Wine Cooler
Model No. MCWC16M MCWC30M
Wine Cooler
. Before Putting Into Use . . . . . . . . . . . . . . . . .
. Important . . . . . . . . . . . . . . . . . . . . . . . .
. Placing and Installation . . . . . . . . . . . . . . . . .
. Description of the Appliance . . . . . . . . . . . . . . .
. Operation Control . . . . . . . . . . . . . . . . . . . .
2
3
4
5
5
6
7
8
9
10
. Maintenance and Cleaning . . . . . . . . . . . . . . . .
. Trouble Shooting Guide . . . . . . . . . . . . . . . . .
. Limited Warranty . . . . . . . . . . . . . . . . .
CAUTION:
Read and follow all safety rules and operating
instructions before first use of this product.
Download from Www.Somanuals.com. All Manuals Search And Download.
Before Putting Into Use
Before connecting the appliance to electrical
power supply, leave it to stand for about 2 hours,
which will reduce the possibility of malfunctions
in the cooling system due to transport handling.
Clean the appliance thoroughly, especially in the
interior (See Cleaning and Maintenance).
In case the interior accessories are not correctly
placed, rearrange them as described in chapter
"Description of the Appliance"
If the gasket is damaged or the door seal is
poor, energy consumption is substantially
higher. To restore efficiency, replace
the gasket.
Always consider instructions stated in
sections Positioning and Energy Saving
Tips, otherwise the energy consumption is
substantially higher.
·
·
·
·
·
·
Remove shipping bracket at base of
door opening and replace the foot
before operating this appliance.
Instructions for Use
These instructions for use are intended for the user.
They describe the appliance and correct operating
procedures for safe use .
SAVE THESE INSTRUCTIONS:
Tips for Energy Saving
Try not to open the door too often, especially when
the weather is hot and humid. Once you open the
door , close it as soon as possible. This is
especially important if you have an upright model .
Every now and then check if the appliance is
sufficiently ventilated ( adequate air circulation
behind the appliance ).
Set the thermostat from higher to lower settings as
soon as possible (depends on how loaded the
appliance is, ambient temperatures etc.).
Ice and frost layers increase energy consumption,
so clean the appliance as soon as the frost layer
is 3-5mm thick.
·
·
·
·
2
Download from Www.Somanuals.com. All Manuals Search And Download.
Important
If you have bought this appliance to replace
an old one equipped with a door lock that
cannot be opened from the inside (lock, bolt),
make sure that the lock is removed, disabled
or destroyed before discarding. This will make
it impossible for children to accidentally lock
themselves inside the appliance and suffocate.
The appliance must be properly connected to
an electrical power supply. (See: Connection
to Power Supply) .
· Disposing of Worn Out
Appliances
· DANGER OR WARNING: Risk of child entrapment.
Before you throw away your old refrigerator or
freezer:
-Take off the doors
- Leave the shelves in place so children may not
easily climb inside.
Do not use an extension cord.
Always disconnect the appliance from the
power supply before cleaning the appliance,
or attempting repairs.
WARNING:
repairs should be performed by qualified
service personnel only.
Do not defrost the appliance with other electric
appliances (for example a hair dryer) and
never attempt to scrape/remove ice/frost with
sharp objects.
· The cooling system of the appliance is filled with
refrigerant and insulating substances which should
be separately treated and processed. Call your
nearest authorised service agent. If you are unable
to locate one, contact your local authorities or your
distributor. Be careful not to damage the tubes on
the rear wall of the appliance (danger of pollution).
The cooling system of the appliance is filled
with refrigerant and oil ,so when the appliance
is damaged, handle it with care and dispose
of it in compliance with environmental protection
safeguards.
The rating plate containing Model No/Serial No
and other technical data specific to this unit, is
located either inside the appliance or outside
on the rear wall.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Placing and Installation
CHOOSING THE RIGHT PLACE
WARNING
Place the appliance in a dry and regularly
ventilated room. Never place the appliance near
heat emitting devices (e.g. cooking appliances,
radiators, water heaters or similar devices) and
do not expose to direct sunlight.
Instructions to avoid to the risk of fire ,
electric shock , or injury to persons.
