2. Next, install the WG511 Wireless PC Card.
c. Click on the “Allow me to connect to the selected wireless
network even though this is not secure” check box.
a. Hold the PC Card with the Netgear logo facing up and insert
it into a CardBus slot. After a short delay, the Found New
Hardware Wizard displays.
d. Click Connect.
WG511 54 Mbps Wireless PC Card
4. Finally, verify wireless network connectivity.
Note: If a Windows XP
certified warning appears,
click Continue Anyway
to proceed.
a. Open the WG511 utility by clicking on the icon
Windows system tray.
in the
Quick Installation Guide
Follow these quick steps to install your WG511
Note: When the
Window XP wireless
configuration utility is
selected, only these two
tab pages appear.
The basic installation and configuration instructions below assume
that your wireless network connection will be to an access point, and
you are not using WEP security. Please refer to Reference Manual
on the Resource CD for detailed instructions on configuring WEP,
using Ad-hoc mode, or using advanced options.
You will see the WG511 system tray icon on the
lower right portion of the Windows task bar.
To use the full Netgear
utility, please see the
Reference Manual on
the NETGEAR 54 Mbps
Wireless PC Card
Windows XP Basic Installation
Windows XP will display a
Wireless Network Connec-
tion message like this one.
1. First, install the WG511 software.
a. Power on your notebook, let the operating system boot up
completely, and log in as needed.
WG511 Resource CD.
3. Now, configure your WG511.
b. Verify that your Connection and Status Monitor information
matches your wireless network.
b. Insert the Resource CD for the WG511 into your CD-ROM
drive. The CD index page shown below will load.
a. Right click on the network icon in the Windows XP system
tray to open the network options menu.
c. Check the two LEDs on the WG511: green indicates a good
connection; blinking green indicates attempting to connect;
off indicates the card is not fully plugged in. Blinking for
the amber LED indicates data transmission.
Note: If this
page does not
automatically
appear, double-
click on
INDEX.HTM on
the CD to load
this page.
d. Verify connectivity to the Internet or network resources.
b. Click on the View Available Wireless Networks menu item.
Note: If you are unable to connect, see troubleshooting tips in
the Basic Installation section of the Reference Manual on the
NETGEAR 54 Mbps Wireless PC Card WG511 Resource CD.
If there is more than
one wireless network
in your vicinity, click
on the one to which
you will connect.
c. Click the INSTALL button. Read the instructions, then click
the Install Software link. When the browser warning
message appears, click Open to start the Install Shield.
d. Follow the InstallShield Wizard steps, and click Finish
when done to restart your computer.
Download from Www.Somanuals.com. All Manuals Search And Download.
|