Explorer 701US / 701EU Optional Handset
This Installation Sheet is designed to be read with the Explorer 721US and 721EU Operation and Installation Guide. It explains how to
install the optional handset.
Checklist
If anything is missing, consult your dealer.
•
•
Handset with 9.8' (3 m) curly cable attached
Docking cable 32.8' (10m) (not shown). If you want a different length of docking cable, consult your dealer. Do NOT cut the
docking cable that is supplied.
•
•
•
•
•
•
•
•
•
•
•
Bulkhead mount for the handset (not shown)
2 flat screws for the handset bulkhead mount (not shown)
2 self-tapping screws for the handset bulkhead mount (not shown)
2 plain washers for the handset bulkhead mount (not shown)
2 spring washers for the handset bulkhead mount (not shown)
2 nuts for the handset bulkhead mount (not shown)
Wallplate
Rubber cushion
2 screws for the wallplate
Protective end cap for the docking cable if handset is disconnected
Hexagonal nut
BEFORE doing any cutting or drilling, check that:
•
the docking cable and the handset curly cable, when connected together, comfortably reach from the base unit to the in-
tended location for the handset wallplate.
•
the intended route for the docking cable allows it to be secured to a bulkhead (or similar) along its length.
Install the wallplate
1. Hold the wallplate at the chosen location and use a
soft pencil to mark the 2 screw hole positions and
the bulkhead hole position.
Docking cable
2. Drill a 1”(25.4 mm) bulkhead hole and 2 pilot holes
for the screws.
3. Assemble the components as shown.
4. Finger-tighten the locking nut to create a waterproof
connection.
Rubber cushion
Hexagonal nut
Locking nut
Bulkhead with hole drilled
Wallplate
Screw
Protective end cap
Handset curly cable
Download from Www.Somanuals.com. All Manuals Search And Download.
|