E
n
5.1ch Home Theater Speaker Package
HTP-938
Front speakers (SKF-980)
Surround speakers (SKR-980)
Center speaker (SKC-980)
Powered subwoofer (SKW-938)
RCA cable 3.0 m
(Green)
Speaker cable 3.0 m
(White)
(Red)
(Blue)
Speaker cables 8.0 m
(Gray)
Center speaker*1
Surround speakers*2
Speaker cables 3.5 m
Subwoofer*2
Front speakers*1
*2
Non-magnetic shielding.
■ Front
*1
*2
For magnetic shielding.
Non-magnetic shielding.
Standby/On indicator
Red: Subwoofer in standby mode
Blue: Subwoofer on
Cork spacer (12 pcs.) for front and
center speakers
With the Auto Standby function, the
SKW-938 automatically turns on when
an input signal is detected in Standby
mode. When there’s no input signal for
a while, the SKW-938 automatically
enters Standby mode.
Speakerterminals
Keyhole slot
Keyhole slot
■ Rear
Speaker
terminals
SKC-980
POWER switch
Speaker
terminals
Press this switch to the ON position to
turn on the power. Press it to the OFF
position to turn off the power.
SKR-980
Keyhole slots
SKF-980
OUTPUT LEVEL control
This control is used to adjust the vol-
ume of the subwoofer.
Wall Mounting
LINE INPUT
To AC outlet
To mount the front/surround speakers vertically, use
the keyhole slot shown to hang each speaker on a
screw that’s securely screwed into the wall.
To mount the center speaker horizontally, use the two
keyhole slots shown to hang each speaker on two
screws that are securely screwed into the wall.
Caution
This RCA input should be connected to
the subwoofer pre out on your AV
receiver with supplied RCA cable.
• A mounting screw’s ability to support a speaker
depends on how well it’s anchored to the wall. If you
have hollow walls, screw each mounting screw into a
stud. If there are no studs, or the walls are solid, use
suitable wall anchors. Use screws with a head diameter
of 9 mm or less and a shank diameter of 4 mm or less.
With hollow walls, use a cable/pipe detector to check
for any power cables or water pipes before making any
holes.
Wall
Caution
Keyhole slots for wall mounting
• The front grille is not designed to be removed so does not attempt
to remove it forcibly, as this will damage it.
5 to 10 mm
Keyhole slots for
wall mounting
Note
SKC-980
• The Auto Standby function turns the subwoofer on when the input signal
exceeds a certain level. If the Auto Standby function does not work reli-
ably, try slightly increasing or decreasing the subwoofer output level on
your receiver.
• If the Standby/On indicator lights (both red and blue LEDs) several sec-
onds or minutes after the sound output stopped, this means that the amp
protection circuit has been activated. In this case, set the OUTPUT LEVEL
control to the center position, and disconnect the power cord from the AC
outlet. Wait at least 10 seconds, and then reconnect the power cord. If that
doesn’t solve the issue, contact your Onkyo dealer.
260 mm
• Leave a gap of between 5 mm and 10 mm between the wall and the base
of the screw head, as shown. (We recommend that you consult a home
installation professional.)
SKF-980
SKR-980
Using the Cork Spacers for a More Stable Platform
We recommend using the supplied cork spacers to achieve the best possible
sound from your speakers. The cork spacers prevent the speakers from mov-
ing, providing a more stable platform.
■ Attaching and detaching the speaker grilles
The front, center and surround
speakers have detachable grilles.
See the right illustrations to attach
or detach them.
Setting the Subwoofer Level
Removal
Replacement
Make sure the SKW-938 subwoofer’s output
level control is set at the “THX-POSITION”.
You can then adjust the level as needed.
Cork spacers
Bottom of the
SKF-980
Bottom of the SKC-980
Cork spacers
Enjoying Home Theater
Specifications
The Home Theater means that you can enjoy surround sound with a real sense of movement in your own home — just like being in
a movie theater or concert hall.
■ Powered Subwoofer (SKW-938)
■ Center Speaker (SKC-980)
Type
Acoustic suspension
Type
2 Way Acoustic suspension
Rated output power (IEC)
125 watts minimum continuous power,
6 ohms, driven at 100 Hz with a
maximum total harmonic distortion of
1 %
Impedance
Maximum input power
Sensitivity
Frequency response
Crossover frequency
Cabinet capacity
Dimensions (W × H × D)
8 Ω
130 W
abFront left and right speakers (SKF-980)
f
ab c
They should be positioned facing the listener at about ear level, and equally
spaced from the TV. Angle them inward slightly so as to create a triangle, with
the listener at the apex.
