Omega Speaker Systems Automobile Parts 41100 User Manual

Operating Instructions  
& Parts Manual  
Hydraulic  
Transmission Jacks  
Model Number  
41100  
Capacity  
1100 Lbs  
2000 Lbs  
3000 Lbs  
42000  
43000  
Model 42000  
Model 43000  
Model 41100  
Shinn Fu Co. of America, Inc. ©2002  
10939 N. Pomona Avenue  
Kansas City, MO 64153  
OIPM#41100-TJ2  
Printed in Taiwan  
Download from Www.Somanuals.com. All Manuals Search And Download.  
MAINTENANCE  
!
WARNING  
Important: Use only a good grade hydraulic jack oil.  
Avoid mixing different types of fluid and NEVER use  
brake fluid, turbine oil, transmission fluid, motor oil or  
glycerin. Improper fluid can cause premature failure  
of the jack and the potential for sudden and immediate  
loss of load.  
Study, understand, and follow all printed materials  
provided with/on this device before use. Do not  
exceed rated capacity. Use only on hard, level,  
seamless surface. Use of this jack is limited to the  
removal, installation and transportation of  
transmissions, transfer cases and transaxles.  
Adequately support the vehicle before starting repairs.  
Failure to heed these markings may result in personal  
injury and/or property damage.  
Adding oil  
1. With saddle fully lowered, set jack in its upright,  
level position. Remove oil filler plug.  
2. Fill until oil is level with the filler plug hole, reinstall  
oil filler plug.  
! Safety Messages !  
Changing oil  
Ensure the center of gravity is centered on the saddle.  
Use only chains and slings provided. If loaded jack  
must be moved, make certain that load is secured by  
appropriate means, is stable, is in lowest possible  
position. This is a lifting and lowering device only.  
Transfer load immediately to appropriate support  
device for service or repair. No alterations shall be  
made to this product.  
For best performance and longest life, replace the  
complete fluid supply at least once per year.  
1. With saddle fully lowered, set jack in its upright,  
level position. Remove the oil filler plug.  
2. Lay the jack on its side and drain the fluid into a  
suitable container.  
Note: Dispose of hydraulic fluid in accordance  
with local regulations.  
OPERATION  
Raise saddle:  
1. Locate and close release valve by turning knob  
clockwise firmly, then pump the pump handle until  
the load is contacted.  
2. Follow vehicle manufacturers recommended proce-  
dures for removing the load as outlined in vehicle  
service manual or repair guide.  
3. Secure load with provided restraints. Ensure load's  
center of gravity is centered on the saddle and load  
is stable before moving jack.  
3. Set jack in its level upright position.  
4. Fill with good quality jack oil. We recommend Mobil  
DTE 13 or equivalent. Reinstall oil filler plug.  
Lubrication  
A periodic coating of light lubricating oil to pivot points,  
axles and hinges will help to prevent rust and assure  
that wheels, casters and pump assemblies move  
freely.  
Lower saddle:  
Cleaning  
1. Slowly, gently turn the release valve knob  
counterclockwise, NEVER MORE THAN 1/2 FULL  
TURN until the load is completely lowered.  
2. Immediately transfer the load to an appropriate  
repair fixture.  
Periodically check the ram for signs of rust or  
corrosion. Clean as needed and wipe with an oily  
cloth.  
Note: Never use sandpaper or abrasive material on  
these surfaces!  
Storage  
! Caution !  
When not in use, store the jack with pump piston and  
saddle in lowest position.  
Be sure all tools and personnel are clear before  
lowering load. Dynamic shock loads are created by  
quickly opening and closing the release valve as the  
load is being lowered. The resulting overload may  
cause hydraulic system failure.  
OIPM#41100-TJ2  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
TROUBLESHOOTING  
Symptom  
Possible Causes  
Corrective Action  
Ensure release valve tightly closed  
Remedy overload condition  
Ensure adequate air supply  
Release valve not tightly closed  
Overload condition  
Air supply inadequate  
Jack will not lift load  
Release valve not tightly closed Ensure release valve tightly closed  
Overload condition  
Hydraulic unit malfunction  
Remedy overload condition  
Contact Omega Tech. Service  
Jack bleeds off after lift  
Reservoir overfilled  
Linkages binding  
Drain fluid to proper level  
Clean and lubricate moving parts  
Jack will not lower after unloading  
Ensure proper fluid level  
Fluid level low  
With ram fully retracted, remove oil filler  
plug to let pressurized air escape, then  
reinstall oil filler plug  
Poor lift performance  
Air trapped in system  
Fluid level low  
Will not lift to full extension  
Ensure proper fluid level  
ONE YEAR LIMITED WARRANTY  
For a period of one (1) year from date of purchase, Shinn Fu Co. of America, Inc. will repair or replace,  
at its option, without charge, any of its products which fails due to a defect in material or workmanship, or which  
fails to conform to any implied warranty not excluded hereby.  
