KIT FEATURES
ALL VEHICLES
Shaft and
DIN unit
4
3
provisions
Fig. A
Fig. A
99-3410
AW -341GO
DW -3410
INSTALLATION
Equalizer
provisions
KIT COMPONENTS
Fig. B
g. B
Radio Housing
INSTRUCTIONS
APPLICATIONS
2-SHAFT HEAD UNITS:
Slide the
IF AN EQUALIZER WILL BE INCLUDED :
aftermarket head unit into the kit and
secure with shaft nuts. (seeFig.A)
Slide the aftermarket equalizer into the back of
the Radio Housing.
Using the hardware
CAR
PAGE
included with the equalizer, mount the unit to
DIN HEAD UNITS:
shaft supports. Slide the DIN cage into the
Cut and remove the
the kit. (seeFig.A)
CHEVROLET
Tracker 1998-04..........................................................1
GEO
Metro 1992-94............................................................1
Tracker 1992-97..........................................................1
SUZUKI
Aerio 2003.................................................................. 2
Esteem 1995-03..........................................................2
Sidekick 1992-98........................................................1
Swift 1992-94............................................................. 1
Vitara series 1999-04.................................................1
RadioHousing and secure by bending the
IF AN EQUALIZER WILL NOT BE
metal locking tabs down.
Slide the
INCLUDED:
Snap the Equalizer Dummy
Equalizer
Dummy Plate
aftermarket head unit into the cage until
secure. (seeFig.B)
Plate into theRadioHousing. (seeFig.B)
(4) #8 x 1" Phillips
Pan-Head Screws
5
6
A
B
C
(4) Speed Clips
D
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
applications
Antenna Adapter:
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
TOOLS REQUIRED
• 40-GM10 - GM antenna adapter 88-up
D) Tape
P
KNOWLEDGE IS OWER
Phillips screwdriver
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
Enhance your installation and fabrication skills
by enrolling in the most recognized and respected
mobile electronics school in our industry.
Re-connect the battery terminal and test the unit
for proper operation. Slide (4) Speed Clips over
the holes in the sub-dash mounting brackets and
mount the head unit/kit assembly with (4)Phillips
Pan-HeadScrews supplied.
or call 800-354-6782 for more information
and take steps toward a better tomorrow.
Cutting tool
Wrench
1-800-221-0932
© COPYRIGHT 2001-2009 METRA ELECTRONICS CORP.
REV. 07-29-09
3
Download from Www.Somanuals.com. All Manuals Search And Download.
|