 User Manual
Patton electronic Network Router EHA3201 User Manual