63839MWFS-120#66242 10/25/01 2:40PM Page1SallyMercury:65946Metalwarebooks:66242:
Electric Food Slicer
with tilted stand
Food Slicer
Use/Care Guide
Model FS-120T
Download from Www.Somanuals.com. All Manuals Search And Download.
63839MWFS-120#66242 10/25/01 2:40PM Page3SallyMercury:65946Metalwarebooks:66242:
I M P O R T A N T S A F E G U A R D S
When using electrical appliances, basic safety precautions should always be followed including the following:
1. READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.
2. This appliance is designed for household use only. It is not intended for commercial use.
3. To protect against electrical shock do not immerse the Motor Assembly, including cord and plug in water or other
liquids. See cleaning instructions.
4. Do not allow children to get access to this appliance. Close supervision is necessary when any appliance is used
near children.
5. Unplug appliance from power outlet when not in use, before putting on or taking off parts, and before cleaning.
6. Do not operate any appliance with damaged cord or plug or after the appliance malfunctions, or has been
damaged in any manner. Return appliance to NESCO Factory Service Department for examination, repair or
adjustment.
7. Only use accessory attachments recommended by the manufacturer.
8. Do not use outdoors.
9. Do not let the cord hang over the edge of a table or counter, or touch hot surfaces.
10. Do not use the appliance for other than intended use.
11. The safety switch prevents accidental operation of the slicer.
12. Do not operate appliance continuously for more than 10 minutes. Allow appliance to cool down for one hour
before operating again.
13. Do not use appliance to cut frozen food or bones.
14. Operate appliance only when blade-locking screw is properly engaged and tightened.
15. Handle blade carefully when cleaning, removing and inserting, as blade is extremely sharp. Do not touch sharp
edge of blade.
16. Be careful, the blade continues to turn for a while after the appliance has been turned off.
17. To avoid danger of injury, always cut food with this appliance fully assembled. The feeder and food press plate
must always be used.
18. Adjust supporting plate to position “0” after use and before cleaning.
19. Do not place on or near a hot gas or electric burner, or in a heated oven.
S A V E T H E S E I N S T R U C T I O N S
THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY
Short Cord Instructions
CAUTION: A short power supply cord is provided to reduce the risk resulting from becoming entangled in or tripping
over a longer cord. Longer extension cords are available and may be used if care is exercised in their use. If an
extension cord is used, the marked electrical rating should be at least as great as the electrical rating of the appliance,
and the cord should be arranged so that it will not drape over the countertop or tabletop where it can be pulled on by
children or tripped over unintentionally.
Polarized Plug
As a safety feature this appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric
shock, this plug is intended to fit into a polarized outlet only. If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
FS-120 Food Slicer
3
Download from Www.Somanuals.com. All Manuals Search And Download.
63839MWFS-120#66242 10/25/01 2:40PM Page4SallyMercury:65946Metalwarebooks:66242:
Directions For Use
1. Place food slicer (Figure 1) on a flat stable surface.
2. If appliance is being used for the first time, follow Cleaning Instructions.
3. Plug into a standard 120V AC electrical outlet.
4. Put Food Tray behind slicer below Blade to collect the sliced food.
5. Place food onto Feeder between Support Plate and Food Press Plate. To avoid danger of injury, always use Feeder
and Food Press Plate while cutting.
6. Rotate Thickness Adjustment Knob to desired slicing width (Figure 3).
7. To start Blade, first slide Safety Switch from position ‘0’ to ‘I’ (Figure 2). While holding Safety Switch, press Pulse
Switch button (using the same hand).
8. Hold the Food Press Plate with your other hand. Keep hand protected behind the Food Press Plate.
9. To begin slicing, push food in with the Food Press Plate and slide food over with the Feeder as shown in Figure 4.
Slide Feeder back and repeat until you have sliced the desired amount of food.
10. When finished, release Pulse Switch button and Safety Switch and it will return to the off position.
11. For safety, always return Thickness Adjustment Knob to ‘0’ (Figure 8) after use to shield sharp edge of blade.
Cleaning Instructions
1. Always unplug appliance before cleaning.
2. Never immerse the Motor Assembly of this appliance in water or other liquid.
3. The Blade, Food Press Plate, Feeder and Food Tray can all be hand washed in warm soapy water. Be careful when
cleaning Blade, which is extremely sharp. Do not leave Blade underwater; trying to handle sharp objects in water
is hazardous.
4. Set Thickness Adjustment Knob to ‘0’.
5. Remove Food Press Plate and Feeder by tilting off as shown in Figure 5.
6. Remove Blade as shown in Figure 6. Hold blade with one hand and use a coin to unlock Blade Locking Screw by
turning it clockwise. Carefully pull blade off and hold by using the blade hole.
