c. Securely insert the Ethernet cable from your broadband
MODEL
modem into the Internet port (B) on the FVS328.
FVS328
Broadband ProSafe VPN Firewall with Dial Backup
PWR TEST Modem
IN TER N ET
LO CA L
LNK
100
ACT
LNK/ACT
1
2
3
4
5
6
7
8
Internet Port
B
Start Here
Internet Port
Local Port 7
Power
Test
LO CA
10/100M
L
1
2
V
DC
1
.
2
A
M
O
DEM
IN TERN ET
8
7
6
5
4
3
2
1
d. Check the status lights and verify the following:
Follow these instructions to set up your router.
Broadband modem
•
•
•
Power: The power light goes on when your turn the
Verify That Basic Requirements Are Met
firewall on.
d. Securely insert one end of the Ethernet cable that came with
your firewall into a LAN port on the router such as LAN
port 7 (C), and the other end into the Ethernet port of your
computer (D).
Test: The test light turns on, then goes off after less than
Assure that the following requirements are met:
a minute.
•
•
You have your broadband Internet service settings handy.
Local: A Local light on the router is lit. If no Local
lights are lit, check that the Ethernet cable connecting
the powered on computer to the router is securely
attached at both ends.
The computer is configured to obtain an IP address
automatically via DHCP. For instructions on how to do this,
please see the Reference Manual on the Model FVS328
Resource CD.
•
Internet: The Internet light on the firewall is lit. If the
Internet light is not lit, make sure the Ethernet cable is
securely attached to the firewall Internet port and the
powered on modem.
D
1. CONNECT THE FIREWALL
a. Turn off your computer and cable or DSL modem.
LO CA
10/100M
L
1
2
V
D
C
1
.
2
A
M
O
DEM
IN TER
N
ET
8
7
6
5
4
3
2
1
b. Disconnect the Ethernet cable (A) which connects from
Broadband modem
3. LOG IN TO THE FIREWALL
your computer to the broadband modem.
C
a. From your PC, launch your Internet browser.
Local Port
address field of Internet Explorer or Netscape® Navigator.
2. RESTART YOUR NETWORK IN THE CORRECT SEQUENCE
Warning: Failure to restart your network in the correct
sequence could prevent you from connecting to the Internet.
A
a. First, turn on the broadband modem and wait 2 minutes.
b. Now, turn on your firewall.
c. Enter admin for the router user name and password for the
Broadband modem
router password, both in lower case letters.
c. Last, turn on your computer.
d. After logging in to the router, you will see the Internet
connection Setup Wizard on the settings main page.
Note: If software usually logs you in to the Internet, do not
run that software or cancel it if it starts automatically.
Download from Www.Somanuals.com. All Manuals Search And Download.
|