Introduction
V-LPSII Phono Stage
This Hi-fi product has been tested to ensure
that its operation is not adversely affected by
normal background levels of Radio
Frequency Interference (R.F.I.), and that it
does not itself generate excessive amounts
Thank you for purchasing the V-LPSII. We
sincerely hope that it will bring you many
years of outstanding listening pleasure.
Instructions
Installation Precautions
of interference. However, if
a
problem
Your new V-LPSII is designed and built to
provide trouble-free performance, but as with persists, please contact your Musical Fidelity
agent.
all electronic devices, it is necessary to
observe a few precautions:
Do not use the V-LPSII near water. The unit
Never open the case of the V-LPSII yourself,
as this will invalidate the guarantee.
must not be exposed to dripping or splashing Place all connecting cables where they are
not likely to be walked on or trapped by
items placed on them.
and no objects filled with liquids, such as
vases, must be placed on the unit.
The V-LPSII will operate in accordance with
Keep the V-LPSII away from heat such as
radiators. No naked flame sources, such as its specifications within the following
environmental range:
lighted candles, should be placed on the
unit.
Temperature 5 to 45 degrees Celsius
Humidity 10 to 90% non condensing
Power Supply Note:
Only use approved Musical Fidelity DC
power supply. The use of other adaptors or
There are no user adjustments inside.
supplies could seriously damage the V-LPSII Please refer all service work to an
authorised Musical Fidelity agent.
.
Connections
All connections must be made before the
Outputs
Front and back connections
Connect the V-LPSII left and right
mains adaptor is plugged in, and before any OUTPUTS to the desired LINE LEVEL (e.g
amplifier connected is switched on. Always AUX) inputs of the amplifier system.
switch off the equipment attached to the V- Power
Moving magnet (MM)/moving coil (MC) input select switch
4mm earth terminal
Power input socket
Power LED
before
connecting/disconnecting
Plug the DC connector lead from the power
supply unit into the V-LPSII power inlet
socket, and plug the adaptor itself into a
power, changing leads or inputs.
Inputs
Using good quality RCA leads (not convenient wall mains outlet. The blue LED
supplied), connect the left and right turntable will light to confirm the unit is ready for use.
outputs to the correct V-LPSII INPUT Use
sockets.
Turn the volume on amplifier to normal
Use the phono MM input for moving magnet listening levels, sit back and enjoy the music.
cartridges. Make sure MM/MC switch is These products have been designed so that
OUT.
it may be left on indefinitely, but please note
Use the phono MC input for moving coil that the mains adapter may become warm to
cartridges. Make sure MM/MC switch is IN.
An earthing terminal is provided. Connect
earth wire from turntable to this terminal if
hum is apparent. Other setups may work fine
with this terminal left disconnected and no
harm is done in doing so.
the touch - this is normal.
Left (white) & right (red) RCA moving coil (MC) inputs
Left (white) & right (red) RCA moving magnet (MM) inputs
Left (white) & right (red) RCA line outputs
Download from Www.Somanuals.com. All Manuals Search And Download.
|