ATLANTIC
hot & cold
water dispenser
Hot water capacity:
5L/h at 85-95°C
Cold water capacity:
0.75L/h at 13-15°C
y
Removable
drip tray
Model:
30100
75 - 550
W
Download from Www.Somanuals.com. All Manuals Search And Download.
_IM.indd
1
1/28/2014 1:45:12 PM
tal surface away from direct sunlight and
sources of heat (stove, heater, radiator etc).
3.This table top water dispenser is not recom-
mended for outdoor use.
(at the rear).
• Now you are ready to use your Table Top Hot
and Cold Water dispenser.
4.NB: The water dispenser is pre-cleaned at
the factory but the reservoir and water lines
must be flushed with fresh water before us
as follows:
Instructions for cleaning:
• Unplug the dispenser from the power outlet.
• The dispenser was disinfected before leav-
ing the factory. You can use a fit for human
consumption disinfector to clean
• Keep the dispenser unplugged
• Fill the water tank with tap water full to ca-
pacity. Wait for 5 minutes until water settles.
• Proceed to drain the water from both faucets
until no more water is remaining.
• Proceed to make sure both drain caps and
faucets are closed.
• Place the water bottle on the water intake;
allow water to stand approximately
one minute.
• Open water faucets to ensure water flows
from both faucets.
it after six months.
• It is advisable to take it in for service after 1
year in order to clean the heating pot. This
must be done by a qualified technician.
• Care is needed when cleaning the appli-
ance to ensure that water do not go into the
electric power parts.
• Wash the inside of the reservoir with warm
water and baking soda solution. The solution
should be about 2 tablespoons of baking
soda to a quarter of water.
• Plug the dispenser into the electrical outlet.
• Turn the cold and hot water switches ON
• The drip tray and water faucets should be
cleaned with mild detergent and warm water.
Trouble shooting guide:
PROBLEM
SOLUTION
Dispenser does not work properly or water
does not flow out.
• Check if the appliance is plugged in
and switched on.
• Check if there’s water in the bottle
• Clear away any blockages in the reservoir.
• Check if the circuit break and see if not
tripped or a blow fuse.
Water is not hot enough
Water is not cold enough
• Check to see if hot water switch
is turned on.
• Too much hot water has been used in a
short period of time. Allow it a few minutes it
will heat up again.
• Check to see if cold water switch
is turned on.
• Too much cold water has been used in a
short period of time. Allow it a few minutes it
will heat up again.
Vibrations
Leakage
• Check to see that the water
dispenser is level.
• Check to see that the bottle is properly fitted
or change bottle if damaged.
Download from Www.Somanuals.com. All Manuals Search And Download.
_IM.indd
3
1/28/2014 1:45:12 PM
Download from Www.Somanuals.com. All Manuals Search And Download.
_IM.indd
4
1/28/2014 1:45:12 PM
|