Performance of any obligation under this warranty may be obtained by returning the warranted product,  
freight prepaid, to Shinn Fu Co. of America, Inc. Warranty Service Department, 10939 N. Pomona Ave., Kansas  
City, MO 64153.  
Except where such limitations and exclusions are specifically prohibited by applicable law. (1) the  
CONSUMER'S SOLE AND EXCLUSIVE REMEDY SHALL BE THE REPAIR OR REPLACEMENT OF DEFECTIVE  
PRODUCTS AS DESCRIBED ABOVE, and (2) Shinn Fu Co. of America, Inc. SHALL NOT BE LIABLE FOR ANY  
CONSEQUENTIAL OR INCIDENTAL DAMAGE OR LOSS WHATSOEVER, and (3) THE DURATION OF ANY AND  
ALL EXPRESSED AND IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION, ANY WARRANTIES OF  
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS LIMITED TO A PERIOD OF ONE (1)  
YEAR FROM DATE OF PURCHASE.  
Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not  
apply to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the  
above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also  
have other rights which vary from state to state.  
REPLACEMENT PARTS  
Available Parts: Please refer to the Parts drawings on pages 5, 6, and when ordering parts. Not all components of  
the jack are replacement items, but are illustrated as a convenient reference of location and position in the  
assembly sequence. When ordering parts, give Figure No. and the description. For example, to order an oil filler  
plug for Model No. 41100, simply request Part # 41100-07, oil filler plug for Model No. 41100. Call or write for  
current pricing: Shinn Fu Company of America, Inc. 10939 N. Pomona Ave. Kansas City, MO 64153, U.S.A.  
Tel:(888)332-6419 Fax:(816)891-6599 E-Mail:[email protected] Omega Website: http://www.omegalift.com  
OIPM#41100-TJ2  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
Model 41100  
Parts No.  
Description  
Quantity  
1
2
3
4
5
6
7
8
power unit  
oil filler plug  
1
1
2
2
1
4
1
2
1
1
1
hyd. unit pivot pin  
angle bracket assy.  
chain  
caster assembly  
handle  
adjusting knob  
saddle  
saddle support  
label (not shown)  
manual (OIPM# 41100-TJ2)  
9
10  
--  
--  
Figure 2 - Replacement Parts for Model 41100  
OIPM#41100-TJ2  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Model 42000  
Parts No.  
Description  
Quantity  
1
2
4
5
6
7
8
9
power unit  
oil filler plug  
angle bracket assy.  
chain  
caster assembly  
handle  
adjusting knob  
saddle  
saddle support  
label (not shown)  
manual (OIPM# 41100-TJ2)  
1
1
2
1
4
1
2
1
1
1
1
10  
--  
--  
8
10  
5
4
9
2
1
7
6
Figure 3 - Replacement Parts for Model 42000  
OIPM#41100-TJ2  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
Model 43000  
Parts No.  
Description  
Quantity  
1
2
3
4
5
6
7
--  
--  
power unit  
1
1
1
4
1
2
2
1
1
oil filler screw  
handle assembly  
caster assembly  
saddle assembly  
adjusting knob  
chain  
label (not shown)  
manual (OIPM# 41100-TJ2)  
5
7
6
3
1
2
4
Figure 4 - Replacement Parts for Model 43000  
OIPM#41100-TJ2  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
Notes  
Shinn Fu Company of America, Inc.  
10939 N. Pomona Ave. Kansas City, MO 64153, U.S.A.  
Tel:(888)332-6419 Fax:(816)891-6599 E-Mail:[email protected] Omega Website: http://www.omegalift.com  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Mr Coffee Coffeemaker 111571 User Manual
Multiquip Portable Generator DCA180SSJ User Manual
NEC Cell Phone i Series User Manual
NordicTrack Treadmill NTTL25900 User Manual
NuVision Tablet Accessory KBT10 User Manual
Oregon Scientific Fitness Electronics PE316PM User Manual
OWI Portable Speaker Venus Speaker User Manual
OWI Speaker AMP1S61 User Manual
Palm PDAs Smartphones Tungsten T Handhelds User Manual
Patton electronic Network Router 2158B User Manual