WIRING INSTRUCTIONS
The appliance should be positioned at least 2in.
away from electric or gas cooking appliances
and at least 12in. away from oil or coal fired
stoves. If this is not possible, use an appropriate
insulation barrier.
For your personal safety, this appliance must
be earthed. In the event of a malfunction or
breakdown, earthing will reduce the risk of
electric shock by providing a path of least
resistance for electric current. This appliance
is equipped with a power cord having an
equipment earthing conductor and fused plug.
The plug must be plugged into an appropriate
wall outlet that is installed and wired in
accordance with all existing local codes and
ordinances. Consult a qualified electrician or
serviceman if the wiring instruction are not
clearly understood, or if doubt exists as to
whether the appliance is properly earthed.
Behind the appliance there should be a free space
of at least 3in. . Kitchen units (cupboards) should
be at least 2in. away from the appliance in order
to assure adequate ventilation. There should be
4in. between both size of the chiller and other
article.
INSTALLATION
Place the appliance firmly on a solid base. Some
CONNECTION TO POWER
SUPPLY
appliances have adjustable feet on the front side;
use them to level the appliance.
Connect the appliance power cord and plug
to a properly earthed wall outlet. The required
nominal voltage and frequency are indicated
on the rating plate (inside the unit or on the
exterior rear wall of the unit).
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Description of the appliance
(A) Adjustable Wire Shelves
(The number of shelves depends on the model)
Shelves can be optionally placed on the guides
inside the appliance. Perishable items should
be stored towards the back/rear of the shelves.
i.e. the coldest part of the shelf.
(B) Defrost Water Outlet
The interior of the appliance is cooled with a
cooling plate mounted in the rear wall. Under the
plate there is a channel and an outlet for defrost
water. Regularly check the defrost water outlet
and the drain channel for blockage. They should
always be kept free and clean of particles.
WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO EFFECT
ON THE OPERATION OF THE APPLIANCE.
Temperature Control
The temperature of the appliance is controlled by setting the thermostat knob to a
desired setting.
Temperature Selection
To turn the control to the "OFF" position, rotate the
To start the appliance turn the temperature control
knob to the position corresponding to the desired
cooling.
Fig A (MCWC16M) see page 6
Fig B (MCWC30M) see page 6
The temperature will vary depending on the
quantity of the item stored and on the frequency
with which the door is opened.
control knob to the "0" position. If the appliance
has been left out of use for some time, set the
control to maximum or the "7" position for 2-3
hours before turning to the desired position. If the
appliance is not being used for long time periods,
disconnect the plug and leave the door partially
open. This will help to reduce mold/mildew from
accumulating inside the appliance cabinet.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
CONTROL KNOB
Fig A (MCWC16M)
Fig B (MCWC30M)
Changes in ambient room temperature will affect the internal temperatures (choose correct
setting of the thermostat knob).
.
. In STOP (0) position the appliance does not operate (cooling system is switched off ),
yet power supply is not interrupted.
. Temperature in the appliance also depends on how often the door is opened.
ILLUSTRATION OF THE APPLIANCE
THERMOSTAT DIAL:
1.
For controlling the temperature inside the
wine cooler. Turns the motor on as soon as
the temperature rises above the desired
level.
PLASTIC COATED SHELVES:
Odor resistant, rustproof, and removable
for easy cleaning.
2.
3.
4.
MAGNETIC GASKET: Tight fitting door
seal keeps all the cooling power locked
inside. No hooks or latches.
TEMPERED GLASS DOOR & INTERIOR LIGHT:
Allows easy interior visibility.
(Interior light for MCWC30M only)
TEMPERATURE RANGE GUIDE:
Upper-Section
Mid-Section
Lower-Section
0
0
0
MIN.
MED.
MAX.
19.0 /66.2 F
17.0 /62.6 F
14.0 /57.2 F
0
0
0
17.0 /62.6 F
14.0 /57.2 F
10.0 /50.0 F
0
0
0
13.6 /56.4 F
9.8 /49.6
F
5.5 /41.9
F
The above temperatures may fluctuate between +/- 5
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Maintenance and Cleaning
Switch Off the Appliance
When Not In Use
Automatic Defrosting of the
Appliance
There is no need to defrost the chiller , because
ice depositing on the inner back wall is defrosted
automatically.
