Lennox Hearth Indoor Fireplace EDV3530 User Manual

LOG PLACEMENT GUIDE  
EDV3530, EDV4035 AND  
EDV4540 SERIES  
750,158M  
REV. N/C 05/2003  
LOG PLACEMENT GUIDE FOR LENNOX DIRECT VENT EDV3530, EDV4035  
AND EDV4540 SERIES VENTED GAS FIREPLACE HEATERS  
GENERAL INFORMATION  
This log placement guide has been prepared to present detailed log  
placement illustrations and provide instruction to assist in the place-  
ment of logs at the initial (new appliance) setup and after the annual  
cleaning and inspection cycles. The information provided here is to  
be used in conjunction with the Homeowner's Care and Operation In-  
structions provided together with this document in the appliance lit-  
erature packet. Please read the Homeowner's Care and Operation In-  
structions completely before completing the procedures detailed in  
this placement guide.  
Figure 1  
INITIAL INSTALLATION CONSIDERATIONS  
Glowing Embers  
If the logs are being installed for the first time, the following para-  
graphs apply:  
DO NOT attempt to install the logs until the appliance installation has  
been completed, the gas line connected and tested for leaks and the  
initial burner operation has been checked out.  
Step 1. Remove the appliance front door.  
Step 2. Remove the boxed log set from the interior of the firebox.  
Remove the logs from their packaging. Handle logs carefully to pre-  
vent breakage.  
CERAMIC EMBER PANELS, LOGS AND GLOWING EMBER  
PLACEMENT  
Figure 2  
Step 1. Install the Ceramic Ember Panels as shown in Figure 3. Panels  
should be placed in the order shown.  
A. Place the left and right panel against the corners as shown.  
B. Align the two front legs of the grate assembly on the dimples and  
align the two rear legs between the cut out as shown.  
C. Place the front panel into its proper position as shown. Adjust the  
panels to minimize the gaps.  
Proper log placement is critical to encourage outstanding flame  
appearance and prevent sooting. When positioned properly as  
shown, logs will be positioned between flame peaks and will not  
impinge any flames.  
Step 3. Separate the Glowing Ember (Rockwool) into pieces about  
the size of a quarter Figure 1. Keep the pieces fluffed up, not matted.  
Distribute these pieces over the front surface of the burner, as shown  
in Figure 2. Do not use more than is necessary. When properly posi-  
tioned, the Glowing Embers will cover approximately 65% of the front  
burner and with no appreciable gaps or openings. Ensure that the  
main burner ports remain uncovered by the ember material.  
Note: This appliance is provided with enough Glowing Embers for sev-  
eral applications, do not feel compelled to use all that is in a new bag.  
For best glowing effect, replace the ember material annually. Replace-  
ment Glowing Embers are available (Catalog Number 88L53).  
Step 2. Position the individual logs as shown in Figures 4 and 5. Logs  
should be placed in the order shown. All logs that have notches to fit  
over the grate tines should be positioned with these notches directly  
against the grate.  
Refer to page 3 for EDV3530 Series appliances and to page 4 for  
EDV4035 & EDV4540 Series appliances.  
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
EDV3530 LOG PLACEMENT  
Log  
Part  
Number  
Number Description  
1
2
1
2
3
4
5
6
Log, Rear  
55M0601  
55M0701  
55M0801  
55M0901  
55M1001  
55M1101  
Log, Diagonal/Left  
Log, Diagonal/Right  
Log, Front/Left  
Log, Top/Right  
Log, Front/Center  
Catalog Number for the entire log set: 55M0201  
3
5
4
6
Align The Hole On The Log (5) Over The Locating Pin  
And Postition The Notch Over The Grate As Shown  
1
4
5
Align Groove At The Bottom  
Of Log (1) Over The Grate And  
Push It Towards The Rear.  
Locating Pins  
Align The Groove In The Bottom Of Log (4)  
Over The Grate And Slide It Toward The Front.  
Locating Pin  
2
3
6
Align The Holes In One End Of Logs 2 & 3 Over The  
Locating Pins And Align The Grooves On The Other  
End Over The Grate And Push It Toward The Rear  
Position The Grooves On Log (6)  
Against The Grate As Shown  
Figure 4  
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
EDV4035 & EDV4540 LOG PLACEMENT  
Log  
Part  
Number  
1
2
Number Description  
1
2
3
4
5
6
Log, Rear  
55M1201  
55M1301  
55M1401  
55M1501  
55M1601  
55M1701  
Log, Diagonal/Left  
Log, Diagonal/Right  
Log, Front/Left  
Log, Top/Right  
Log, Front/Center  
Catalog Number for the entire log set: 55M0301  
1
3
5
4
6
Align The Hole On The Log (5) Over The Locating Pin  
And Postition The Notch Over The Grate As Shown  
4
5
Align Groove At The Bottom  
Of Log (1) Over The Grate And  
Push It Towards The Rear.  
Locating Pins  
Align The Groove In The Bottom Of Log (4)  
Over The Grate And Slide It Toward The Front.  
Locating Pin  
2
3
6
Align The Holes In One End Of Logs 2 & 3 Over The  
Locating Pins And Align The Grooves On The Other  
End Over The Grate And Push It Toward The Rear  
Position The Grooves On Log (6)  
Against The Grate As Shown  
Figure 5  
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.  
Lennox reserves the right to make changes at any time, without notice, in design,  
materials, specifications, prices and also to discontinue colors, styles and products.  
Consult your local distributor for fireplace code information.  
Printed in U.S.A. © 2003 by Lennox  
P/N 750,158M REV. N/C 05/2003  
1110 West Taft Avenue • Orange, CA 92865  
Download from Www.Somanuals.com. All Manuals Search And Download.  

KWC Music Mixer 802259 User Manual
La Crosse Technology Weather Radio WS 1611 User Manual
LG Electronics Blu ray Player BP120 User Manual
Life Fitness Treadmill CLST 0100 01RF User Manual
Makita Trimmer BUR141 User Manual
Manitowoc Ice Ice Maker K00194 User Manual
Masterbuilt Turkey Fryer 20010210 User Manual
Maxtor DVR 777 W V10 User Manual
Maytag Clothes Dryer MED5707TQ0 User Manual
McCulloch Lawn Mower M65H53SD User Manual