Next, ConnectYourSmartSwitchintheCorrect
Order
Now, Configure the Switch with the
Smartwizard
)NSTALLATION 'UIDE
FS700TS (728TS, 752TS, 752TPS) Series Gigabit Smart Switch
These instructions assume you are using DHCP in your network. If you are using static IP
addressing in your network, configure the switch IP address before connecting it to your
network. In the absence of a DHCP server, the switch defaults to 192.168.0.239 for its IP
address.
1. Click Start > Programs and run Smartwizard.
Start Here
Follow these instructions to set up your smart switch. Before proceeding with the smart
switch installation, familiarize yourself with the contents of the Resource CD, especially
the reference manuals on your Resource CD.
To configure the switch before connecting it to your network:
1. Set up the PC with an IP address in the 192.168.0.x subnet, and connect the PC to the
switch. Then, use the Smartwizard Discovery utility to configure the switch.
2. Connect each PC to an RJ-45 network port on the Switch front panel.
First, Verify Package Contents
Use category 5 (Cat5) unshielded twisted-pair (UTP) cable terminated with an RJ-45
connector to connect.
•
•
•
•
•
•
NETGEAR Smart Switch
Rubber footpads for tabletop installation
Power cord
Figure 2
Rack-mount kit for installing the switch in a 19-inch rack
Installation Guide
2. Click Discover to find your switch in the network.
Smart Switch Resource CD with Smartwizard Discovery and Hardware Installation
Guide. (A link to the online Software User's Manual is on the Resource CD.)
•
Warranty/Support Information Card
Then, Prepare to Install Your Smart Switch
Prepare a PC with an Ethernet adapter and a CD ROM drive.
Figure 1
Next, Install the Smartwizard Discovery
Utility on a PC
3. Connect the Smart Switch to your network.
Figure 3
4. Power on the switch.
The Smartwizard Discovery utility finds the switch and displays its MAC Address, IP
Address, and model number. If you cannot configure your switch, verify that the
cable connections are secure, that the IP address configuration of the PC is in the
same subnet as the switch.
5. Verify that the PC with the Smartwizard Discovery utility is on the same subnet as the
1. Insert the resource CD into your CD drive.
switch.
2. Run the Setup program to install the Smartwizard Discovery. The Installation Wizard
will guide you through.
Download from Www.Somanuals.com. All Manuals Search And Download.
|