| INSTALLATION INSTRUCTIONS FOR PART 99-7009   APPLICATIONS   Mitsubishi Endeavor   2004-2010   99-7009   KIT FEATURES   s DIN Head Unit Provisions   s ISO DIN Head Unit Provisions   KIT COMPONENTS   A) Radio Housing   s B) ISO Brackets   s C) Trim Plate   C A B WIRING AND ANTENNA CONNECTIONS (Sold Separately)   Harness:   s ꢀꢁꢂꢀꢁꢁꢃ ꢂ -ITSUBISHI HARNESS ꢃꢄꢄꢅꢂUP   s -)4/ꢂꢁꢃ ꢂ -ITSUBISHI AMPLIFIED )NTERFACE ꢅꢁꢁꢆꢂUP   Antenna Adapter:   s .OT REQUIRED   OOLS REQUIRED:   T Phillips Screwdriver s Socket Wrench   1-800-221-0932   © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION   Download from Www.Somanuals.com. All Manuals Search And Download.   99-7009   2004-2010 MITSUBISHI ENDEAVOR   A Disconnect the negative battery terminal   to prevent an accidental short circuit.   1 2 Unsnap and remove entire panel sur-   rounding radio and A/C controls.   (Figure A)   3 Remove (1) 10MM nut from the rear support   on the top left of radio on cross bar behind   dash. (FIGURE B)   B 4 5 Remove (3) Phillips screws to remove   factory radio chassis (Figure C)   Remove (4) Phillips screws from the pock-   et at the bottom of the radio and A/C panel   and remove the pocket. (This is where the   C 99-7009 will be mounted.) (Figure D)   D 1 Download from Www.Somanuals.com. All Manuals Search And Download.   ..",%%.   9>Cꢀ=ZVYꢀJc^iꢀEgdk^h^dc   5SING THE FACTORY HARDWAREꢂ MOUNT   THE ꢃꢃꢁꢄꢅꢅꢃ IN THE LOCATION WHERE   THE FACTORY POCKET RESIDEDꢀ   3LIDE THE $). CAGE INTO THE 2ADIO   (OUSING AND SECURE BY BENDING   THE METAL LOCKING TABS DOWNꢀ   ꢀ ꢁ 3LIDE THE AFTERꢁMARKET HEAD UNIT   INTO THE CAGE AND SECUREꢀ 3NAP   TRIM PLATE INTO THE RADIO HOUSINGꢀ   ' Download from Www.Somanuals.com. All Manuals Search And Download.   ..",%%.   >HDꢀ9>Cꢀ=:69ꢀJC>IꢀEGDK>H>DC   -OUNT THE )3/ "RACKETS TO THE HEAD   UNIT WITH THE SCREWS SUPPLIED WITH   THE UNITꢀ   ꢀ 3LIDE THE HEAD UNIT INTO THE RADIO   OPENING UNTIL THE SIDE CLIPS ENGAGEꢀ   ꢁ ꢂ 3NAP THE 4RIM PLATE INTO THE 2ADIO   (OUSINGꢀ   ( Download from Www.Somanuals.com. All Manuals Search And Download.   ..",%%.   ! " ! " # $ 3TRIP WIRE ENDS BACK ꢄꢇꢀꢈ   4WIST ENDS TOGETHER   3OLDER   # $ 4APE   ,OCATE THE FACTORY WIRING HARNESS IN THE DASHꢀ   -ETRA RECOMMENDS USING THE PROPER MATING   ADAPTER AND MAKING THE CONNECTIONS AS   SHOWNꢀ ꢆ)SOLATE AND INDIVIDUALLY TAPE OFF THE   ENDS OF ANY UNUSED WIRES TO PREVENT ELECTRICAL   SHORT CIRCUIT 3EE FIGURE !ꢀ   ꢀ ꢁ ꢂ 2EꢁCONNECT THE NEGATIVE BATTERY TERMINAL AND TEST   THE UNIT FOR PROPER OPERATIONꢀ   2EASSEMBLE RADIO AND DASH ASSEMBLIES IN   REVERSE ORDER OF DISASSEMBLYꢀ   ) Download from Www.Somanuals.com. All Manuals Search And Download.   ..",%%.   * Download from Www.Somanuals.com. All Manuals Search And Download.   INST997009   1-800-221-0932   Rev. 04-26-10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-7009   Download from Www.Somanuals.com. All Manuals Search And Download.   |