7. Clean outer surface of Motor Assembly and Base with damp cloth. Mild detergent or plain water can be used to
dampen cloth. Never immerse Motor Assembly in water or any other liquid. Do not use steel wool, abrasive
cleaners, or sharp utensils.
8. To facilitate cleaning, the Thickness Adjustment Knob can be turned past ‘0’ as shown in Figure 7 to allow
Supporting Plate to slide back – only use this feature with blade removed. After cleaning and before reassembling,
push Support Plate forward and reset Thickness Adjustment Knob to ‘0’ (Figure 8).
9. After cleaning and drying, install Blade and Blade Screw to Motor Assembly in reverse order of step 6
(see Figure 6). Make sure Blade Locking Screw is properly engaged and tightened. Reinstall Food Press Plate
and Feeder.
FS-120 Food Slicer
4
Download from Www.Somanuals.com. All Manuals Search And Download.
63839MWFS-120#66242 10/25/01 2:40PM Page5SallyMercury:65946Metalwarebooks:66242:
Get To Know Your Nesco Food Slicer
Item Description
1
2
3
4
5
6
7
8
9
Motor assembly
Blade
Support plate
Thickness adjustment knob
Food press plate
Base
Safety switch
Pulse switch
Power cord set
10 Feeder
11 Food tray
12 Blade locking screw
Figure 1: Food Slicer Model FS-120T
Figure 2
Figure 3
FS-120 Food Slicer
5
Download from Www.Somanuals.com. All Manuals Search And Download.
63839MWFS-120#66242 10/25/01 2:40PM Page6SallyMercury:65946Metalwarebooks:66242:
Get To Know Your Nesco Food Slicer
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
FS-120 Food Slicer
6
Download from Www.Somanuals.com. All Manuals Search And Download.
63839MWFS-120#66242 10/25/01 2:40PM Page7SallyMercury:65946Metalwarebooks:66242:
O N E Y E A R L I M I T E D W A R R A N T Y
This appliance is warranted for one year from date of original purchase against defects in material and workmanship.
This warranty does not cover transportation damage, misuse, accident or similar incident. This warranty gives you
specific legal rights and you may have other rights, which vary, from state to state.
Your new NESCO® Food Slicer comes equipped with numerous safety features. Any attempt to interfere with the
operation of these safety features makes this warranty null and void. In the event we receive a Food Slicer for service
that has been tampered with, we reserve the right to restore it to its original state and charge for the repair.
Defective products may be returned, postage prepaid, with a description of the defect to: The Metal Ware Corporation,
1700 Monroe Street, Two Rivers, Wisconsin 54241 for no charge repair or replacement at our option.
Service and genuine NESCO® replacement parts may be obtained from the NESCO® FACTORY SERVICE DEPARTMENT.
For service in warranty, follow instructions set forth in warranty. When ordering new parts, make sure that you always
mention the model number of the product, which is found on the Base of the Unit.
About Your Warranty and Service Satisfaction
One simple step sets you on the road to complete customer satisfaction:
Mail in your warranty card and file your NESCO® Food Slicers Exclusive registration number now!
Your serial number and Food Slicer Model are located on the bottom of the Base.
We enter this number into our database. It registers your warranty and identifies your Food Slicer specifically by its
individual code. Should you call our 800 toll free line, your registration number helps us identify your appliance and
speeds up our assistance to you.
Five Easy Steps to Satisfaction
Should you have a problem with your NESCO® Food Slicer, please refer to these steps for assistance:
1. Call us on our toll free number, 1-800-288-4545 and tell us about your problem.
2. If we instruct you to send us all or part of your appliance for repair or replacement, the Customer Satisfaction
representative will give you an authorization number (this number notifies our receiving department to expedite
your repair). Pack your unit carefully in a sturdy carton to prevent damage because any damage caused by
shipping is not covered by the warranty.
3. Print your name, address and authorization number on the carton.
4. Write a letter explaining the problem. Include the following: Your name, address, telephone number and a copy
of the original bill of sale.
5. Attach the sealed envelope containing the letter inside the carton. Insure the package for the value of the NESCO®
Food Slicer and ship prepaid to:
The Metal Ware Corporation
1700 Monroe Street
Two Rivers, WI 54241
FS-120 Food Slicer
7
Download from Www.Somanuals.com. All Manuals Search And Download.
63839MWFS-120#66242 10/25/01 2:40PM Page8SallyMercury:65946Metalwarebooks:66242:
1-800-288-4545
© 2001, The Metal Ware Corporation
66242
Download from Www.Somanuals.com. All Manuals Search And Download.
|