83 dB/W/m
50 Hz to 45 kHz
2 kHz
Input sensitivity/impedance 280 mV / 20 kΩ
Frequency response
Cabinet capacity
c
Center speaker (SKC-980)
20 Hz to 100 Hz
49 L
Position it close to your TV (preferably on top) facing forward at about ear
level, or at the same height as the front left and right speakers.
deSurround left and right speakers (SKR-980)
7.5 L
433 mm × 158 mm × 199 mm
(incl. grille and projection)
Dimensions (W × H × D)
380 mm × 444 mm × 429 mm
(incl. grille and projection)
Position them at the sides of the listener, or slightly behind, about 60 to 100 cm
above ear level. Ideally they should be equally spaced from the listener.
Weight
Drivers unit
5.3 kg
Weight
15.5 kg
12 cm A-OMF Cone Woofer × 2
2.5 cm Soft Dome Tweeter × 1
Binding post (Banana type supported)
Magnetic shielding
Drivers unit
Power supply
Power consumption
Other
30 cm Cone Woofer
AC 230 V, 50 Hz
137 W
f
Subwoofer (SKW-938)
Terminal
Other
The subwoofer handles the bass sounds of the LFE (Low-Frequency Effects)
channel. The volume and quality of the bass output from your subwoofer will
depend on its position, the shape of your listening room, and your listening
position. In general, a good bass sound can be obtained by installing the sub-
woofer in a front corner, or at one-third the way along the front wall, as shown.
Corner
position
1/3 of wall
position
Auto Standby function
■ Front Speakers (SKF-980)
■ Surround Speakers (SKR-980)
Type
Impedance
2 Way Acoustic suspension
Type
Impedance
2 Way Acoustic suspension
de
8 Ω
130 W
8 Ω
130 W
Maximum input power
Sensitivity
Frequency response
Crossover frequency
Cabinet capacity
Dimensions (W × H × D)
Maximum input power
Sensitivity
Frequency response
Crossover frequency
Cabinet capacity
Dimensions (W × H × D)
83 dB/W/m
50 Hz to 45 kHz
2 kHz
81 dB/W/m
50 Hz to 45 kHz
2 kHz
Connecting the Speakers
7.5 L
4.6 L
158 mm × 433 mm × 199 mm
(incl. grille and projection)
200 mm × 275 mm × 169 mm
(incl. grille and projection)
Surround
left
speaker
Surround
right
speaker
Front left
speaker
Front right
speaker
Weight
Drivers unit
5.3 kg
Weight
Drivers unit
3.5 kg
12 cm A-OMF Cone Woofer × 2
2.5 cm Soft Dome Tweeter × 1
Binding post (Banana type supported)
Magnetic shielding
13 cm A-OMF Cone Woofer × 1
2.5 cm Soft Dome Tweeter × 1
Binding post (Banana type supported)
Terminal
Other
Center speaker
Terminal
Specifications and appearance are subject to change without
prior notice.
THX and the THX logo are trademarks of THX Ltd. which are regis-
tered in some jurisdictions. All rights reserved.
Blue
Gray
White
Red
Green
Speaker Connection Precautions
Read the following before connecting your
speakers:
• Turn off your receiver before making any
connections.
Sales & Product Planning Div. : 2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN
Tel: 072-831-8023 Fax: 072-831-8163
ONKYO U.S.A. CORPORATION
• Pay close attention to speaker
wiring polarity. Connect positive
(+) terminals to only positive (+)
terminals, and negative (–) ter-
minals to only negative (–) terminals. If the
speakers are wired incorrectly, the sound
will be out of phase and will sound unnatu-
ral.
18 Park Way, Upper Saddle River, N.J. 07458, U.S.A.
Powered
subwoofer
ONKYO EUROPE ELECTRONICS GmbH
Liegnitzerstrasse 6, 82194 Groebenzell, GERMANY
ONKYO EUROPE ELECTRONICS GmbH (UK BRANCH)
The Coach House 81A High Street, Marlow, Buckinghamshire, SL7 1AB, UK
Tel: +44-(0)1628-473-350 Fax: +44-(0)1628-401-700
• Be careful not to short the positive and nega-
tive wires. Doing so may damage your amp.
ONKYO CHINA LIMITED
Unit 1 & 12, 9/F, Ever Gain Plaza Tower 1, 88, Container Port Road, Kwai Chung,
N.T., Hong Kong. Tel: 852-2429-3118 Fax: 852-2428-9039
Note
Y1006-1
• When you connect the surround back and front
high speakers, prepare for it separately.
SN 29400482
(C) Copyright 2010 ONKYO CORPORATION Japan. All rights reserved.
* 2 9 4 0 0 4 8 2 *
Download from Www.Somanuals.com. All Manuals Search And Download.
|