Ice build-up on the inner back wall during the
compressor operation will defrost automatically
(when the compressor has cycled off) . Defrost
water will drain out passing through the drain
outlet in the inner back wall into a drain pan
situated above the compressor, from where it
evaporates.
If you do not intend to use the appliance for long
periods of time. Set the thermostat knob to the
STOP (0) position, disconnect the power supply,
take out the contents and defrost and clean the
appliance. Leave the door slightly open.
Cleaning the Appliance
Disconnect the power supply before cleaning
the appliance.
Do not use coarse or aggressive cleaning
agents as you may damage the surface.
Clean the exterior with water and detergent.
Remove the detachable accessories in the
interior of the appliance and clean with water and
liquid detergent. Plastic parts cannot be washed
in dishwashers.
Wash the interior of the appliance with lukewarm
water , adding one or two spoonfuls of vinegar.
After cleaning, connect the appliance to power
supply and reload it.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Trouble-Shooting Guide
.
Sometimes you may come across minor problems
that in most cases do not require a service call
and can be easily eliminated. The problem may
have resulted from improper handing and / or
installation of the appliance. Please refer to the
below trouble-shooting guide to assist you in
identifying the possible cause and solution to your
problem. Should the problem still persist after
completing these checkpoints. Contact the closest
authorized service agent in your area for assistance.
Ice Formation on the Inner
Rear Wall
As long as the defrost water runs to the
channel and through the outlet to the drain
pan on the compressor, automatic defrosting
of the appliance is assured.
In case the ice formation on the inner back
wall is increased (1/8-1/5in.), ice should be
manually defrosted.
Set the thermostat knob to STOP ( 0 )
position and leave the door open. Never
use electric devices for defrosting and do
not scrape the ice or frost layer with sharp
objects.
The Appliance Fails to
Operate After Connecting to
Electrical Power Supply
After defrosting is complete, turn the knob to
desired position and close the door. The
cause of increased ice formation may be
one of the following:
.
.
Check the power cord is properly connected.
Check the power supply in the electrical outlet.
(blown fuse / circuit breaker) .
Make sure the appliance is switched on.
(thermostat knob in operating position)
_
.
the door does not seal well (clean the
gasket if it is contaminated, or replace it if
it is damaged);
the door is frequently opened or left too
_
Continuous Operation of the
Cooling System
The door is frequently opened or left open for
too long.
The door is not properly closed (the door may
sag, the gasket may be polluted or damaged).
Perhaps you may have overloaded the appliance.
The reason may be inadequate ventilation of the
compressor (assure adequate air circulation).
long;
_
the food stored in the appliance was warm;
the food or dish is touching the inner back
_
.
.
wall.
.
.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
Check the accessories on the interior of the
appliance, they should be placed correctly in
their positions; also check, bottles, tins, and
other vessels are not touching each other
causing rattling and/or vibrations.
Water is Leaking From the
Appliance
If the discharge water outlet is clogged, or the
defrost water drips over the channel, water will
leak from the appliance.
Clean the clogged outlet.
.
.
Manually defrost the increased ice layer ( see
ice Formation on the Inner rear Wall ).
Noise
Cooling in this appliance is made possible by
cooling the system using a compressor, which
will produce certain noise levels. How noise
noisy the appliance is depends on where it is
placed, how it is used and how old the
appliance is.
During the operation of the compressor
the noise of the liquid is heard and when the
compressor is not operating, the refrigerant flow
is heard, This is a normal condition and it has
no influence whatsoever on the lifetime of the
appliance.
.
.
.
After starting the appliance, the
operation of the compressor and the refrigerant
flow may be louder, which does not mean that
something is wrong with the appliance and it has
no influence on the lifetime of the appliance.
Gradually the noise will reduce.
Sometimes unusual and louder noise
may be heard. This noise is often a
consequence of inadequate installation.
The appliance must be level and installed on
a firm solid base/floor.
The appliance should not touch the wall or
kitchen units standing next to it.
_
_
9
Download from Www.Somanuals.com. All Manuals Search And Download.
|