H S x a 1 2
Lennox’ Elite® SERIES
Home Comfort Systems
homeowner’s manual
Download from Www.Somanuals.com. All Manuals Search And Download.
HSXA12
W I T H R 4 1 0 A
R E F R I G E R A N T
Many indoor units are equipped with re-usable
foam filters. These filters can be cleaned with a
mild soap and water solution. Rinse the filter thor-
oughly and let it dry completely, before it is
returned to the unit or grille.
Lennox Dealers
Nobody knows more about the care and operation
of your new Lennox equipment than your Lennox
dealer. Your Lennox dealer is your best choice for
routine maintenance or service. Lennox’ Quality
Dealer Standards program ensures that when you
call your Lennox dealer, you can count on prompt,
courteous and professional service.
The filter and all access panels must be in place
any time the unit is in operation.
Your system may be equipped with an electronic air
cleaner which will provide respiratory relief by re-
moving up to 90 percent of all airborne particles
which pass through it. If it is, ask your dealer to
instruct you on its maintenance.
Before the start of each heating and cooling sea-
son, the following service checks should be
performed by a qualified service technician.
As always, electrical power to the unit must be
turned off prior to any unit maintenance.
Your indoor evaporator coil is equipped with a
drain pan to collect condensate formed as your sys-
tem removes humidity from the inside air. Have
your dealer show you where the main condensate
drain (and auxiliary drain, if applicable) runs and
how to check the drain for any obstruction.
D The outdoor and indoor coils should be inspected
and cleaned. The outdoor coil may be flushed
with a water hose.
NOTE – It may be necessary to flush the outdoor
coil more frequently if it is exposed to substances
which are corrosive or which block airflow
across the coil (e.g., pet urine, cottonwood seeds,
etc.)
It is also very
important to
provide
D The refrigerant lines should be visually inspected
unrestricted
airflow to the
and the coils should be checked for leaks.
outdoor unit.
Leaves, trash
or shrubs
crowding the
unit cause the
outdoor unit
to work harder and use more energy. Keep
shrubbery trimmed away from the unit and
periodically check for debris which may have
collected around the unit.
D Wiring should be checked for loose connections.
D Voltage must be checked at the indoor and
outdoor units (units operating).
D The amp-draw at the outdoor fan motor and
indoor blower motor should be checked. Values
should be compared with those given on unit
nameplate.
D Indoor unit filters should be cleaned or
replaced.
D The refrigerant charge should be checked and
system pressures should be gauged.
D The condensate drain line should be checked for
free and unobstructed flow and it should be
cleaned, if necessary.
Download from Www.Somanuals.com. All Manuals Search And Download.
THERMOSTAT OPERATION -- COMFORT IS AT YOUR FINGERTIPS
Though your thermostat may vary somewhat from the
description below, its operation will be similar.
System Switch
Set the system switch for heating, cooling or auto op-
eration. The auto mode allows the system to automati-
cally switch from heating mode to cooling mode to
maintain predetermined comfort settings.
Temperature Setting Levers
Set the lever or dial to the desired temperature setpoints
for both heating and cooling. Avoid frequent tempera-
ture adjustment; turning the unit off and back on before
pressures equalize puts stress on the unit compressor.
Temperature Indicator
The temperature indicator displays the actual room
temperature.
Fan Switch
In AUTO or INT (intermittent) mode, the blower oper-
ates only when the thermostat calls for heating or cool-
ing. This mode is generally preferred when humidity
control is a priority. The ON or CONT mode provides
continuous indoor blower operation, regardless of
whether the compressor or furnace is operating. This
mode is required when constant air circulation or filter-
ing is desired.
Programmable Thermostats
Your Lennox system may be controlled by a
programmable thermostat. These thermostats provide
the added feature of programmable time-of-day
setpoints for both heating and cooling. Refer to the
user’s information manual provided with your
particular thermostat for operation details.
Please record the following information for your
convenience.
Before you call
If your system fails to operate, check the following
before calling for service:
Dealer Name:
Address:
D Check to see that all electrical disconnect
switches are ON.
D Make sure the room thermostat temperature
Phone Number:
selector is properly set.
D Make sure the room thermostat system switch is
Unit Model Number: HSXA12 –
Installation Date:
properly set.
D Replace any blown fuses, or reset circuit
breakers.
D Make sure unit access panels are in place.
D Make sure air filter is clean.
D Locate unit model number and have it handy
before calling.
*P504541M*
504,541M
2002 Lennox Industries Inc., Dallas, TX
Litho U.S.A.
Download from Www.Somanuals.com. All Manuals Search And Download.
02/2002
|